LITE-ON TECHNOLOGY CORPORATION Property of Lite-On Only FEATURES * TTL INTERFACE COMPATIBLE * HIGH SPEED OPTIC SIGNAL TRANSMISSION * BUILT-IN LED DRIVER * LOW POWER CONSUMPTION VDD Vin LED VDD * 2.7V ~ 5.25V HIGH ON FLOATING 2.7V ~ 5.25V LOW OFF FLOATING 2.7V ~ 5.25V FLOATING OFF * WATER CLEAR EPOXY COMPOUND PACKAGED. Vin HIGH LOW LED OFF OFF PACKAGE DIMENSIONS NOTES: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.1mm(.004") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Mark color:Black Part No. : LTDL-TA16A-T DATA SHEET BNS-OD-C131/A4 Page : 1 of 4 LITE-ON TECHNOLOGY CORPORATION Property of Lite-On Only ABSOLUTE MAXIMUM RATINGS AT TA=25℃ PARAMETER MAXIMUM RATING UNIT -0.5 ~ +7 V -0.5 ~ VDD +0.5 V 120 mW Supply Voltage (VDD) Input Voltage (VIN) Power Dissipation (P) Operating Temperature Range -25 ℃ to + 70 ℃ Storage Temperature Range -40 ℃ to + 70 ℃ Lead Soldering Temperature [1.6mm(.063") From Body] 260℃ ≦5 Seconds ELECTRICAL OPTICAL CHARACTERISTICS AT TA=25℃ PARAMETER SYMBOL MIN. TYP. MAX. UNIT TEST CONDITION NRZ signal Ts － － 16 Mbps Operating Voltage VDD 2.75 － 5.25 V Peak Emission Wavelength λPeak 630 650 690 nm Fiber coupling light output Pc -21 -17 -15 dBm *1 Dissipation current IDD － 5 12 mA *2 High level input voltage VIH 2 － － V Low level input voltage VIL － － 0.8 V “LowHigh”propagation delay time tPLH － － 100 ns “HighLow”propagation delay time tPHL － － 100 ns Pulse width distortion ΔtW -15 － 15 ns Jitter Δtj － － 15 ns Transmission Speed Part No. : LTDL-TA16A-T DATA SHEET BNS-OD-C131/A4 Page : *3 2 of 4 LITE-ON TECHNOLOGY CORPORATION Property of Lite-On Only *1 Measuring method of optical output coupling power Transmitter Optical power meter Standard plastic optical fiber cable VIN Calibrate the optical power meter to sense the light with wavelength 650nm. VDD GND +- VDD 0.1uF *2 Power dissipation measuring method Transmitter V IN V DD GND 0.1uF A IDD +- VDD Part No. : LTDL-TA16A-T DATA SHEET BNS-OD-C131/A4 Page : 3 of 4 LITE-ON TECHNOLOGY CORPORATION Property of Lite-On Only *3 Measuring pulse response Transmitter Standard receiver Standard plastic optical fiber cable V IN Output Signal V DD GND +- V DD Oscilloscope Trigger:CH1 0.1uF Input CH1 NRZ code "1010..." pattern CH2 50% Input signal (CH1) Standard receiver output (CH2) t PLH Pulse width distortion 50% t PHL tw = t PHL-t PLH Note (1) NRZ code: 16MHz (2)The impedance of the probe for the oscilloscope must be more than 1MΩ and less than 10pf. Part No. : LTDL-TA16A-T DATA SHEET BNS-OD-C131/A4 Page : 4 of 4