LXMG221W-0700034-D0 LXMG2203 34W 700mA Dimmable LED Driver Module ® TM P RODUCTION D ATASHEET • DESCRIPTION To reduce audible noise the internal switching frequency remains above 30kHz. Safety features include open output circuit protection, whole string short circuit protection. The maximum allowable hot spot case temperature is 90°C (above this temperature the module will be thermally self-protected). The recommended operating ambient temperature range is -30°C to 70°C, as long as the maximum case temperature is not exceeded. The compact enclosure is rated to IP66, meets UL8750 and UL1310 class 2, CE pending. • High Efficiency (90%) • Active Power Factor Correction (Typical 0.99 at 120VAC) • Universal AC Input 100~277VAC • Constant Current 700mA Typical Output • Anode Supply Adjusts for String Voltage between 14V and 48V • Dimming Input Provides 10% to 100% Range, Plus Shutdown • Small Compact Size With a Hole in the Middle for Easier Mounting and Wiring • Fully Isolated Plastic Case (IP66) • Long Life Expectancy • Full Protection: OVP, SCP, OTP, Maximum Power Limit • Complies with UL8750 & UL1310 (File E337545) • FCC Class B & CE Pending • RoHS Compliant WWW . Microsemi .C OM The LXMG221W-0700034-D0 is a fully enclosed compact solid-state LED lighting driver module. It operates from a universal AC input supply in the range of 100VAC to 277VAC, 50/60Hz to drive a string of LEDs with active power factor correction. LED string voltage can range from 14V to 48V at a constant current of 700mA to drive a wide variety of LED lamp string requirements. Control terminal leads include a dimming input BRITE_A with a dedicated RETURN lead. The amplitude of the output LED string current will vary from 10% to 100% corresponding to a 1VDC to 10VDC signal on the BRITE_A input following the 0V to 10V ESTA E1.3-2001 Analog Control Specification Standard. The BRITE_A terminal when pulled down below minimum dimming will turn off the LEDs and enter a low power consumption mode. KEY FEATURES • APPLICATIONS Worldwide Residential and Commercial LED Lighting Fixtures such as: • LED Down Lights • LED Street Lights IMPORTANT: For the most current data, consult MICROSEMI’s website: http://www.microsemi.com Patents Pending PRODUCT HIGHLIGHT LXMG221W-0700034-D0 ORDER INFORMATION Part Number Input Voltage Output Current LXMG221W-0700034-D0 100VAC to 277VAC 50/60Hz 700mA Dimmable Current Source 14V to 48V Anode Voltage Copyright © 2010 Rev. 1.1a, 2011-08-01 Microsemi Analog Mixed Signal Group 11861 Western Avenue, Garden Grove, CA. 92841, 800-877-6458, 714-898-8121, Fax: 714-893-2570 Page 1 LXMG221W-0700034-D0 LXMG2203 34W 700mA Dimmable LED Driver Module ® TM P RODUCTION D ATASHEET ABSOLUTE MAXIMUM RATINGS Input Frequency (VIN) .............................................................................................................................................. 47 to 63Hz Input Power ....................................................................................................................................................................... 40W Output LED String Current ............................................................................................................. 800mA (Internally Limited) Output String Voltage .......................................................................................................................... 52V (Internally Limited) Output Power ...................................................................................................................................... 38W (Internally Limited) Input Signal Voltage (BRITE_A Input) ................................................................................................................... -0.3V to 52V Cold Start Temperature....................................................................................................................................................-30°C Hot Spot Case Temperature, zero airflow ......................................................................................................................... 90°C Storage Temperature Range ..............................................................................................................................-40°C to 85°C Note: Exceeding these ratings could cause damage to the device. All voltages are with respect to Ground. Currents are positive into, negative out of specified terminal. WWW . Microsemi .C OM Input Voltage (VIN) ......................................................................................................................................... 90 VAC to 305VAC RECOMMENDED OPERATING CONDITIONS (R.C.) This module has been designed to operate over a wide range of input and output conditions. However, best efficiency and performance will be obtained if the module is operated under the condition listed in the ‘R.C.’ column. Min. and Max. columns indicate values beyond which the inverter, although operational, might not function optimally. Parameter Max Units 100 277 VAC VBRITE_A 0 10 V VBRITE_PWM 0.2 10 kHz VBRITE_PWM 10 52 V VBRITE_PWM 0.2 25 kHz VBRITE_DC 9.5 100 % LED String Voltage VLED 14 48 V OUT(-) Sink Current OUT-ISINK Input Supply Voltage Range Linear BRITE_A Control Input Voltage Range Linear BRITE_A Control PWM Frequency Range (Open Collector) Linear BRITE_A Control PWM Amplitude Range (Totem Pole) Linear BRITE_A Control PWM Frequency Range (Totem Pole) Linear BRITE_A Control PWM Duty Cycle Range Maximum Allowable Case Temperature Cold Start Temperature Symbol Min VIN R.C. 700 mA TC TCOLD 90 °C -30 °C ELECTRICAL CHARACTERISTICS Parameter Symbol Input Voltage VIN Off Power PIN(MIN) Input AC Current Maximum Inrush Current Copyright © 2010 Rev. 1.1a, 2011-08-01 Test Conditions / Comment Line Frequency 47 to 63 Hz Min Typ 90 Max Units 305 VAC BRITE_A ≤ 0.5V, VIN = 120VAC 0.3 W I120 Measured at Full Load and 120VAC Input 0.31 A I277 Measured at Full Load and 277VAC Input 0.14 A IINRUSH Measure at 277VAC Peak AC Line; Maximum Duration 10μs Measure at 277VAC Peak AC Line Measured after 10μs Microsemi Analog Mixed Signal Group 11861 Western Avenue, Garden Grove, CA. 92841, 800-877-6458, 714-898-8121, Fax: 714-893-2570 60 A 5 A Page 2 LXMG221W-0700034-D0 Unless otherwise specified, the following specifications apply over the recommended operating condition except where otherwise noted; VIN = 90 VAC to 305VAC; BRITE_A = 8kΩ to RETURN; Full Load condition is 48V/700mA unless otherwise noted LXMG221W-0700034-D0 LXMG2203 34W 700mA Dimmable LED Driver Module ® TM P RODUCTION D ATASHEET ELECTRICAL CHARACTERISTICS Parameter Symbol Power Factor Test Conditions / Comment Min Full Load, 100VAC to 277VAC 0.9 Peak Efficiency η Full Load, VLED = 48V Efficiency η Full Load, VLED = 48V, VIN = 120VAC Total Harmonic Distortion Typ 88 THD Full load, 100VAC to 277VAC Average Sink Current IOUT- TA = 25°C 665 LED String Voltage VLED Rated LED current 14 Max Units PF 90 % 89 % 10 % 735 mA 48 V OUTPUTS 700 Ripple (pk-pk) IOUT-RIPPLE Full Load, VLED = 48V, (pk to pk)/Average 20 % Line Regulation IOUT-LINE VIN = Nominal ± 10% (i.e. 120VAC ± 10%) 1 % Load Regulation IOUT-LOAD OUT(+) 14V to 48V 1 4 % Turn-on Time DELAY Cold Start, Power ON 1 Output Overshoot / Undershoot IOUTSHOOT WWW . Microsemi .C OM Unless otherwise specified, the following specifications apply over the recommended operating condition except where otherwise noted; VIN = 90 VAC to 305VAC; BRITE_A = 8kΩ to RETURN; Full Load condition is 48V/700mA unless otherwise noted Sec Turning Power On or Off 10 % Dimming BRITE_A Voltage for Full Bright BRITE_A Potentiometer Value at Full Bright BRITE_A Voltage for Full Dim VBRITE_A_MAX POT VBRITE_A_MIN Minimum Output Current IMIN Output Current Dim Range (Analog Dimming) Shutdown Voltage BRITE_A to RETURN BRITE_A = 0.95V 9.5 10 10.5 V 8 10 12 kΩ 0.95 1 1.05 V 8 10 12 % of Max ILED = 700mA, BRITE_A = 0.95V Versus BRITE_A ≥ 10V 10 VBRITE_SD RATIO 0.6 V 52 V Protection Overvoltage Protection VOV Maximum OUT(+) Over Temperature Shutdown TOT Over Case Temperature Protection Hot Spot 95 °C UL / CE LXMG221W-0700034-D0 Safety & EMC Compliance Compliance to UL8750 & UL1310 Class 2 File E337545 EN 61347-1, EN61347-2-13 Pending FCC Title 47, Part 15 Conducted and Radiated Emission, Class B EN 55015 Conducted emission EN 61000-3-2 Harmonic current emissions EN 61000-3-3 Voltage fluctuations and flicker Copyright © 2010 Rev. 1.1a, 2011-08-01 Microsemi Analog Mixed Signal Group 11861 Western Avenue, Garden Grove, CA. 92841, 800-877-6458, 714-898-8121, Fax: 714-893-2570 Page 3 LXMG221W-0700034-D0 LXMG2203 ® TM 34W 700mA Dimmable LED Driver Module P RODUCTION D ATASHEET Safety & EMC Compliance EN 61547 Pending Life Expectancy WWW . Microsemi .C OM Specification for equipment for general lighting purposes. EMC immunity requirements Standard Test Items EN61000-4-2 Electrostatic Discharge Immunity EN61000-4-3 Radiated Susceptibility test EN61000-4-4 Electrical Fast Transient EN61000-4-5 Surge Immunity Test, AC Power Line, Line to Line 2kV, Line to Earth 4 kV EN61000-4-6 Conducted Susceptibility Immunity test EN61000-4-8 Power Frequency Magnetic Field Immunity Test EN61000-4-11 Voltage Dips and Interruption Immunity 5 years / 50,000 hours @ 100% duty at maximum case temperature 55°C Environmental Standards EU RoHS, REACH \ LEAD DESCRIPTION Name Pin # Description INPUT TERMINAL LEADS (18AWG) BROWN AC L Main Input Power Supply Line 100VAC to 277VAC BLUE AC N Main Input Power Supply Neutral CONTROL TERMINAL LEADS (22AWG) PURPLE BRITE_A Analog Dimming Input (Full Brightness if Open) GRAY RETURN Dimming Return OUTPUT TERMINAL LEADS (18AWG) RED OUT(+) LED String Anode Voltage (High Side) YELLOW OUT(-) OUT(-) LED Cathode Voltage (Low Side) 700mA OPERATING STATES DRIVER STATUS OUT(+) String OUT(-) (700mA) YES ON OUT(+) OPEN OUT(-) NO OUT(+) Max Voltage OUT(+) Short OUT(-) OUT(+) String OUT(-) w/ 1 or more LED short Over Temperature at the Case Hot Spot NO SHUTDOWN YES ON NO SHUTDOWN Power Loss (Blackout) Event NO SHUTDOWN NO SHUTDOWN YES ON BRITE_A SHORTED TO RETURN or OUT(-) BRITE_A OPEN (or Resistor > 12kOhm) Copyright © 2010 Rev. 1.1a, 2011-08-01 COMMENT STAYLIT™, OUT(+) ≥ 14V When the temperature goes down, the module turns on again (no user intervention) When Power comes back, the module turns on again (no user intervention) Microsemi Analog Mixed Signal Group 11861 Western Avenue, Garden Grove, CA. 92841, 800-877-6458, 714-898-8121, Fax: 714-893-2570 Page 4 LXMG221W-0700034-D0 LED ON CONDITION LXMG221W-0700034-D0 LXMG2203 ® TM 34W 700mA Dimmable LED Driver Module P RODUCTION D ATASHEET MECHANICAL DRAWING 78.0 WWW . Microsemi .C OM 60.0 Ø 12.7 80.0 70.0 26.0 5.0 Wire length is 160mm ± 5mm, stripped 12mm ± 2mm UL1015 AWG#18 16/30 stranded 105°C Input & Output wires; AWG#22 7/30 stranded Control wires, all wires tinned. Please insure the wire nuts are installed correctly to prevent intermittent operation. Connecting the AC input to Control or Output wires will result in damage to the module. Hole in center, mounting tab slot width 4mm. LXMG221W-0700034-D0 Copyright © 2010 Rev. 1.1a, 2011-08-01 Microsemi Analog Mixed Signal Group 11861 Western Avenue, Garden Grove, CA. 92841, 800-877-6458, 714-898-8121, Fax: 714-893-2570 Page 5 LXMG221W-0700034-D0 LXMG2203 ® TM 34W 700mA Dimmable LED Driver Module P RODUCTION D ATASHEET APPLICATION INFORMATION WWW . Microsemi .C OM OUT(+) NEUTRAL 700mA 100VAC to 277VAC LXMG221W0700034-D0 OUT(-) RETURN 1V to 10V or <0.6V OFF LINE 10k BRITE_A LXMG221W-0700034-D0 Copyright © 2010 Rev. 1.1a, 2011-08-01 Microsemi Analog Mixed Signal Group 11861 Western Avenue, Garden Grove, CA. 92841, 800-877-6458, 714-898-8121, Fax: 714-893-2570 Page 6 LXMG221W-0700034-D0 LXMG2203 TM ® 34W 700mA Dimmable LED Driver Module P RODUCTION D ATASHEET NOTES WWW . Microsemi .C OM LXMG221W-0700034-D0 PRODUCTION DATA – Information contained in this document is proprietary to Microsemi and is current as of publication date. This document may not be modified in any way without the express written consent of Microsemi. Product processing does not necessarily include testing of all parameters. Microsemi reserves the right to change the configuration and performance of the product and to discontinue product at any time. Copyright © 2010 Rev. 1.1a, 2011-08-01 Microsemi Analog Mixed Signal Group 11861 Western Avenue, Garden Grove, CA. 92841, 800-877-6458, 714-898-8121, Fax: 714-893-2570 Page 7