T TRUMPower TA2S Series DC/DC CONVERTERS SMD, 2:1 Input, 5-6 Watt *MODEL NUMBER OUTPUT VOLTAGE OUTPUT CURRENT OUTPUT POWER 9-18 VDC IN 18-36 VDC IN 36-75 VDC IN 3.3 VDC 5 VDC 12 VDC 15 VDC 1000 1000 470 400 mA mA mA mA 3.3W 5W 5.6W 6W TA2S-3S123.3 TA2S-5S1205 TA2S-6S1212 TA2S-6S1215 TA2S-3S243.3 TA2S-5S2405 TA2S-6S2412 TA2S-6S2415 TA2S-3S483.3 TA2S-5S4805 TA2S-6S4812 TA2S-6S4815 ±5 VDC ±12 VDC ±15 VDC ±500 mA ±230 mA ±190 mA 5W 5.5W 5.7W TA2S-5D1205 TA2S-6D1212 TA2S-6D1215 TA2S-5D2405 TA2S-6D2412 TA2S-6D2415 TA2S-5D4805 TA2S-6D4812 TA2S-6D4815 For 1.5K VDC isolation, add suffix "C" to the model number. Add sufffix "T" for remote on/off control. ELECTRICAL SPECIFICATIONS INPUT SPECIFICATIONS Input Voltage....................................................See Table Nominal Input...........................................12, 24, 48 VDC Input Filter.......................................................Pi Network PIN CONNECTIONS for 500V ISOLATION PIN # FUNCTION SINGLE DUAL +V Input 1, 24 1, 24 -V Input 12, 13 12, 13 +V Output 11, 14 11, 14 Common 10, 15 -V Output 10, 15 2, 23 2, 3, 4, 5, 9, 16, 4, 5, 9, 16, 20, No Connection 20, 21, 22, 23 21 OUTPUT SPECIFICATIONS Voltage Accuracy.............................................±2%, Max. Line Regulation.............................................±0.5%, Max. Load Regulation, Single Output, 10%FL-FL...±0.5%, Max. Dual Output, 1/4FL-FL..........±1%, Max. Minimum Load.................................10% on Each Output Ripple and Noise, 20MHz BW, 3.3V/5V..100 mVp-p, Max. 12V/15V.......1% p-p Max. Short Circuit Protection..................................Continuous Temperature Coefficient..........................±0.02%/C, Max. PIN CONNECTIONS for 1.5KV ISOLATION PIN # FUNCTION SINGLE DUAL +V Input 22, 23 22, 23 -V Input 2, 3 2, 3 +V Output 14 14 Common 9, 16 -V Output 16 11 1, 4, *5, 9, 10, 1, 4, *5, 10, 12, No Connection 11, 12, 13, 15, 13, 15, 20, 21, 20, 21, 24 24 *Pin #5 is Remote on/off control (suffix "T") or NC. All Specifications Typical @+25°C, Nominal Line, and Full Load Unless Otherwise Noted. GENERAL SPECIFICATIONS Efficiency...........................................................70 - 82% Isolation Voltage, Input to Output..............500 VDC, Min. For 1.5K VDC Isolation, Add Suffix "C" Isolation Resistance.................................109 Ohms, Min. Switching Frequency....................................100 kHz, Min. Operating Temperature, No Derating.......-25°C to +71°C Storage Temperature Range.................-40°C to +125°C Cooling.............................................Free Air Convection Case Material..................................Black Coated Copper with Non-Conductive Base ALL DIMENSIONS IN INCHES (mm) Rev. A -01/2008- Tumbler Technologies + TRUMPower • Santa Clara, CA • 408-988-6616 • [email protected] • www.TRUMPower.com