ASB ALN2642L

plerowTM ALN2642L
Internally Matched LNA Module
Features
Description
・ 50 dB Gain at 2642.5 MHz
・ +12 ~ +17 dBm P1dB
・ +24 dBm Output IP3
・ 1.2 dB Noise Figure
・ 25 dB Gain Control Range
・ Power-detecting Function
・ Power Shutdown Available
The plerowTM ALN-series is the compactly designed surface-mount
module for the use of the LNA with or without the following gain blocks in
the infrastructure equipment of the mobile wireless (CDMA, GSM, PCS,
PHS, WCDMA, DMB, WLAN, WiBro, WiMAX), GPS, satellite communication terminals and so on. It has an exceptional performance of low
noise figure, high gain, high OIP3, and low bias current. The stability
factor is always kept less than unity over the application band in order to
confirm its unconditionally stable implementation to the application system environment. The surface-mount module package including the
completed matching circuit and other components necessary just in case
allows very simple and convenient implementation onto the system
board in mass production level.
Specifications
Parameter
Frequency Range
@ T = 25°C, VCC = 5 V, Freq. =2642 MHz, 50 ohm
Unit
Specifications
Min
Website: www.asb.co.kr
E-mail: [email protected]
± 0.5
± 0.7
Tel: (82) 42-528-7223
Fax: (82) 42-528-7222
dB
1.2
1.3
dBm
24
2630
Gain
dB
48
Gain Flatness
dB
Output IP3
S11 / S22
50
dB
-14 / -14
Output P1dB
dBm
12 ~ 17
Power-detecting Range
dBm
-5 ~ +15
Power-detecting DC Output
Max
2655
MHz
Noise Figure
More Information
Typ
V
0.3 ~ 2.9
Switching Time
µsec
-
Supply Current
mA
Supply Voltage
V
5
Impedance
Ω
50
Max. RF Input Power
dBm
C.W 29 ~ 31 (before fail)
Package Type & Size
mm
Surface Mount Type, 36Wx36Lx4.0H
ASB Inc., 4th Fl. Venture Town
Bldg., 367-17 Goijeong-Dong,
Seo-Gu, Daejon 302-716, Korea
250
1) Operating temperature is -40°C to +85°C.
2) OIP3 is measured with two tones at an output power of 3 dBm / tone separated by 1 MHz.
3) Note: We recommend that the VSWR toward a source and load be less than 4:1 to avoid an unwanted oscillation.
4) S11/S22 (max) is the worst value within the frequency band.
Outline Drawing
ALN2642L
TOP
BOTTOM
SIDE
; soldering area
; φ0.5 plated thru hole to
ground plane
(unit ; mm)
1/1
SUGGESTED FOOTPRINT
www.asb.co.kr
Pin Number
Function
1
Shutdown
3
RF In
5
ATT. Cont.
8
RF Out
9
RF Detect
10
+Vcc
All Other Pins
Ground
Note: 1. The number and size of ground via holes in
a circuit board is critical for thermal RF
grounding considerations.
2. We recommend that the ground via holes be
placed on the bottom of all ground pins for
better RF and thermal performance, as
shown in the drawing at the left side.
October 2007