DC-6.0 GHz 1.0W Packaged HFET F1001-SC April 2010 - Rev 05-Apr-10 Features Functional Block Diagram 46.5 dBm OIP3 @ 5.8 GHz 15.5 dB Gain @ 2 GHz 10.0 dB Gain @ 6 GHz 30.0 dBm P1dB SOT-89 Package General Description The XF1001-SC is a high linearity Hetrojunction Field Effect Transistor (HFET) housed in an industry standard SOT-89 package. Optimum performance is achieved when the device is biased at a drain voltage of 8V and drain current of 300m. At this bias point, the device is capable of more than 30 dBm of P1dB and OIP3 of more than 46 dBm. The XF1001-SC is suitable for applications up to 6 GHz where it has 10 dB of gain. Absolute Maximum Ratings Device Voltage (Vcc) Current (Icc) Power Dissipation (PDC) RF Input Power (RFin) Junction Temperature Thermal Resistance Storage Temperature (Tstg) Operating Temperature ESD (HBM) Moisture Sensitivity Level (MSL) Typical Performance: 8V, 25 ºC Parameter Typical Frequency (F) 1900 Gain (S21) 15.5 Ourput IP3 (OIP3) 46.5 Output P1dB 30.0 Quiescent Current (Idq) 300 Input Return Loss (S11) -12.5 Output Return Loss (S22) -7.5 Noise Figure (NF) 4.5 5800 10.1 46.5 30.0 300 -22.5 -7.5 5.0 Units MHz dB dBm dBm mA dB dB dB +9.0 V 450 mA 4.5W +24 dBm 175 ºC 30 ºC/W -55 ºC to +150 ºC -40 ºC to +85 ºC Class 1A MSL 1 Operation of this device beyond any of these parameters may cause permanent damage. P1dB at 5900 MHz can be improved to over 30 dBm at the expense of gain. Electrical Characteristics (T=25ºC,Vd=8V) Unless otherwise specified, the following specifications are guaranteed at room temperature in a Mimix test fixture. Parameter Condition Frequency Range (F) Test Frequency Small Signal Gain (S21) Externally matched Output Intercept Point (OIP3) Pout/Tone=13 dBm, Spacing=5 MHz Output P1dB Quiescent Current (Icq) Gate Voltage Noise Figure (NF) Units Min Typ Max MHz DC 6000 MHz 1900 13.5 15.5 dB dBm +44.0 +46.5 dBm +29.0 +30.0 mA 300.0 330.0 V -1.2 -0.85 -0.5 dB 4.5 Mimix Broadband, Inc., 10795 Rockley Rd., Houston, Texas 77099 Tel: 281.988.4600 Fax: 281.988.4615 mimixbroadband.com Page 1 of 7 Characteristic Data and Specifications are subject to change without notice. ©2010 Mimix Broadband, Inc. Export of this item may require appropriate export licensing from the U.S. Government. In purchasing these parts, U.S. Domestic customers accept their obligation to be compliant with U.S. Export Laws. DC-6.0 GHz 1.0W Packaged HFET F1001-SC April 2010 - Rev 05-Apr-10 Evaluation Board: EV1, 5.8 GHz Vg = -0.85V Vd = 8V RFIN RFOUT Dielectric: Rogers 4003 Thickness: 12mil Schematic: EV1, 5.8 GHz Mimix Broadband, Inc., 10795 Rockley Rd., Houston, Texas 77099 Tel: 281.988.4600 Fax: 281.988.4615 mimixbroadband.com Page 2 of 7 Characteristic Data and Specifications are subject to change without notice. ©2010 Mimix Broadband, Inc. Export of this item may require appropriate export licensing from the U.S. Government. In purchasing these parts, U.S. Domestic customers accept their obligation to be compliant with U.S. Export Laws. DC-6.0 GHz 1.0W Packaged HFET F1001-SC April 2010 - Rev 05-Apr-10 Typical Performance: 5.8 GHz XF1001-SC, 8V 300mA 11 20 10 15 9 10 S21 S (dB) 8 5 S11 7 0 S22 6 -5 5 -10 4 15 -15 3 -20 2 -25 5.5 5.55 5.6 5.65 5.7 5.75 5.8 5.85 5.9 5.95 6 Freq (GHz) 48 XF1001-SC, 8V 300mA 46 44 42 (dBm) 40 P1dB 38 OIP3 36 Psat 34 32 30 28 26 5.45 5.5 5.55 5.6 5.65 5.7 5.75 5.8 5.85 5.9 5.95 6 6.05 Freq (GHz) Mimix Broadband, Inc., 10795 Rockley Rd., Houston, Texas 77099 Tel: 281.988.4600 Fax: 281.988.4615 mimixbroadband.com Page 3 of 7 Characteristic Data and Specifications are subject to change without notice. ©2010 Mimix Broadband, Inc. Export of this item may require appropriate export licensing from the U.S. Government. In purchasing these parts, U.S. Domestic customers accept their obligation to be compliant with U.S. Export Laws. DC-6.0 GHz 1.0W Packaged HFET F1001-SC April 2010 - Rev 05-Apr-10 Typical Performance: 5.8 GHz (over temperature) XF1001-SC, 8V, 300mA: Gain Vs Temperature 13 12 Gain (dB) 11 10 9 +25ºC 8 +85ºC 7 -40ºC 6 5 54 5.4 55 5.5 56 5.6 57 5.7 58 5.8 59 5.9 6 61 6.1 Frequency (GHz) XF1001-SC, 8V, 300mA: P1dB Vs Temperature 32 31 P1dB (dBm) 30 29 28 +25ºC 27 +85ºC -40ºC 26 25 5.4 5.5 5.6 5.7 5.8 5.9 6 6.1 Frequency (GHz) XF1001-SC, 8V, 300mA: OIP3 Vs Temperature 48 47 46 45 P1dB (dBm) 44 43 42 41 +25ºC 40 +85ºC 39 -40ºC 38 37 36 5.4 5.5 5.6 5.7 5.8 5.9 6 6.1 Frequency (GHz) Mimix Broadband, Inc., 10795 Rockley Rd., Houston, Texas 77099 Tel: 281.988.4600 Fax: 281.988.4615 mimixbroadband.com Page 4 of 7 Characteristic Data and Specifications are subject to change without notice. ©2010 Mimix Broadband, Inc. Export of this item may require appropriate export licensing from the U.S. Government. In purchasing these parts, U.S. Domestic customers accept their obligation to be compliant with U.S. Export Laws. DC-6.0 GHz 1.0W Packaged HFET F1001-SC April 2010 - Rev 05-Apr-10 Typical Performance: 1.9 GHz XF1001-SC, 8V 300mA 17 20 S21 16 15 S11 S (dB) 15 10 S22 14 5 13 0 12 -5 11 -10 10 -15 9 -20 1.6 1.65 1.7 1.75 1.8 1.85 1.9 1.95 2 2.05 2.1 2.15 2.2 Freq (GHz) XF1001-SC, 8V 300mA 48 46 44 (dBm) 42 40 P1dB 38 OIP3 36 34 32 30 28 26 1.7 1.75 1.8 1.85 1.9 1.95 2 2.05 2.1 Freq (GHz) Mimix Broadband, Inc., 10795 Rockley Rd., Houston, Texas 77099 Tel: 281.988.4600 Fax: 281.988.4615 mimixbroadband.com Page 5 of 7 Characteristic Data and Specifications are subject to change without notice. ©2010 Mimix Broadband, Inc. Export of this item may require appropriate export licensing from the U.S. Government. In purchasing these parts, U.S. Domestic customers accept their obligation to be compliant with U.S. Export Laws. DC-6.0 GHz 1.0W Packaged HFET F1001-SC April 2010 - Rev 05-Apr-10 App Note [1] Biasing - The XF1001-SC requires power supply sequencing. Negative voltage supply (Vgg) needs to be turned on first and then positive voltage can be applied to the drain (Vdd). When turning off the device, the positive supply (Vdd) should be turned off first and then negative voltage (Vgg) can be removed. The gate voltage is adjusted in order to set the drain current to the desired level. The gate voltage required to achieve a certain current can vary over temperature and from one device to another due to pinch-off voltage variation. Constant drain current can be achieved by Implementing an active bias circuit which allows for temperature compensation and eliminates the effect of pinch off voltage variation. Physical Dimensions Pin-out Details Description Pin # RF Input 1 RF Output 3 GND 2, 4 Mimix Broadband, Inc., 10795 Rockley Rd., Houston, Texas 77099 Tel: 281.988.4600 Fax: 281.988.4615 mimixbroadband.com Page 6 of 7 Characteristic Data and Specifications are subject to change without notice. ©2010 Mimix Broadband, Inc. Export of this item may require appropriate export licensing from the U.S. Government. In purchasing these parts, U.S. Domestic customers accept their obligation to be compliant with U.S. Export Laws. DC-6.0 GHz 1.0W Packaged HFET F1001-SC April 2010 - Rev 05-Apr-10 Handling and Assembly Information CAUTION! - Mimix Broadband MMIC Products contain gallium arsenide (GaAs) which can be hazardous to the human body and the environment. For safety, observe the following procedures: Do not ingest. Do not alter the form of this product into a gas, powder, or liquid through burning, crushing, or chemical processing as these by-products are dangerous to the human body if inhaled, ingested, or swallowed. Observe government laws and company regulations when discarding this product. This product must be discarded in accordance with methods specified by applicable hazardous waste procedures. Life Support Policy - Mimix Broadband's products are not authorized for use as critical components in life support devices or systems without the express written approval of the President and General Counsel of Mimix Broadband. As used herein: (1) Life support devices or systems are devices or systems which, (a) are intended for surgical implant into the body, or (b) support or sustain life, and whose failure to perform when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in a significant injury to the user. (2) A critical component is any component of a life support device or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness. Package Attachment - This packaged product from Mimix Broadband is provided as a rugged surface mount package compatible with high volume solder installation. Care should be taken not to apply heavy pressure to the top or base material to avoid package damage. Vacuum tools or other suitable pick and place equipment may be used to pick and place this part. Care should be taken to ensure that there are no voids or gaps in the solder connection so that good RF, DC and ground connections are maintained. Voids or gaps can eventually lead not only to RF performance degradation, but reduced reliability and life of the product due to thermal stress. Mimix Lead-Free RoHS Compliant Program - Mimix has an active program in place to meet customer and governmental requirements for eliminating lead (Pb) and other environmentally hazardous materials from our products. All Mimix RoHS compliant components are form, fit and functional replacements for their non-RoHS equivalents. Lead plating of our RoHS compliant parts is 100% matte tin (Sn) over copper alloy and is backwards compatible with current standard SnPb low-temperature reflow processes as well as higher temperature (260°C reflow) “Pb Free” processes. Ordering Information Part Number for Ordering XF1001-SC-0G00 XF1001-SC-0G0T XF1001-SC-EV1 Description Matte Tin plated RoHS compliant SOT-89 surface mount package in bulk quantity Matte Tin plated RoHS compliant SOT-89 surface mount package in tape and reel Evaluation Board @ 5800 MHz C a u t i o n : E S D S e n s i t i ve Appropriate precautions in handling, packaging and testing devices must be observed. Proper ESD procedures should be followed when handling this device. Mimix Broadband, Inc., 10795 Rockley Rd., Houston, Texas 77099 Tel: 281.988.4600 Fax: 281.988.4615 mimixbroadband.com Page 7 of 7 Characteristic Data and Specifications are subject to change without notice. ©2010 Mimix Broadband, Inc. Export of this item may require appropriate export licensing from the U.S. Government. In purchasing these parts, U.S. Domestic customers accept their obligation to be compliant with U.S. Export Laws.