KMO KVO HIGH VOLTAGE RECTIFIER ASSEMBLIES QUICK DISCONNECT TAB OR TURRET TYPE TERMINALS UNIVERSAL MOUNTING PRV 5,000 TO 15,000 VOLTS AVERAGE CURRENT TO 1 AMP EDI Type No. Peak Reverse Voltage PRV (Volts) Max. Fwd. Volt. 25 o C I F = 500 mA VF (Volt s) Avg . Rec tifi ed Current @ TC =50 o C I O (Am ps) KMO5 or KVO5 5,000 8 1.00 KMO8 or KVO8 8,000 11 1.00 KMO10 or KVO10 10,000 13 0.80 KMO12 or KVO12 12,000 15 0.80 KMO15 or KVO15 15,000 18 0.60 ELECTRICAL CHARACTERISTICS(at TA =25 C Unless Otherwise Specified) Max .Peak One Cycle Surge (8.3 ms) I FSM 50 A Max. DC Reverse Current @ PRV ,I R 1 A 100 A o Max. DC Reverse Current @ PRV and 100 C, IR Operating Temperature Range, TA , (Fig. 1) -55 oC to +150 oC Storage Temperature Range, TSTG -55 oC to +150 oC NOTE: 1. A thin film of silicone thermal compound is recommended between the bottom of the assembly and the mounting surface for improved thermal conduction. 2. Also available in fast recovery version KMOR and KVOR. Contact the factory for further information. KMO KVO FIG.1 FIG.2 OUTPUT CURRENT vs CASE TEMPERATURE NON-REPETITIVE SURGE CURRENT 0.1SEC 1.0SEC 100 75 % MAXIMUM SURGE % RATED FWD CURRENT 100 50 25 0 0 25 50 75 100 125 75 50 25 0 150 1 O CASE TEMPERATURE ( C) 3 2 4 5 6 7 8 9 10 30 20 40 50 60 CYCLES(60 Hz) Heat sink mounting pad temperature=Case temperaure(Tc) FIG.3 CASE OUTLINE ALL DIMENSIONS IN INCHES .032 x .250 TAB TERMINALS TYP. .340 MAX. .250 .750 KMO 3.00 MAX. 2.00 .37 TYP. 1.67 .340 MAX. KVO .372 .745 .388 .775 .165 .50 EDI reserves the right to change these specifications at any time without notice. ELECTRONIC DEVICES, INC. DESIGNERS AND MANUFACTURERS OF SOLID STATE DEVICES SINCE 1951. 21 GRAY OAKS AVENUE * YONKERS. NEW YORK 10710 914-965-4400 * FAX 914-965-5531 Ee-mail:[email protected] * Wwebsite: http://www.ediediodes.com * 1-800-678-0828