MICROSEMI LX5213CDP

LIN D O C #: 5213
LX5213
9-LINE LOW CAPACITANCE, µP OWER SCSI TERMINATOR
T
H E
I
N F I N I T E
P
O W E R
O F
I
P
N N O VA T I O N
R O D U C T I O N
D
DESCRIPTION
The LX5213 is a nine-line active terminator
for the SCSI parallel bus. This SCSI standard
recommends active termination at both ends
of the SCSI bus.
During disconnect mode, the LX5213 requires a meager 60µA of supply current while
offering only 3.5pF of output capacitance.
To enter this low-power mode, the disconnect pin can be left open (floating) or driven
high, thereby disconnecting the terminating
resistors and placing the internal low dropout
regulator into low-power mode. In disconnect mode, each termination line presents
a high impedance to the SCSI bus with the
overall effect being to preserve high-signal
integrity and yield subsequent reliable, errorfree communications.
During normal operation, the LX5213 con-
A T A
S
H E E T
K E Y F E AT U R E S
■ 3.5pF OUTPUT CAPACITANCE DURING
DISCONNECT
sumes only 600µA of current, which is the
lowest enabled supply current of any terminator available on the market today.
Linfinity's proprietary BiCMOS low dropout
regulator architecture enables this unique
and very efficient operating characteristic.
The LX5213 also offers a precisely trimmed
channel output current specified to a 5%
tolerance. The maximum value of the output
current is trimmed as closely as possible to
the SCSI standard maximum specification to
give the highest possible noise margin for
fast SCSI operation. And the LX5213 sinks
up to 150mA of current, making it compatible
with today's fast active negation drivers.
The LX5213 is a superior, pin-for-pin replacement for a variety of industry products
such as the UC5603 and UC5613.
■ 60µA SUPPLY CURRENT IN DISCONNECT MODE
■ 600µA SUPPLY CURRENT DURING
NORMAL OPERATION
■ 150mA SINK CURRENT FOR ACTIVE
NEGATION
■ LOGIC COMMAND DISCONNECTS ALL
TERMINATION LINES
■ CURRENT LIMIT AND THERMAL
PROTECTION
■ COMPATIBLE WITH SCSI 1, 2 AND 3
STANDARDS
■ CONSULT FACTORY FOR APPLICATION
TEST REPORT: 5213TR
IMPORTANT: For the most current data, consult LinFinity's web site: http://www.linfinity.com.
PRODUCT HIGHLIGHT
R E C E I V I N G W AV E F O R M - 10MH Z
D R I V I N G W AV E F O R M - 10MH Z
Driver
Receiver
1 Meter, AWG 28
LX5213
LX5213
LX5268
LX5268
NOTE:
For An In-Depth
Discussion On Applying
SCSI, Request Linfinity
Application Note:
"Understanding The
Single-Ended SCSI Bus"
PA C K A G E O R D E R I N F O R M AT I O N
TA (°C)
0 to 70
DIP
N Plastic
16-pin
LX5213CN
TSSOP
PWP Plastic
24-pin, Power
LX5213CPWP
SOIC
DP Plastic
16-pin, Power
LX5213CDP
Note: All surface-mount packages are available in Tape & Reel.
Append the letter "T" to part number. (i.e. LX5213CDPT)
Copyright © 1997
Rev. 1.9 7/97
LINFINITY MICROELECTRONICS INC.
11861 W ESTERN A VENUE, G ARDEN G ROVE, CA. 92841, 714-898-8121, F AX: 714-893-2570
1
P R O D U C T D ATA B O O K 1 9 9 6 / 1 9 9 7
LX5213
9-LINE LOW CAPACITANCE, µP OWER SCSI TERMINATOR
P
R O D U C T I O N
A B S O L U T E M A X I M U M R AT I N G S
D
A T A
S
H E E T
PA CKA GE PIN OUTS
(Note 1)
TermPwr Voltage ................................................................................................. +7V
Signal Line Voltage ................................................................................... 0V to +7V
Regulator Output Current ................................................................................... 0.4A
Operating Junction Temperature
Plastic (N, PWP, DP Packages) .................................................................... 150°C
Storage Temperature Range .............................................................. -65°C to 150°C
Lead Temperature (Soldering, 10 seconds) .................................................... 300°C
T7
T8
T9
N.C.
GND
DISCONNECT
T1
T2
Note 1. Exceeding these ratings could cause damage to the device. All voltages are with
respect to Ground. Currents are positive into, negative out of the specified
terminal.
T H E R MAL DATA
N PACKAGE:
THERMAL RESISTANCE-JUNCTION TO AMBIENT, θ JA
65°C/W
PWP PACKAGE:
THERMAL RESISTANCE-JUNCTION TO LEADS, θJL
27°C/W
THERMAL RESISTANCE-JUNCTION TO AMBIENT, θ JA
60°C/W
DP PACKAGE:
THERMAL RESISTANCE-JUNCTION TO LEADS, θJL
20°C/W
THERMAL RESISTANCE-JUNCTION TO AMBIENT, θ JA
45°C/W
Disconnect
L
H
Open
2
Outputs
Enabled
HI Z
HI Z
Quiescent
Current
600µA
60µA
60µA
15
3
14
4
13
5
12
6
11
7
10
8
9
N PACKAGE
(Top View)
T7
T8
T9
N.C.
GND
HEATSINK/GND
HEATSINK/GND
HEATSINK/GND
HEATSINK/GND
DISCONNECT
T1
T2
1
24
2
23
3
22
4
21
5
20
6
19
7
18
8
17
9
16
10
15
11
14
12
13
T6
T5
REG OUT
N.C.
HEATSINK/GND
HEATSINK/GND
HEATSINK/GND
HEATSINK/GND
N.C.
VTERM
T4
T3
PWP PACKAGE
(Top View)
Junction Temperature Calculation: TJ = TA + (PD x θJA).
The θ JA numbers are guidelines for the thermal performance of the device/pc-board
system. All of the above assume no ambient airflow.
POWER UP / POWER DOWN FUNCTION T ABLE
16
2
T6
T5
REG OUT
N.C.
N.C.
VTERM
T4
T3
1
T7
T8
T9
HEATSINK/GND
GND
DISCONNECT
T1
T2
16
2
15
3
14
4
13
5
12
6
11
7
10
8
9
T6
T5
REG OUT
HEATSINK/GND
HEATSINK/GND
VTERM
T4
T3
DP PACKAGE
(Top View)
Copyright © 1997
Rev. 1.9 7/97
P R O D U C T D ATA B O O K 1 9 9 6 / 1 9 9 7
LX5213
9-LINE LOW CAPACITANCE, µP OWER SCSI TERMINATOR
P
R O D U C T I O N
D
A T A
S
H E E T
R E C O M M E N D E D O P E R AT I N G C O N D I T I O N S
Parameter
Symbol
TermPwr Voltage
Signal Line Voltage
Disconnect Input Voltage
Output Capacitor on REGOUT
Operating Virtual Junction Temperature Range
LX5213C
(Note 2)
Recommended Operating Conditions
Min.
Typ.
Max.
VTERM
Units
4
0
0
2.2
5.25
5
VTERM
V
V
V
µF
0
125
°C
Note 2. Range over which the device is functional.
ELECTRICAL CHARACTERISTICS
(Unless otherwise specified, these specifications apply over the operating ambient temperature range of 0°C ≤ T A ≤ 70°C. TermPwr = 4.75V, Disconnect = 0V. Low duty cycle pulse testing techniques are used which maintains junction and case temperatures equal to the ambient temperature.)
Parameter
Symbol
Test Conditions
Min.
LX5213
Typ.
Max.
Units
Supply Current Section
TermPwr Supply Current
Power Down Mode
All term lines = Open
All term lines = 0.5V
Disconnect = Open
0.6
194
60
1.2
208
100
mA
mA
µA
110
110
2.9
-21.8
-21.8
-21.8
-21.8
10
3.5
30
116
120
Ω
Ω
V
mA
mA
mA
mA
nA
pF
mA
Output Section (Terminator Lines)
Terminator Impedance
Terminator Output High Voltage
Max. Output Current
Output Leakage
Output Capacitance
Sink Current
ITERM = -5mA to -15mA, TA = 25°C
ITERM = -5mA to -15mA
VOUT = 0.5V, T A = 25°C
VOUT = 0.5V, 0°C ≤ TA ≤ 70°C
VOUT = 0.5V, V TERM = 4V, TA = 25°C
VOUT = 0.5V, V TERM = 4V, 0°C ≤ TA ≤ 70°C
Disconnect = Open, VTERM = 0V to 5.25V
Disconnect = Open
VOUT = 4V
104
100
2.7
-20.3
-19.0
-19.5
-18.0
20
-23
-23
-23
-23
400
Regulator Section
Regulator Output Voltage
Line Regulation
Load Regulation
Drop Out Voltage
Short Circuit Current
Thermal Shutdown
3.6
10
20
0.7
-200
150
VTERM = 4V to 6V
I REG = 0 to -50mA
IREG = -50mA
VREG = 0V
20
50
1.0
-350
V
mV
mV
V
mA
°C
2.0
40
V
µA
Disconnect Section
Disconnect Threshold
Input Current
Copyright © 1997
Rev. 1.9 7/97
0.8
Disconnect = 0V
3
P R O D U C T D ATA B O O K 1 9 9 6 / 1 9 9 7
LX5213
9-LINE LOW CAPACITANCE, µP OWER SCSI TERMINATOR
P
R O D U C T I O N
D
A T A
S
H E E T
BLOCK DIAGRAM
FIGURE 1 — LX5213 BLOCK DIAGRAM
REG OUT
VTERM
VTERM
Channel
1 of 9
DISCONNECT
VBG
T0
VTERM
T8
A P P L I C AT I O N S C H E M AT I C
FIGURE 2 — 8-BIT SCSI SYSTEM APPLICATION
TERM POWER
DB (0)
DB (1)
DB (0)
DB (1)
2.2µF
DB (6)
DB (7)
DB (P)
DB (6)
DB (7)
DB (P)
REGOUT
2.2µF
TERMPWR
TERMPWR
ACK
RST
MSG
VTERM
SCSI CABLE
ATN
BSY
LX5213
REGOUT
DISCONNECT
~ ~
ATN
BSY
~ ~ ~
DISCONNECT
VTERM
2.2µF
2.2µF
LX5213
LX5213
REGOUT
5V
DISCONNECT
VTERM
VTERM
~ ~
2.2µF
PERIPHERAL
~ ~ ~
DISCONNECT
HOST
TERM POWER
5V
LX5213
ACK
RST
MSG
REGOUT
2.2µF
Note: Add third LX5213 for 16-bit SCSI
PRODUCTION DATA - Information contained in this document is proprietary to Lin Finity, and is current as of publication date. This document
may not be modified in any way without the express written consent of LinFinity. Product processing does not necessarily include testing of
all parameters. Linfinity reserves the right to change the configuration and performance of the product and to discontinue product at any time.
4
Copyright © 1997
Rev. 1.9 7/97