Frontier Electronics Corp. 667 E. COCHRAN STREET, SIMI VALLEY, CA 93065 TEL: (805) 522-9998 FAX: (805) 522-9989 E-mail: [email protected] Web: frontierusa.com Insert Molded Coil—2433 series A. Mechanical Drawing: B. Electrical Specification: Part No. 2433-01 2433-02 2433-03 2433-04 2433-05 2433-06 2433-07 2433-08 2433-09 2433-10 L Min. (uH) 0.047 0.068 0.090 0.117 0.148 0.188 0.231 0.272 0.330 0.390 L Nom. (uH) 0.048 0.078 0.108 0.146 0.190 0.240 0.292 0.342 0.405 0.465 L Max. (uH) 0.049 0.085 0.126 0.175 0.232 0.292 0.350 0.412 0.480 0.540 Q Min. @ L Nom. 90 @ 50MHz 100 @ 50MHz 100 @ 50MHz 94 @ 50MHz 88 @ 50 MHz 78 @ 50 MHz 72 @ 50 MHz 68 @ 50 MHz 66 @ 40 MHz 60 @ 40 MHz Color Brown Red Orange Yellow Green Blue Violet Gray White Black C. Features: 1. Plastic molded. 2. High reliability. 3. Low cost. D. Measurement: 1. Q and L measured with ½” long of TCW#16 soldered along the coil leads and with one end flush with the bottom of the coil then bent ¼” down from stand off at an angle of 90°. 2. L min. measured with core halfway out of the top of the form. 3. Inductance greater than 0.1uH read at recommended Q meter frequency. 4. Inductance below 0.1uH calculated from readings taken at 50MHz. E. Test equipment: Q meter (HP 4342A) IMC 2433 series Mar. 15, 2002 Page 1 of 1