DM9601E Product Brief USB to Ethernet MAC Controller with Integrated 10/100 PHY June 2008 Rev.1.0 The DM9601 is a fully integrated and cost-effective single chip USB to Fast Ethernet MAC controller with 10/100 PHY. It is designed with the low power and high performance process. It is a 3.3V device with 5V tolerance then it supports 3.3V and 5V signaling. The DM9601 provides USB transceiver compliant with USB1.1, 10/100M PHY, MAC controller, memory controller and an external MII interface to connect HPNA device or other support MII interface transceiver. This chip already integrated 16K byte SRAM. The DM9601 interfaces to the UTP3, 4, 5 in 10Base-T and UTP5 in 100Base-TX. It is fully compliance with the IEEE 802.3u Spec. Its auto-negotiation function will automatically configure the DM9601 to take the maximum advantage of its abilities. The DM9601 is also support IEEE 802.3x full-duplex flow control. The DM9601 supports 3 wake-up event to wake-up system from suspend mode. There are 7 GPIO pins (General purpose I/O) for user’s application. Block Diagram PHYceiver MAC 100 Base-TX PCS TX Machine 10 Base-T Tx/Rx Memory Management RX Machine RX+/Internal SRAM Autonegotiation MII Management Control & MII Register DP USB Tx/Rx MII TX+/- Control &Status Registers EP / SIE controller 100 Base-TX transceiver EEPROM Interface External MII Interface LED DM Specifications ■ USB Characteristics: z USB Specification revision 1.1 compliant z Supports 12MHz Full-Speed operation z Supports suspend mode and remote wake-up resume z Supports USB standard commands z Supports vendor specific commands z Supports test-mode for memory test. z Efficient TX/RX FIFO auto management. ■ Transceiver: 10/100M PHY, USB 1.1 ■ Others: z Supports large internal 16K byte SRAM z Supports automatically load vendor ID and product ID from EEPROM z Supports MII and reverse MII interface z IEEE802.3x flow control for full-duplex mode z Back Pressure Mode for half-duplex mode flow control z Supports wakeup frame, link status change and Magic packet events for remote wake-up z Low-Power, Single-Supply 3.3V CMOS technology z Very Low Power Consumption mode ¾ Power Reduced mode(cable detection) ¾ Power Down mode ¾ Selectable TX drivers for 1:1 or 1.25:1 transformers for additional power reduction. z Compatible with 3.3V and 5.0V tolerant I/O z 100-pin LQFP Application VoIP CPE (ATA, IP Phone, Video Phone) IP STB, IPC, Internet Radio Ordering Information Part Number DM9601E Pin Count 100 Package LQFP DAVICOM Semiconductor, Inc. No.6, Li-Hsin Rd.VI, Science Park, Hsin-Chu, Taiwan, R.O.C. TEL: 886-3-5798797 FAX: 886-3-5646929 E-mail: [email protected]