Data Sheet High Sensitivity 10Gb/s surface mount coplanar APD preamp receiver AT10XGC The AT10XGC receiver consists of an avalanche photodiode, a low-noise preamplifier and a precision NTC thermistor in a hermetic coplanar packagewith a connectorized single-mode fiber pigtail. Differential outputs are provided to improve noise rejection for enhanced sensitivity. It has been optimised for use in 10Gb/s metro or long-haul applications, either as a discrete device or within a transponder, using NRZ modulation, with or without FEC, at data rates up to 10.709Gb/s. Features: • High sensitivity, -28.5dBm typical • Low capacitance high speed InGaAs APD photodetector • Supports FEC rates up to 10.709Gb/s • Best in class power consumption, only 300mW • Designed to exceed the environmental requirements of Telcordia GR-468-CORE • RoHS 5/6 compliant Applications: • Client or line side links • 300 pin LR transponder applications • Yellow fiber pigtail for MSA compliance 1 Data Sheet Operating Characteristics Case Temperature = 25°C unless otherwise specified Parameter Typ Max Unit 231-1 PRBS BER<10-12 Voptimal = VM10 -28.5 -27.0 dBm Sensitivity penalty EOL over temperature [1] [2] 231-1 PRBS BER<10-12 Voptimal = VM10 T=0 to +85°C 0.75 1.0 dB Deviation from linear phase DC - 6GHz -10 +10 ° VAPD=VM10 Small signal 8 Optical sensitivity BOL [1] [2] Symbol Measurement Conditions Sens High frequency -3dB corner fH Low frequency -3dB corner fL Transimpedance gain TZ Small signal VOUT 9 GHz 40 kHz 5.7 kΩ Peak-to-peak 165 mV S22 DC to 6.0GHz -8 dB PSAT 2^23-1 PRBS VAPD=VM3 BER<10-12 -3 APD breakdown voltage Vbr T=25°C IAPD=10mA 20 40 V APD breakdown voltage temperature coefficient TVbr 0.030 0.061 V/°C Dark current Id 100 nA Amplifier bias current Icc 73 mA Input current for output limiting IIn lim Transimpedance amp supply voltage VTZA Thermistor resistance RTH [3] [4] [5] Maximum output voltage Return loss Optical overload [2] [6] [1] [2] [3] [4] [5] [6] 2.3 4.0 -1 At 90% of Vbr 55 Peak-to-peak T=25°C Notes: 2 Min Optical Wavelength between 1525-1575nm. Data to 1610nm available on request. Measured with 9.95Gb/s, extinction ratio > 12dB, Q factor > 30, 50% crossing level, 1550nm. Load impedance is 50Ω AC-coupled. Excludes APD responsivity. Differential. Single ended. dBm 80 uA 3.3 V 10 kΩ Data Sheet Absolute Maximum Ratings The table below provides maximum and/or minimum values of critical parameters which will not permanently damage the device, but for which the operating specification may not hold. Parameter Symbol Min Max Unit Amplifier bias voltage VCC -0.7 5.0 V Top 0 +85 °C Tstg -40 +85 °C 3 mA Vbr V Operating temperature Storage temperature Input photocurrent [1] [2] IPD [3] APD bias voltage VAPD Fiber bend radius 0 20 mm Notes: [1] The operating temperature is defined as the temperature of the module case. [2] The rating is referred to the ambient temperature. [3] VAPD · VM3. Although implementation of a current limit is intuitive, it is not recommended as biasing below the specified M = 3 voltage in the presence of a high optical power has been shown to cause device damage. Class 2 ESD precautions must be observed when handling these devices. Pin Out Pin # Symbol Parameter Pin # Function Parameter 1 GND Case ground 10 Out_P Positive RF data output 2 VAPD APD bias voltage 11 GND Case RF ground 3 NC No connection 12 GND Case ground 4 NC No connection 13 NC No connection 5 NC No connection 14 VCC Amplifier supply (+3.3V) 6 GND Case ground 15 NC No connection 7 GND Case RF ground 16 RTH Thermistor 8 Out_N Negative RF data output 17 GND Case ground 9 GND Case ground Deliverable Data VM3 and Vbr are provided on the fiber tag for each device. 3 Data Sheet Circuit Schematic VAPD RTH 0.9nF 10kOhms @ 25 °C 10nF Out_P Out_N 100nF 0.9nF Vcc Figure [1] AT10XGC Circuit schematic. Outline Drawing Dimensions in mm Figure [2] Outline diagram (Illustration only. For full details, refer to appropriate assembly drawing.) Note: Fiber is 900mm yellow secondary coated single-mode fiber, length = 1100 +0/-200mm. 4 Data Sheet Typical Performance Characteristics Figure [3] Electrical output data eye, M = 10, 10Gb/s 231-1 PRBS, -28dBm optical input. Figure [4] Electrical output data eye, M = 10, 10Gb/s 231-1 PRBS, -24dBm optical input. 5 Data Sheet Typical Performance Characteristics (continued) Figure [5] Typical BER performance, measured with 9.95Gb/s 2^31-1 PRBS, extinction ratio > 12dB, Q factor > 30, 50% crossing level, 1550nm at 25ºC. RoHS Compliance Bookham is fully committed to environment protection and sustainable development and has set in place a comprehensive program for removing polluting and hazardous substances from all of its products. The relevant evidence of RoHS compliance is held as part of our controlled documentation for each of our compliant products. RoHS compliance parts are available to order, please refer to the ordering information section for further details. Ordering Information: AT10XGC - (Connector) J = SC/PC J57 = LC e.g. AT10XGC-J is an AT10XGC with an SC/PC connector. Other options available on request Contact Information North America Bookham Worldwide Headquarters Europe Paignton Office Asia Shenzhen Office 2584 Junction Ave. San Jose CA 95134 USA Brixham Road Paignton Devon TQ4 7BE United Kingdom 2 Phoenix Road Futian Free Trade Zone Shenzhen 518038 China • Tel: +1 408 919 1500 • Tel: +44 (0) 1803 66 2000 • Fax: +1 408 919 6083 • Fax: +44 (0) 1803 66 2801 • Fax: +86 755 33305805 +86 755 33305807 • Tel: +86 755 33305888 Important Notice Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by Bookham before they become applicable to any particular order or contract. In accordance with the Bookham policy of continuous improvement specifications may change without notice. The publication of information in this data sheet does not imply freedom from patent or other protective rights of Bookham or others. Further details are available from any Bookham sales representative. www.bookham.com [email protected] 6 ISO14001:1996 EMS 504193 TL9000 Rev 3.0 (ISO9001:2000) FM15040 BH12852 Rev 2.0 January 2007. ©Bookham 2006. Bookham is a registered trademark of Bookham Inc.