AMS393 GENERAL DESCRIPTION The AMS393 consists of two independent, FEATURES voltage comparators .These were designed Wide supply voltage range specifically to operate Low supply current drain independent of From a single power supply over a wide range of voltages. Operation supply. from split power supplies is also Possible and the Voltage. Low input biasing current, low power supply current drain is independent of Low input offset current the magnitude of the power Supply voltage. The Low input offset voltage outputs can be connected to other open-collector Input common-mode voltage range includes outputs to achieve wired-AND relationships. GND. Differential input voltage range equal to the power supply voltage Low output saturation voltage Output voltage compatible with TTL, MOS and CMOS logic Block Ver1.0 Diagram 1 AMS393 Pin Description Absolute Maximum Ratings Symbol Parameter Value Unit 30 or±15 V ±30 V Vcc Power supply Voltage VIDR lnput Differential Voltage Range(a) VICR lnput Common Mode Voltage Range -0.3 to 30 V TOPR Operating -40 to 80 ℃ Tstg storage Temperature (TA=+25℃) -55 to +125 ℃ 280 ℃ TL Temperature Range Lead Temperatur,1mm from Case for 10 Seconds Maximum Ratings are those Values beyond which damage to the device may occur. Functional operation should be restricted to the Recommended Operating Conditions. Notes: a. Split Power Supplies. Ver1.0 2 AMS393 Electrical Characteristics at specified free-air temperature, Vcc= 5V ( unless otherwise noted) AMS393 Symbol Parameter Test conditions* Vio Input Offset voltage Vcc=5V to MAX, VlC=VICR Min, Vo=1.4V Iio Input offset current Vo=1.4V llB Input bias Current Vo=1.4V VICR AVD Common-mode input voltage range Large-signal differential voltage amplification Min 25℃ Typ Max 2 5 Full range 9 Unit mV 25℃ Full range 25℃ Full range 25℃ Full range 0 to Vcc-1.5 0 to Vcc-2 Vcc=15V, Vo=1.4V to 11.4V, RL≥15KΩ to Vcc 25℃ 50 200 V/mV VOH=5V VID=1V, 25℃ 50 80 dB VOH=30V VID=1V, Full range 0.1 50 25℃ 150 400 lOH High-level output current VOL Low-level output voltage lOL=4mA,VID=-1V lOL Low-level output current VOL=1.5V,VID=-1V lcc supply current RL=00 5 -25 Vcc=5V 25℃ Vcc=30V Full range nA nA V Full range 25℃ 50 150 -250 -400 700 6 nA mV mA 0.8 1 2.5 mA *Full range(MIN to MAX),for the AMS393 is 0℃ to 70 ℃.All characteristics are measured with zero common-mode input voltage unless otherwise specified. ** The voltage at either input or common-mode should not be allowed to go negative by more than 0.3V.The upper end of the common-mode voltage range is Vcc-1.5V,but either or both inputs can go to 30V without damage. Absolute Maximum Ratings Vcc=5V, TA=25℃ Parameter Response time Test conditions RL connected to 5V through 5.1 KΩ, CL=15pF*(See Note 1) 100-mV input step with 5-mV overdrive Min Typ Max Units 1.3 μs TTL-level input step 0.3 * CL includes probe and jig capacitance. Note 1:The response time specified is the interval between the input step function and the instant when the output crosses 1.4V Ver1.0 3 Typical Applications Circuit Ver1.0 AMS393 4 Package Description AMS393 SOP8 PACKAGE OUTLINE DIMENSIONS Ver1.0 5 AMS393 DIP8 PACKAGE OUTLINE DIMENSIONS Ver1.0 6