MODEL NUMBER CAMH9126 L-Band Power Amplifier FEATURES • L-Band Op. Freq. • 52 dB Gain • 61 dBm Pout • 45% Efficiency AMP A A .250-.252 DIA. x.40 MIN DEEP INCLUDING SUPPORT FLANGE .250-.252 x .38 SLOT .40 MIN DEEP INCLUDING SUPPORT FLANGE. 10.50 MAX .086-56 UNC-2B 3 PLS. 10.38 3x 1.125 2x .650 1.000 4.000 CAUTION BeO CONTAINS BERYLLIUM OXIDE DO NOT ALTER, CUT, OR GRIND 8.000 1.000 7.000 VIEW A-A .75 .12 TOP SIDE J1 Connector 2x 1.000 A3 10.00 RF OUT 2x .50 MADE IN U.S.A. CAMH9126 HIGH POWER AMPLIFIER SN RF IN +41.5V +15V DAICO INDUSTRIES, INC. J3 DC J1 A GND (SHLD) B MODIN + C MODIN D N/C E PABIT + F PABIT G PAOT + H PAOT - 2.00 J2 2x .65 .75 Power Amplifier 2.88 .44 6.40 .60 2.40 10.880 FRONT J N/C K N/C L N/C M GND(SHLD) N N/C P ±15VRT R ±15VRT S +15V T N/C U +41.5VRT V +41.5VRT W +41.5VRT X +41.5V Y +41.5V Z +41.5V G U ARAN TEED PERFO RMA N CE Parameter J3 RF OUT J2 RF IN VSWR N/C = NO CONNECT DAICO Industries +15V X,Y,Z +41.5V P,R U,V,W S +41.5VRT H PAOT - G +15VRT F PABIT - E PAOT + N/C D,J,K L,N,T PABIT + C MODIN - GND B MODIN + A,M 1400 52 61 +10 No Damage SENSOR/LOGIC J1 CONNECTOR Min Typ Max Units Operating Frequency 1215 Gain 50 Peak Power Output 60 RF Power In: Operate +7 In Out Pulse Delay On Puse Delay Off Harmonics II III Impedance Transition (Rise/Fall) Time DC Current Operating Temperature 200 200 30 30 80 -46 1.4:1 1.4:1 435 400 35 38 50 120 5.3 0.45 +25 63 +18 +20 1.5:1 1.5:1 600 600 500 7.5 0.7 +52 MHz dB dBm dBm Conditions PRF 3.57 KHz PW = 15 µSec nSec nSec dBc dBc OHMS µSec AMP At +41.5 VDC AMP At +15 VDC °C TA 310.507.3242 • FAX 310.507.5701 • www.daico.com 29