LITEON LPTL21157AFBK1

LITE-ON TECHNOLOGY CORPORATION
Property of Lite-On Only
FEATURES
*2.0 inch ( 50.80 mm) MATRIX HEIGHT
*LOW POWER REQUIREMENT
*HIGH BRIGHTNESS & HIGH CONTRAST
*SINGLE PLANE, WIDE VIEWING ANGLE
*SOLID STATE RELIABILITY
* 5×7 ARRAY WITH X-Y SELECT
*COMPATIBLE WITH USASCII AND EBCDIC CODES
*STACKABLE HORIZONTALLY
*CATEGORIZED FOR LUMINOUS INTENSITY
DESCRIPTION
The LPTL21157AFBK1 is a 2.0 inch (50.8 mm) matrix height
5×7 dot matrix display. This device uses AS-AlInGaP RED LED
chips (AlInGaP epi on GaAsP substrate). The matrix display has
black face and transparent dot.
DEVICE
PART NO.
DESCRIPTION
AlInGaP RED
Cathode Column
Anode Row
LPTL21157AFBK1
PART NO.: LPTL21157AFBK1
BNS-OD-C131/A4
PAGE:
1 of 5
LITE-ON TECHNOLOGY CORPORATION
Property of Lite-On Only
PACKAGE DIMENSIONS
NOTES: 1.All dimensions are in millimeters. Tolerance is ± 0.25 mm (0.01“) unless otherwise noted.
2.Pin tip’s shift tol. is +/0.4mm
INTERNAL CIRCUIT DIAGRAM
PART NO.: LPTL21157AFBK1
BNS-OD-C131/A4
PAGE:
2 of 5
LITE-ON TECHNOLOGY CORPORATION
Property of Lite-On Only
PIN CONNECTION
No.
CONNECTION
1
ANODE ROW 5
2
ANODE ROW 7
3
CATHODE COLUMN 2
4
CATHODE COLUMN 3
5
ANODE ROW 4
6
CATHODE COLUMN 5
7
ANODE ROW 6
8
ANODE ROW 3
9
ANODE ROW 1
10
CATHODE COLUMN 4
11
CATHODE COLUMN 3
12
ANODE ROW 4
13
CATHODE COLUMN 1
14
ANODE ROW 2
.
PART NO.: LPTL21157AFBK1
BNS-OD-C131/A4
PAGE:
3 of 5
LITE-ON TECHNOLOGY CORPORATION
Property of Lite-On Only
ABSOLUTE MAXIMUM RATING
PARAMETER
MAXIMUM RATING
UNIT
Average Power Dissipation Per Dot
40
mW
Peak Forward Current Per Dot
( Frequency 1Khz, 18% duty cycle)
90
mA
Average Forward Current Per Dot
Forward Current Derating from 250C
15
0.2
mA
mA/℃
Reverse Voltage Per Dot
5
-35℃ to +85℃
Operating Temperature Range
V
-35℃ to +85℃
Storage Temperature Range
Soldering Conditions : 1/16 inch below seating plane for 3 seconds at 260℃, or temperature of unit (during
assembly) not over max. temperature rating above
ELECTRICAL / OPTICAL CHARACTERISTICS AT Ta=25oC
PARAMETER
SYMBOL MIN. TYP. MAX. UNIT TEST CONDITION
Average Luminous Intensity
IV
3003
µcd
Ip=2mA
1/16Duty
Peak Emission Wavelength
λp
632
nm
IF=20mA
Spectral Line Half-Width
∆λ
20
nm
IF=20mA
Dominant Wavelength
λd
624
nm
IF=20mA
Forward Voltage any Dot
VF
2.05
2.6
V
IF=20mA
Reverse Current any Dot
IR
100
µA
VR=5V
IV-m
2:1
Luminous Intensity Matching Ratio
IF=10mA
Note: Luminous intensity is measured with a light sensor and filter combination that
approximates the CIE (Commision Internationale De L’Eclairage) eye-response curve.
BIN GRADE
RANGE
PART NO.: LPTL21157AFBK1
BNS-OD-C131/A4
K2
21.1
:
34.0
L1
34.1
:
54.4
L2
54.5
:
87.0
PAGE:
M1
54.5
:
87.0
4 of 5
LITE-ON TECHNOLOGY CORPORATION
Property of Lite-On Only
TYPICAL ELECTRICAL / OPTICAL CHARACTERISTIC CURVES
(25oC Ambient Temperature Unless Otherwise Noted)
PART NO.: LPTL21157AFBK1
BNS-OD-C131/A4
PAGE:
5 of 5