Technical Data Sheet Opto Interrupter ITR9608 █ Features ․Fast response time ․High analytic ․Cut-off visible wavelength λp=940nm ․High sensitivity ․Pb free ․The product itself will remain within RoHS compliant version. █ Descriptions The ITR9608 consist of an infrared emitting diode and an NPN silicon phototransistor, encased side-by-side on converging optical axis in a black Thermoplastic Housing The phototransistor receives radiation from the IRED only .This is the normal Situation. But when an object is in between , phototransistor could not receives the radiation. For additional component information , please refer to IR928-6C and PT928-6C █ Applications ․Mouse Copier ․Switch Scanner ․Floppy disk driver ․Non-contact Switching ․For Direct Board █ Device Selection Guide Device No. Chip Material LENS COLOR IR928-6C GaAlAs Water clear PT928-6C Silicon Water clear Everlight Electronics Co., Ltd. Device No：CDRX-096-006 http:\\www.everlight.com Prepared date：08-08-2005 Rev 2 Page: 1 of 6 Prepared by：Denky ITR9608 █ Package Dimensions Notes: 1.All dimensions are in millimeters 2.Tolerances unless dimensions ±0.2mm 3.Lead spacing is measured where the lead emerge from the package 4.Above specification may be changed without notice. EVERLIGHT will reserve authority on material change for above specification 5.These specification sheets include materials protected under copyright of EVERLIGHT corporation . Please don＇t reproduce or cause anyone to reproduce them without EVERLIGHT＇s consent 6.When using this product , please observe the absolute maximum ratings and the instructions for use outlined in these specification sheets. EVERIGHT assumes no responsibility for any damage resulting from use of the product which does not comply with the absolute maximum ratings and the instructions included in these specification sheets. Everlight Electronics Co., Ltd. Device No：CDRX-096-006 http:\\www.everlight.com Prepared date：08-08-2005 Rev 2 Page: 2 of 6 Prepared by：Denky ITR9608 █ Absolute Maximum Ratings (Ta=25℃) Parameter Power Dissipation at(or below) 25℃ Free Symbol Ratings Unit Pd 100 mW Reverse Voltage VR 5 V Forward Current IF 50 mA Peak Forward Current (*1) Pulse width ≦100μs, Duty cycle=1% IFP 1 A Collector Power Dissipation PC 75 mW Collector Current IC 50 mA Collector-Emitter Voltage B VCEO 30 V Emitter-Collector Voltage B VECO 5 Operating Temperature Topr -25~+85 V ℃ Storage Temperature Tstg -40~+85 ℃ Tsol 260 ℃ Air Temperature Input Output Lead Soldering Temperature (*2) (1/16 inch form body for 5 seconds) (＊1) tw=100 μsec. , T=10 msec. (＊2) t=5 Sec █ Electro-Optical Characteristics (Ta=25℃) Parameter Input Min. Typ. Max. Unit Conditions VF1 --- 1.2 1.6 Forward Voltage VF2 --- 1.4 1.85 Reverse Current VF3 IR λP ----- 2.6 --- 4.0 10 μA VR=5V --- 940 --- nm IF=20mA View Angle 2θ1/2 --- 60 --- Deg IF=20mA Dark Current ICEO --- --- 100 nA VCE=20V,Ee=0mW/cm2 C-E Saturation Voltage VCE(sat) --- --- 0.4 V IC=2mA ,Ee=1mW/cm2 Collect Current IC(ON) 0.7 --- --- mA VCE=5V IF=20mA tr --- 15 --- μsec tf --- 15 --- μsec Peak Wavelength Output Symbol Transfer Rise time Characteristics Fall time Everlight Electronics Co., Ltd. Device No：CDRX-096-006 http:\\www.everlight.com Prepared date：08-08-2005 IF=20mA V IF=100mA,tp=100μs,tp/T=0.01 IF=1A,tp=100μs,tp/T=0.01 Rev 2 VCE=5V IC=1mA RL=1KΩ Page: 3 of 6 Prepared by：Denky ITR9608 █ Typical Electrical/Optical/Characteristics Curves for IR Fig.1 Forward Current vs. Ambient Temperature Fig.2 Spectral Distribution 140 100 IF=20mA Ta=25°C 120 80 100 60 80 60 40 40 20 20 0 -40 -20 0 20 40 60 80 100 Fig.5 Relative Intensity vs. 0 Fig.6 Relative Radiant Intensity vs. Forward Current Angular Displacement Ie-Radiant Intensity(mW/sr) 1000 -20 0 -10 10 20 30 100 10 0 10 0 10 1 2 10 10 3 10 4 IF-Forward Current (mA) Fig.7 Relative Intensity vs. Ambient Temperature(°C) 40 0.9 50 0.8 0.7 60 70 80 0.6 0.4 0.2 0 0.2 0.4 0.6 Fig.8 Forward Current vs. Ambient Temperature(°C) 1.3 15 Ie-Radiant Intensity (mW/sr) 1.0 1.2 10 IF=20mA IF=20mA 5 1.1 0 1 25 50 75 Everlight Electronics Co., Ltd. Device No：CDRX-096-006 100 25 120 http:\\www.everlight.com Prepared date：08-08-2005 50 75 Rev 2 100 120 Page: 4 of 6 Prepared by：Denky ITR9608 █ Typical Electrical/Optical/Characteristics Curves for PT Fig.1Collector Power Dissipation vs. Ambient Temperature Fig.2 Spectral Sensitivity 100 1.0 80 0.8 60 0.6 40 0.4 20 0.2 Ta=25 C 0 0 -25 25 0 50 75 85 100 Fig.3 Relative Collector Current vs. Ambient Temperature 160 100 300 500 700 900 1100 1300 Fig.4 Collector Current vs. Irradiance 100 2 140 C 120 10 100 80 1 60 40 0.1 20 0 0 10 20 30 40 50 60 70 0.01 0.5 3 1.5 1 2 Fig.5 Collector Dark Current vs. Ambient Temperature Fig.6 Collector Current vs. Collector-Emitter Voltage 14 10 12 10 10 8 10 6 4 10 2 10 0 25 50 Everlight Electronics Co., Ltd. Device No：CDRX-096-006 75 100 0 0 http:\\www.everlight.com Prepared date：08-08-2005 1 2 Rev 2 3 4 Page: 5 of 6 Prepared by：Denky ITR9608 █ Reliability Test Item And Condition The reliability of products shall be satisfied with items listed below. Confidence level：90% LTPD：10% NO. 1 Item Solder Heat Test Condition TEMP : 260℃ ± 5 ℃ H : +100℃ 2 3 10 sec Failure Judgement Criteria Ac/Re More than 90% of lead to 22 PCs be covered by soldering 0/1 IR≧U×2 22 PCs Ee≦L×0.8 VF≧U×1.2 0/1 15 mins Temperature Cycle 5 min L : -40℃ 15 min H : +100℃ 5 min 10 sec Thermal Shock Test Sample Hours/ Size Cycle L : -10℃ 300 cycle 300 cycle 22 PCs 5 min U :Upper specification limit L :Lower specification limit 0/1 4 High Temperature TEMP. : +100℃ Storage 1000 hrs 22 PCs 0/1 5 Low Temperature TEMP. : -40℃ Storage 1000 hrs 22 PCs 0/1 1000 hrs 22 PCs 0/1 1000 hrs 22 PCs 0/1 6 7 DC Operating Life VCE=5V IF=20mA High Temperature / 85℃ / 85% R.H. High Humidity EVERLIGHT ELECTRONICS CO., LTD. Office: No 25, Lane 76, Sec 3, Chung Yang Rd, Tucheng, Taipei 236, Taiwan, R.O.C Everlight Electronics Co., Ltd. Device No：CDRX-096-006 Tel: 886-2-2267-2000, 2267-9936 Fax: 886-2267-6244, 2267-6189, 2267-6306 http:\\www.everlight.com http:\\www.everlight.com Prepared date：08-08-2005 Rev 2 Page: 6 of 6 Prepared by：Denky