RGPP30 SERIES GLASS PASSIVATED FAST SWITCHING RECTIFIER CHENG- YI ELECTRONIC VOLTAGE RANGE 50 TO 1000 Volts CURRENT 3.0 Amperes DO-201AD FEATURE High voltage High current capability Low leakage current High surge capability Low cost MECHANICAL DATA Case:Mold plastic use UL 94V-0 recognized flame retardant epoxy Terminals:Axial leads, solderable per MIL-STD-202, method 208 Polarity:Color band denotes cathode Mounting Position:Any MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 250C ambient temperature unless otherwise specified. Signle phase, half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20%. RGPP30A RGPP30B RGPP30D RGPP30G RGPP30J RGPP30K RGPP30M Maximum Recurrent Peak Reverse Voltage 50 Maximum RMS Voltage 35 70 140 280 420 Maximum DC Blocking Voltage 50 100 200 400 600 100 200 Maximum Average Forward Rectified Current, .375", (9.5mm) Lead Length at TA =55 C 600 800 Peak Forward Surge Current 8.3 ms single half sine-wave V 560 700 V 800 1000 V A 150 Maximum Forward Voltage at 3.0A Peak A V 1.3 1.2 Maximum Reverse Current, Rated DC Full Cycle Average, .375", (9.5mm) Lead Length T A =55 C UNITS 1000 3.0 0 A 30 0 Maximum DC Reverse Current, at Rated DC Blocking Voltage Maximum Reverse Recovery Time (Note 1) 400 A 5.0 150 Typical Junction Capacitance (Note 2) Operating and Storage Temperature Range Notes : 1. Reverse Recovery Test Conditions : IF=.5A, I R=1A, Irr=.25A 2. Measured at 1.0MHz and applied reverse voltage of 4.0 Volts 150 150 150 60 -65 to +175 250 500 500 nS pF 0 C RGPP30 SERIES GLASS PASSIVATED FAST SWITCHING RECTIFIER CHENG- YI ELECTRONIC RATING AND CHARACTERISTICS CURVES RGPP30 SERIES Fig. 1 - REVERSE RECOVERY TIME CHARACTERISTIC AND TEST CIRCUIT DIAGRAM 50 NONINDUCTIVE trr 10 NONINDUCTIVE +0.5A ( ) D.U.T. (+) 0 PULSE GENERATOR (NOTE 2) 25 Vdc (approx.) ( ) OSCILLOSCOPE (NOTE 1) 1 NONINDUCTIVE -0.25 (+) -1.0A NOTES : 1. Rise Time=7ns max., Input Impedance= 1 megohm, 22pF. 2. Rise Time=10ns max., Source Impedance= 50 ohms. SET TIME BASE FOR 5 / 10ns/cm 1cm Fig. 3 - TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS AVERAGE FORWARD RECTIFIED CURRENT, AMPERES 3.0 SINGLE PHASE HALF WAVE 60HZ RESISTIVE OR INOUCTIVE LOAD .375" LEAD LENGTH 2.5 2.0 1.5 1.0 0.5 INSTANTANEOUS FORWARD CURRENT, AMPERES Fig. 2 - FORWARD CURRENT DERATING CURVE 10 1.0 0 TJ = 25 C 0.1 .01 0 25 50 100 75 125 150 .4 175 .6 .8 1.0 1.2 1.4 1.6 0 AMBIENT TEMPERATURE, C INSTANTANEOUS FORWARD VOLTAGE, VOLTS 100 CAPACITANCE-pF 0 TJ=25C 10 1 1 10 REVERSE VOLTAGE. VOLTS 100 FORWARD SURGE CURRENT, AMPERES, PK (HALF-SINE WAVE) Fig. 4 - TYPICAL JUNCTION CAPACITANCE Fig. 5 - PEAK FORWARD SURGE CURRENT 250 200 150 0 TJ=25C 100 50 0 1 10 NUMBER OF CYCLES AT 60Hz 100