Series 252 ® Two Axis, Ministick Controller With Optional Momentary Switch Features • Compact Size (20x21x13mm) • Long Life 1 Million Cycles • Optional momentary switch is operational at all rotations • Sturdy metal case with convenient mounting tabs • RoHS compliant Pat. No: US 6,353,430 , Taiwan: 128688. Pat. Pending in Japan & China Electrical and Mechanical Specifications Potentiometer 1 & 2 Available Switch Resistance Range 10 K ohms through 200 K ohms Type Momentary Resistance Tolerance Standard: ±30% Special: ±10% and ± 20% available Contact Resistance 100 milliohms max Insulation Resistance 100 Megaohms min @ 250 VDC Maximum Contact Resistance 200 milliohms max after 500,000 cycles switching 5mA @ 5VDC Rotational Torque of Stick 200 ± 80 gf.cm at 10° deflection Dielectric Strength 250 VAC 50/60 Hz for 1 minute Power Rating 0.0125 watt @ 50°C, Derated to no load at 85°C Operating Voltage 50 VAC or 5 VDC maximum Power Rating 12 VDC, 50 mA maximum Travel 0.9 ± 0.4mm Angle of Rotation 60° maximum Life Standard: 1,000,000 cycles Special: Consult CTS RoHS Compliance Compliant with European Union RoHS Directive 1-2 CTS Electronic Components Insulation Resistance 100 Megaohms min @ 100 VDC Operational Force 800±200 g Switch Life 500,000 cycles © 2006 CTS Corporation. All rights reserved. Information subject to change. 6/20/06 www.ctscorp.com Electrical and Mechanical Specifications Potentiometer 1 & 2 Operating Temperature Soldering Conditions Wave - up to 5 seconds at 260°C No Solder or flux on component side of board OPERATION ANGLE 53°~63° (ALL DIRECTION) b d 1 2 3 CENT. 5.00 .197 CENT. 13.30 .524 1.20±0.05 .047±.002 Ø1.0+0.1 -0.0 (4) HOLES FOR .039+.004 OPTIONAL SWITCH -.000 TERMINALS 3.00 .118 c a d b 1 1.1(4) .043 0.8±0.1(6) .031±.004 1.90±0.05 .075±.002 SWITCH CIRCUIT DIAGRAM 9.3 .366 SECTION A-A SCALE : 10X 11.2 .441 CENT. 16.0 .630 CENT. 12.0 .472 MOUNTING HOLE DETAIL VIEWED FROM MOUNTING SIDE 2 3 11.2 .441 VR 1 a 3.3±0.3 .130±.012 c A 7.3 .287 Ø1.3+0.1 -0.0 (4) .051 +.004 +0.1 -.000 Ø1.0-0.0 (6) .039 +.004 -.000 1 2 3 CENT. 5.00 .197 1.90 15.50 CENT. .075 .610 6.50 CENT. .256 CENT. 4.50 .177 +0.4 DIM "L" -0.3 .760 +.016 -.012 12.2±0.3 .480±.012 A 11.8 .465 9.5 .374 CTS Series 252 3.8±0.3 .150±.012 Mounting Information PC Terminals CENT. 16.0 .630 -10°C to +70°C VR 2 CENT. 9.5 .374 mm DIMENSION: inch Ordering Information 252 A 103 C 60 N A RESIST TOL DRIVE ARM LENGTH DIM "L" LENGTH FROM MOUNTING SURFACE A – 19.3mm B – 24.3mm 2-2 CTS Electronic Components RESISTANCE CODE EXAMPLES CODE 103 203 503 104 124 154 RESISTANCE 10K 20K 50K 100K 120K 150K A – ±10% B – ±20% C – ±30% TAP CONFIGURATION N – NO TAP T – 4° TAP AT CENTER ROTATIONAL ANGLE 40 – 40º 50 – 50º 60 – 60º © 2006 CTS Corporation. All rights reserved. Information subject to change. SWITCH CONFIGURATION A – W/O SWITCH B – MOMENTARY SWITCH 6/20/06 www.ctscorp.com