FR1012GP THRU FR1020GP Shanghai Lunsure Electronic Technology Co.,Ltd Tel:0086-21-37185008 Fax:0086-21-57152769 Features • • • • • • 1 Amp Glass Passivated Rectifier 1200 to 2000 Volts Low Cost Low Leakage Low Forward Voltage Drop High Current Capability Fast Switching Speed For High Efficiency Glass Passivated Junction Maximum Ratings • • DO-41 Operating Temperature: -55°C to +150°C Storage Temperature: -55°C to +150°C Catalog Number FR1012GP FR1014GP FR1016GP FR1018GP FR1020GP Device Marking ------------ Maximum Recurrent Peak Reverse Voltage 1200V 1400V 1600V 1800V 2000V Maximum RMS Voltage 840V 980V 1120V 1260V 1400V Maximum DC Blocking Voltage 1200V 1400V 1600V 1800V 2000V D A Cathode Mark B D Electrical Characteristics @ 25°C Unless Otherwise Specified Average Forward Current Peak Forward Surge Current Maximum Instantaneous Forward Voltage 18-20 Maximum DC Reverse Current At Rated DC Blocking Voltage IF(AV) 1A TA = 55°C IFSM 30A 8.3ms, half sine VF 1.35V 1.50V IR 5.0µA 100µA C IFM = 1.0A; TA = 25°C DIMENSIONS TA = 25°C TA = 100°C DIM A B C D INCHES MIN .166 .080 .028 1.000 Maximum Reverse Recovery Time 300ns IF=0.5A, IR=1.0A, FR1012-1016 Trr 500ns Irr=0.25A FR1018-1020 Typical Junction CJ 15pF Measured at Capacitance 1.0MHz, VR=4.0V *Pulse Test: Pulse Width 300µsec, Duty Cycle 1% www.cnelectr.com MAX .205 .107 .034 --- MM MIN 4.10 2.00 .70 25.40 MAX 5.20 2.70 .90 --- NOTE FR1012GP thru FR1020GP Figure 1 Typical Forward Characteristics 20 Figure 2 Forward Derating Curve 10 1.2 6 4 1.0 2 25°C Amps .8 1 .6 .6 Amps .4 .4 .2 .2 .1 Single Phase, Half Wave 60Hz Resistive or Inductive Load .06 0 .04 0 50 75 100 125 150 175 °C .02 .01 .4 .6 .8 1.0 Average Forward Rectified Current - Amperesversus Ambient Temperature - °C 1.4 12 Volts Instantaneous Forward Current - Amperesversus Instantaneous Forward Voltage - Volts Figure 3 Junction Capacitance 100 60 40 20 pF TJ=25°C 10 6 4 2 1 .1 .2 .4 1 Volts 2 4 10 20 40 100 200 Junction Capacitance - pFversus Reverse Voltage - Volts www.cnelectr.com 400 1000 FR1012GP thru FR1020GP Figure 4 Peak Forward Surge Current 60 50 40 30 Amps 20 10 0 1 2 4 6 8 10 20 40 60 80 100 Cycles Peak Forward Surge Current - Amperesversus Number Of Cycles At 60Hz - Cycles Figure 5 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω trr +0.5A 0 Pulse Generator Note 2 25Vdc 1Ω Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive Oscilloscope Note 1 -0.25 -1.0 1cm Set Time Base for 20/100ns/cm www.cnelectr.com