AND5YA Ultra Bright LED Lamps: Type 2 Weight: 2.0 mg Unit: mm AND5YA Cathode Index 3.2±0.2 ø1.8±0.1 2.2±0.1 R0.9±0.1 InGaAlP Ultra Bright Yellow Light Emission Surface Mount Package Features • RoHS Compliant • Small package size with dome lens • 3.2 (l) x 2.4 (w) x 2.6 (h) size • Suitable for REFLOW soldering • Recommended Forward Current: 10 mA 0.5±0.1 0.5±0.1 2.4±0.1 2.5±0.2 2.0 Maximum Ratings (Ta = 25°C) Polarity Characteristics Symbol Rating Unit Forward Current IF 25 mA Reverse Voltage VR 5 V Power Dissipation PD 100 mW Operating Temperature Range TOpr -40 to 85 °C Storage Temperature Range TStg -40 to 90 °C Electro-Optical Characteristics (Ta = 25°C) Characteristics Symbol Test Condition Minimum Typical Maximum Unit Forward Voltage VF IF = 20 mA – 2.1 2.4 V Reverse Current IR VR = 5 V – – 25 µA Luminous Intensity IV IF = 20 mA 395 625 – mcd Peak Emission Wavelength lP IF = 20 mA – 591 – nm Spectral Line Half Width ∆λ IF = 20 mA – 15 – nm Dominant Wavelength λd IF = 20 mA – 589 – nm Full Viewing Angle θ IV = 1/2 Peak – 30 – degree Precaution Please be careful of the following: 1. Manual soldering: maximum temperature of iron tip: 260°C max. Soldering time: within 5 sec. per solder-land Soldering portion of lead: up to 1.6 mm from the body of the device 2. Reflow solder: recommended condition is as follows: 140 - 160°C The following soldering patterns are recommended for reflow soldering 230°C max. more than 2 min. Time Reflow 4°C/sec. max. 2.5 Temperature 10 sec. max. Product specifications contained herein may be changed without prior notice. It is therefore advisable to contact Purdy Electronics before proceeding with the design of equipment incorporating this 2.5 2.0 2.5 Purdy Electronics Corporation • 720 Palomar Avenue • Sunnyvale, CA 94085 Tel: 408.523.8200 • Fax: 408.733.1287 • [email protected] • www.purdyelectronics.com 7/18/07 AND5YA InGaAlP Ultra Bright Yellow Light Emission Ultra Bright LED Lamps: Type 2 IV – IF IF – VF 1000 10 5 3 1 1.6 Ta = 25°C 500 Ta = 25°C 30 Luminous Intensity IV (mcd) Forward Current IF (mA) 50 300 100 50 30 10 1.7 1.8 1.9 2.0 2.1 2.2 2.3 1 3 Forward Voltage VF (V) IV – TC 10 30 50 100 Relative Luminous Intensity – Wavelength 3 1.0 Relative Luminous Intensity Relative Luminous Intensity 5 Forward Current IF (mA) 1 0.5 0.3 0.1 -20 0 20 40 60 IF = 20 mA Ta = 25°C 0.8 0.6 0.4 0.2 0 540 80 560 580 600 620 640 660 Wavelength λ (nm) Case Temperature TC (°C) Radiation Pattern IF – Ta 20° 10° 0° 10° Ta = 25°C 20° 30° 30° 40° 40° 50° 50° 60° 60° 70° 70° 80° 80° Allowable Forward Current IF (mA) 40 30 20 10 90° 90° 0 0.2 0.4 0.6 0.8 0 0 20 40 60 80 Ambient Temperature Ta (°C) Purdy Electronics Corporation • 720 Palomar Avenue • Sunnyvale, CA 94085 Tel: 408.523.8200 • Fax: 408.733.1287 • [email protected] • www.purdyelectronics.com 100 7/18/07