NON-ISOLATED DC/DC CONVERTERS 4.5 Vdc - 14 Vdc Input VRBC-16E1Ax 0.75 Vdc - 3.63 Vdc/16 A Output RoHS Compliant Rev.A • Non-Isolated • Under-voltage Lockout (UVLO) • High Efficiency • OCP/SCP • Fixed Frequency • Wide Trim • Low Cost • Wide Input • Industrial Temperature Range • Remote Sense • Logic Low/High (Option) • Remote On/Off • Over Temperature Shutdown Description The Bel VRBC-16E1Ax is part of the non-isolated dc/dc converter series. The modules use a SIP package. These converters are available in a range of output voltages from 0.75 Vdc to 3.63 Vdc over a wide range of input voltage (Vin = 4.5 Vdc - 14 Vdc). The efficiency is typically 92% at 3.3 Vdc output at full load. Part Selection Output Voltage 0.75 V - 3.63 V Input Voltage 4.5 V - 14 V Max. Output Current 16 A Max. Output Power 58 W Typical Efficiency 92% Model Number Active Low VRBC-16E1AL Model Number Active High VRBC-16E1A0 Notes: 1. Add “G” suffix at the end of the model number to indicate Tray Packaging. 2. All part numbers above indicate RoHS 6. Change the second letter "R" to "7" for RoHS 5 part numbers. Absolute Maximum Ratings Parameter Input Voltage (continuous) Output Enable Terminal Voltage Ambient Temperature Storage Temperature Min -0.3 V -0.3 V -40 °C Typ - Max 15 V 15 V 85 °C -55 °C - 125 °C Notes Input Specifications Parameter Input Voltage Vo,set < 3.0 Vo,set ≥ 3.0 Min Typ Max 4.5 V Vo,set+1.5 V - 14 V 14 V Input Current (full load) - - 15 A Input Current (no load) Remote Off Input Current - 100 mA 2 mA - Input Reflected Ripple Current (pk-pk) - - 400 mA Input Reflected Ripple Current (rms) - - 150 mA I t Inrush Current Transient - 0.2 A s 0.4 A s Turn-on Voltage Threshold Turn-off Voltage Threshold 3.7 V 4.3 V - 4.2 V 2 2 Notes This power module is not internally fused. An input line fuse must always be used Tested with one 1000 uF / 25 V AL input capacitor with ESR=0.03 ohm max and 6 × 47 uF/16 V Tantalum capacitors with ESR=0.013 ohm max at 100 kHz, & simulated source impedance of 1000 nH, 5 Hz to 20 MHz. 2 Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 • Tel 201-432-0463 • Fax 201-432-9542 • www.belfuse.com NON-ISOLATED DC/DC CONVERTERS 4.5 Vdc - 14 Vdc Input 0.75 Vdc - 3.63 Vdc/16 A Output Output Specifications Parameter Output Voltage Set Point Load Regulation Line Regulation Regulation Over Temperature (-40°C to +85°C) Output Current Current Limit Threshold Short Circuit Surge Transient Min -2%Vo,set - Typ 0.2%Vo,set 0.3%Vo,set Max 2%Vo,set - - 0.3%Vo,set - 0A - 180% Io,out 2 1A s 16 A 2 3A s Ripple and Noise (pk-pk) - 30 mV 80 mV Ripple and Noise (rms) Turn on Time Overshoot at Turn on Output Capacitance Transient Response 50% ~ 100% Max Load Settling Time 100% ~ 50% Max Load Settling Time 0 uF 12 mV 8 mS - 35 mV 20 mS 1%Vo,set 5600 uF - All 100 mV 80 uS 100 mV 80 uS - Notes Vin=12 V, full load Tested with 0-20 MHz, 10 uF tantalum capacitor & 1 uF ceramic capacitor at the output di/dt=0.5 A / uS; Vin=12 V and and without any external capacitor at the output. Note: All specifications are typical at nominal input, full load at 25 °C unless otherwise stated. General Specifications Parameter Min Typ Max Vo=3.3 V Vo=2.5 V Vo=1.8 V Vo=1.5 V Vo=1.2 V Vo=0.75 V - 91.7% 90.4% 87.5% 86% 85% 79% - Vo=3.3 V Vo=2.5 V Vo=1.8 V Vo=1.5 V Vo=1.2 V Vo=0.75 V 250 kHz 0.7525 V 93.5% 91.5% 88.4% 87% 86% 80% 280 kHz 130 °C - 310 kHz 3.63 V - - 0.5 V Efficiency Efficiency Switching Frequency 1 Over Temperature Shutdown Output Trim Range (Wide Trim) Remote Sense Compensation MTBF 4,619,490 hours Dimensions Inches (L × W × H) Millimeters (L × W × H) Weight - 2.0x 0.5 x 0.32 50.8 x 12.7 x 8.13 7.1 g Notes Measured at Vin=12 V, lo=lo-max Measured at Vin=5 V, lo=lo-max Total adjustment of trim, setpoint and remote sense combined should not exceed 3.63 V. Vo=0.7525 V when trim pin open Calculated Per Bell Core TR-332 (IO = 80%Io,max; Vin=12 V; Vo=3.3 V; Ta = 25°C) - Notes: All specifications are typical at 25 °C unless otherwise stated. 1. The Tref temperature measurement location: Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 • Tel 201-432-0463 • Fax 201-432-9542 • www.belfuse.com NON-ISOLATED DC/DC CONVERTERS 4.5 Vdc - 14 Vdc Input 0.75 Vdc - 3.63 Vdc/16 A Output Control Specifications Parameter Remote On/Off Min Typ Max Signal Low (Unit Off) -0.2V - 0.3V Signal High (Unit On) - - Vin, max Signal Low (Unit On) -0.2V - 0.3V Signal High (Unit Off) 2.5V - Vin, max Notes VRBC-16E1A0; Remote On/Off pin open, Unit on. VRBC-16E1AL; Remote On/Off pin open, Unit on. Output Trim Equations Equation for calculating the trim resistor (in Ω) given the desired output voltage (Vo) is shown below. The Trim Up resistor should be connected between the Trim pin and Ground. Vout Rtrim = 10500 − 1000 Vo − 0.7525 Sense Module trim Rtrim GND Equation for calculating the trim voltage (in V) given the desired output voltage (Vo) is shown below. The Trim Up voltage should be connected between the Trim pin and Ground. Vout Vtrim = 0.7 − 0.0667 × (Vo − 0.7525) Sense Module trim Vtrim GND Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 • Tel 201-432-0463 • Fax 201-432-9542 • www.belfuse.com NON-ISOLATED DC/DC CONVERTERS 4.5 Vdc - 14 Vdc Input 0.75 Vdc - 3.63 Vdc/16 A Output Efficiency Data MODULE 2.5V 100% 95% 90% 85% 80% 75% 70% 5.0V 12.0V EFFICIENCY EFFICIENCY MODULE 3.3V 100% 90% 5.0V 12.0V 80% 70% 1.6 4.0 8.0 12.0 16.0 1.6 OUTPUT CURRENT 4.0 100% 95% 90% 85% 80% 75% 70% 5.0V 12.0V EFFICIENCY EFFICIENCY 12.0 16.0 MODULE 1.5V MODULE 1.8V 105% 95% 5.0V 12.0V 85% 75% 65% 1.6 4.0 8.0 12.0 1.6 16.0 OUTPUT CURRENT 4.0 8.0 12.0 OUTPUT CURRENT 16.0 EFFICIENCY 5.0V 12.0V 4.0 12.0 16.0 MODULE 0.75V 100% 90% 80% 70% 60% 50% 1.6 8.0 OUTPUT CURRENT MODULE 1.2V EFFICIENCY 8.0 OUTPUT CURRENT 100% 90% 80% 70% 60% 50% 5.0V 12.0V 1.6 4.0 8.0 12.0 16.0 OUTPUT CURRENT Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 • Tel 201-432-0463 • Fax 201-432-9542 • www.belfuse.com NON-ISOLATED DC/DC CONVERTERS 4.5 Vdc - 14 Vdc Input 0.75 Vdc - 3.63 Vdc/16 A Output Thermal Derating Curves Vo=0.75 V; Vin=12 V Vo=1.8 V; Vin=12 V Vo=3.3 V; Vin=12 V Ripple and Noise Waveforms Vin=5.0 V, Vo=3.3 V Vin=12 V, Vo=3.3 V Note: External load with 10 uF tantalum capacitor and 1 uF ceramic at the output, full load, Ta=25 deg C. Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 • Tel 201-432-0463 • Fax 201-432-9542 • www.belfuse.com NON-ISOLATED DC/DC CONVERTERS 4.5 Vdc - 14 Vdc Input 0.75 Vdc - 3.63 Vdc/16 A Output Transient Response Waveforms 50% to 100% load Transient at Vin=5 V, Vo=3.3 V 100% to 50% load Transient at Vin=5 V, Vo=3.3 V 50% to 100% load Transient at Vin=12 V, Vo=3.3 V 100% to 50% load Transient at Vin=12 V, Vo=3.3 V Note: External load capacitor Cext=0 uF, and Ta=25 deg C. Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 • Tel 201-432-0463 • Fax 201-432-9542 • www.belfuse.com NON-ISOLATED DC/DC CONVERTERS 4.5 Vdc - 14 Vdc Input 0.75 Vdc - 3.63 Vdc/16 A Output Mechanical Outline Pin Connections Pin Function 1 Vo 2 Vo 3 Remote Sense 4 Vo 5 Ground 6 Ground 7 Vin 8 Vin 9 N/A 10 Trim 11 Remote On/Off RoHS Compliance Complies with the European Directive 2002/95/EC, calling for the elimination of lead and other hazardous substances from electronic products. ©2007 Bel Fuse Inc. Specifications subject to change without notice. 011807 CORPORATE FAR EAST EUROPE Bel Fuse Inc. 206 Van Vorst Street Jersey City, NJ 07302 Tel 201-432-0463 Fax 201-432-9542 www.belfuse.com Bel Fuse Ltd. 8F/ 8 Luk Hop Street San Po Kong Kowloon, Hong Kong Tel 852-2328-5515 Fax 852-2352-3706 www.belfuse.com Bel Fuse Europe Ltd. Preston Technology Management Centre Marsh Lane, Suite G7, Preston Lancashire, PR1 8UD, U.K. Tel 44-1772-556601 Fax 44-1772-888366 www.belfuse.com