Low Profile 10 Base-T Interface Module EPE6125GD PCA Part Number(s) Electrical Specifications @ 25 °C Parameter Frequency Specification XMIT RCV Unit 17 ± 1 17 ± 1 MHz Insertion Loss (See Note 1) 1-10 MHz 1.0 1.0 Attenuation (See Note 1) 20 MHz 7.0 5.0 dB Max. dB Min. 25 MHz 18.0 11.0 dB Min. 30 MHz 30.0 18.0 dB Min. 40 MHz 35.0 26.0 dB Min. 15.0 15.0 dB Min. 30.0 30.0 dB Min. Cut-off Frequency Low pass filers @ 3 dB cut-off point Filter Only Isolation (for 1 minute) Vrms 1500 (Pins 4,7 to 8,9 & 1,3 to 13,14) Return Loss 5-10 MHz Commom Mode Rejection 30-100 MHz Crosstalk (See Note 2) 1-10 MHz 30.0 Between Channels Hipot (for 1 minute) 200 (Pins 4 to 3) Impedance Ratio Filter Only (See Note 3) dB Min. Vrms 100 Ω 100 Notes : 1. References to filter output @ 5.0 MHz. Filter only; excludes all resistor networks. 2. Transmitter to Receiver Characteristics. 3. Low Pass Filters : Xmit = 7 Pole, Rcv = 5 Poles Schematic Package X'MIT 68.1Ω 7 .640 .085 1:1 243Ω 6 8 680Ω PCA EPE6125GD Date Code 100 Ω LPF 9 5 Suggested Solder Pad Layout .530 Max. .700 68.1Ω 4 10 243Ω CHIP SIDE MEDIA SIDE RCV 12 3 1:1 49.9Ω LPF 2 White Dot Pin 1 .100 .04 .094 Max. .088 Min. .800 Max. .780 Min. .04 Typ. .03 13 100 Ω .100 .670 14 49.9Ω Leads : .018 x .010 1 DSE6125GD 12/7/94 Unless Otherwise Noted Dimensions in Inches Tolerances: Fractional = ± 1/32 .XX = ± .030 .XXX = ± .010 QAF-CSO7 8/10/94 ELECTRONICS INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 TEL: (818) 892-0761 FAX: (818) 894-5791