POMONA 73037

Model 73037
MMCX JACK STRAIGHT SEMI-RIGID, RG405
Model 73037 MMCX JACK STRAIGHT SEMI-RIGID, RG405
Snap-on coupling and microminiature size for fast connect
and disconnect where space is
limited
Features
•
DC - 6 GHz bandwidth.
•
50% smaller than MCX connectors.
•
Connectors allow rotation of 360˚ for layout
flexibility.
•
Non-slotted contact design for low RF leakage.
•
Meets CECC 22340.
•
Perfect for applications where space, weight,
performance and ease of assembly are required.
Materials
•
•
•
•
Body is machined brass with gold plating.
Center contacts – Plug is gold plated Phosphor
bronze and Jack is gold plated beryllium copper.
High quality PTFE insulators.
Crimp Ferrules are gold or nickel plated copper.
USA: Sales: 800-490-2361
Technical Support: [email protected]
Fax: 425-446-5844
Europe: 31-(0) 40 2675 150
International: 425-446-5500
Where to Buy: www.pomonaelectronics.com
Specifications
Impedance
50 Ω
Frequency Range
DC - 6 GHz
Working Voltage
170 Vrms max.
Dielectric Withstanding
Voltage
500 Vrms
VSWR
1.3 max.
Center / Outer contact
resistance
0.01 / 0.005 Ω
Number of insertions
500 cycles minimum
Insulation resistance
> 500 MΩ
Temperature Range
-55˚ C to 155˚ C, -67˚
F to 311˚ F
Ordering Information
Model: 73037
Description: MMCX JACK STRAIGHT SEMI-RIGID,
RG405
All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (.51 mm),
.xxx = ± .005” (.127 mm). All specifications are to the latest revisions.
Specifications are subject to change without notice. Registered trademarks
are the property of their respective companies.
D2003466 REV 001
Copyright © 2007 12/18/2008
Page 1 of 2
Model 73037
MMCX JACK STRAIGHT SEMI-RIGID, RG405
Cable Types and Crimp Die Information
Connector
Model #
Cable Groups
73037
RG405
Crimp Die
Cavity Size for
Outer Ferrule
.151 (3.8)
.
Cable Assembly Instructions
USA: Sales: 800-490-2361
Technical Support: [email protected]
Fax: 425-446-5844
Europe: 31-(0) 40 2675 150
International: 425-446-5500
Where to Buy: www.pomonaelectronics.com
All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (.51 mm),
.xxx = ± .005” (.127 mm). All specifications are to the latest revisions.
Specifications are subject to change without notice. Registered trademarks
are the property of their respective companies.
D2003466 REV 001
Copyright © 2007 12/18/2008
Page 2 of 2