RO2166E RO2166E-1 RO2166E-2 ® • • • • • Ideal for European 857.65 MHz Transmitters Very Low Series Resistance Quartz Stability Surface-Mount Ceramic Case with 21 mm2 Footprint Complies with Directive 2002/95/EC (RoHS) 857.65 MHz SAW Resonator Pb The RO2166E is a true one-port, surface-acoustic-wave (SAW) resonator in a surface-mount ceramic case. It provides reliable, fundamental-mode, quartz frequency stabilization of local oscillators operating at 857.65 MHz. This SAW is designed for 857.65 MHz superhet receivers with 10.7 MHz IF. Applications include remote-control and wireless security receivers operating under ETSI-ETS 300 220 in Europe and under FTZ 17 TR 2100 in Germany. Absolute Maximum Ratings CW RF Power Dissipation +0 dBm DC Voltage Between Terminals ±12 VDC Case Temperature -40 to +125 °C Operating Temperature Range -40 to +125 °C 260 °C Soldering Temperature (10 seconds / 5 cycles max.) SM3030-6 Case 3.0 X 3.0 Electrical Characteristics Frequency (+25 °C) Characteristic Nominal Frequency Tolerance from 857.65 MHz RO2166E RO2166E-1 RO2166E-2 RO2166E RO2166E-1 RO2166E-2 Notes fC 2, 3, 4, 5 Minimum 857.500 857.550 857.575 Typical ∆fC Insertion Loss Quality Factor Unloaded Q 50 Ω Loaded Q Temperature Stability Turnover Temperature Turnover Frequency Frequency Temperature Coefficient Frequency Aging Absolute Value during the First Year DC Insulation Resistance between Any Two Terminals RF Equivalent RLC Model Motional Resistance Motional Inductance Motional Capacitance Transducer Static Capacitance Test Fixture Shunt Inductance Lid Symbolization (in addition to Lot and/or Date Codes) Reel Size 7 Inch Standard Reel Quantity Reel Size 13 Inch Sym IL QU QL TO fO FTC |fA| RM LM CM CO LTEST 2, 5, 6 5, 6, 7 15 6, 7, 8 1 5 5, 6, 7, 9 5, 6, 9 2, 7 10 0.9 5607 310 25 fC 0.032 10 Maximum 857.800 857.750 857.725 ±150 ±100 ±75 1.6 Units 35 °C kHz ppm/°C2 ppm/yr MΩ Ω µH fF pF nH 1.0 5.9 17 6.1 5.6 1.64 21.00 514 / YWWS 500 Pieces / Reel 3000 Pieces / Reel MHz kHz dB CAUTION: Electrostatic Sensitive Device. Observe precautions for handling. Notes: 1. 2. 3. 4. 5. 6. 7. Frequency aging is the change in fC with time and is specified at +65°C or less. Aging may exceed the specification for prolonged temperatures above +65°C. Typically, aging is greatest the first year after manufacture, decreasing in subsequent years. The center frequency, fC, is measured at the minimum insertion loss point, ILMIN, with the resonator in the 50 Ω test system (VSWR ≤ 1.2:1). The shunt inductance, LTEST, is tuned for parallel resonance with CO at fC. Typically, fOSCILLATOR or fTRANSMITTER is approximately equal to the resonator fC. One or more of the following United States patents apply: 4,454,488 and 4,616,197. Typically, equipment utilizing this device requires emissions testing and government approval, which is the responsibility of the equipment manufacturer. Unless noted otherwise, case temperature TC = +25°C±2°C. The design, manufacturing process, and specifications of this device are subject to change without notice. Derived mathematically from one or more of the following directly measured 8. 9. 10. 11. parameters: fC, IL, 3 dB bandwidth, fC versus TC, and CO. Turnover temperature, TO, is the temperature of maximum (or turnover) frequency, fO. The nominal frequency at any case temperature, TC, may be calculated from: f = fO [1 - FTC (TO -TC)2]. Typically oscillator TO is approximately equal to the specified resonator TO. This equivalent RLC model approximates resonator performance near the resonant frequency and is provided for reference only. The capacitance CO is the static (nonmotional) capacitance between the two terminals measured at low frequency (10 MHz) with a capacitance meter. The measurement includes parasitic capacitance with "NC” pads unconnected. Case parasitic capacitance is approximately 0.05 pF. Transducer parallel capacitance can by calculated as: CP ≈ CO - 0.05 pF. Tape and Reel Standard for ANSI / EIA 481. This product complies with directive 2002/95/EC of the European Parlament and of the Council of 27 January 2003 on the restriction of the use of certain hazardous substances in electrical and electronic equipment. RF Monolithics, Inc. Phone: (972) 233-2903 Fax: (972) 387-8148 RFM Europe Phone: 44 1963 251383 Fax: 44 1963 251510 ©1999 by RF Monolithics, Inc. The stylized RFM logo are registered trademarks of RF Monolithics, Inc. E-mail: [email protected] http://www.rfm.com RO2166E-113004 Page 1 of 2 857.650 MHz SAW Resonator Electrical Connections The SAW resonator is bidirectional and may be installed with either orientation. The two terminals are interchangeable and unnumbered. The callout NC indicates no internal connection. The NC pads assist with mechanical positioning and stability. External grounding of the NC pads is recommended to help reduce parasitic capacitance in the circuit. Pin Connection 1 NC 2 Terminal 3 NC 4 NC 5 Terminal 6 NC Power Test 50 Ω Source at F C P INCIDENT Low-Loss Matching Network to 50 Ω P REFLECTED 1 6 2 3 5 4 Typical Application Circuits B G C H Typical Low-Power Transmitter Application 1 6 1 6 200k Ω +9VDC Modulation Input A 2 5 E F 2 5 C1 I 47 L1 (Antenna) 4 3 1 3 4 6 D 2 3 5 4 J C2 ROXXXXC Bottom View RF Bypass 470 Typical Local Oscillator Application Case Dimensions Dimension A B C D E F G H I J Min 2.87 2.87 1.12 0.77 2.67 1.47 0.72 1.37 0.47 1.17 Output 200k Ω +VDC mm Nom 3.0 3.0 1.25 0.90 2.80 1.6 0.85 1.5 0.60 1.30 Max 3.13 3.13 1.38 1.03 2.93 1.73 0.98 1.63 0.73 1.43 Min 0.113 0.113 0.044 0.030 0.105 0.058 0.028 0.054 0.019 0.046 Inches Nom 0.118 0.118 0.049 0.035 0.110 0.063 0.033 0.059 0.024 0.051 C1 +VDC L1 Max 0.123 0.123 0.054 0.040 0.115 0.068 0.038 0.064 0.029 0.056 1 6 2 3 5 4 C2 ROXXXXC Bottom View RF Bypass Equivalent LC Model 0.05 pF* Co = Cp + 0.05 pF Cp Typical Test Circuit *Case Parasitics The test circuit inductor, LTEST, is tuned to resonate with the static capacitance, CO, at FC. Rm Electrical Test Lm Cm Temperature Characteristics The curve shown on the right accounts for resonator contribution only and does not include LC component temperature contributions. fC = f O , T C = T O 0 0 6 5 2 4 3 To 50 Ω Network Analyzer -50 -50 -100 -100 -150 -150 (f-fo ) / fo (ppm) 1 From 50 Ω Network Analyzer -200 -80 -60 -40 -20 -200 0 +20 +40 +60 +80 ∆T = TC - T O ( °C ) RF Monolithics, Inc. Phone: (972) 233-2903 Fax: (972) 387-8148 RFM Europe Phone: 44 1963 251383 Fax: 44 1963 251510 ©1999 by RF Monolithics, Inc. The stylized RFM logo are registered trademarks of RF Monolithics, Inc. E-mail: [email protected] http://www.rfm.com RO2166E-113004 Page 2 of 2