K1110D & K1120D Series 5V Crystal Clock Oscillators ! Applications: Wide Area Networks (WAN’s) Reference Clocking x. Ma mm 8 , 20 x. Ma mm 2 , 13 0DA Z E K11X3.330 MHTE COD 3 TI DA C ! Superior Tolerance Performance Including up to 10 years of aging ! 2.0 to 35.0 MHz Frequency Range ! ±10ppm ±20ppm Stability Options ! -40°C to 85°C Operating Temperature - K1120D ! 0°C to 70°C Operating Temperature - K1110D ! Meets Stratum IV Requirements ! Enable/Disable Option Available m 9m 7,4 x. Ma PIN 1 E L E C T R I C A L S P E C I F I C AT I O N S Model Frequency Range (MHz) Input Current (mA) Frequency Stability (ppm) Overall 0oC to 70oC K1110DA K1120DAM 2 to 35 < 30 Inclusive of Calibration, Temperature, Voltage, Load, Aging ±10 - - ±20 Inclusive ±3.0 0oC to +70oC -40oC to +85oC OBSOLETE -40oC to 85oC Aging @ 50oC (10 Years) Temperature Range (oC) Operating -40oC to +85oC +5.0V ±5% 45/55 < 16MHz; 40/60 ≥ 16MHz Storage Supply Voltage (V) Symmetry CMOS/TTL “0” Level (VOL) 0.5 max. “1” Level (VOH) Rise Time & Fall Time (ns) Start Up Time (ms) 4.5 min <5 <10 PA R T N U M B E R I N G G U I D E K11X0DAX X - Specify Frequency “Blank” = Fixed Frequency “E” = Enable/Disable “Blank” = 0°C to 70°C Operating Temp. “M” = -40°C to +85°C Operating Temp. Model Selection: See Table Above 2553 N. Edgington Street, Franklin Park, IL 60131 " Phone: 847.451.1000 " Fax: 847.451.7585 800-888-1499 or www.champtech.com 1 K1110D & K1120D Series 5V Crystal Clock Oscillators PIN FUNCTION 1 N/C or Enable/Disable 7 Gnd/ & Case Gnd 8 Output + VCC 14 SHIPPING TUBE CROSS SECTION OBSOLETE TEST CIRCUIT DIAGRAM OUTPUT WAVEFORM MECHANICAL AND ENVIRONMENTAL SPECIFICATIONS TEST METHODS REFERENCE PROCEDURES DESCRIPTION Temperature Cycle MIL-STD-833, Mtd 1010, Cond. B -55°C to +125°C; Air-to-Air; 100 cycles; 10 min. dwell Mechanical Shock MIL-STD-202, Mtd 213, Cond. D 500 g’s Vibration MIL-STD 202, Mtd 204, Cond. B 10-2000 Hz; 0.06 inch; 15g; 3 planes Humidity Steady State MIL-STD-202, Mtd 103 40°C; 90%-95% R.H.; 56 days Thermal Shock MIL-STD-883, Mtd 1011.7 Cond. A 100°C to 0°C; Water-to-Water; 15 cycles Electrostatic Discharge MIL-STD-883, Mtd 3015 Class II 2 KV to 4 KV Threshold Solderability Hermeticity MIL-STD-883, Mtd 2022.2 MIL-STD-883, Mtd 1014.8, Cond. A1 Solder dip; Meniscograph Criteria Mass spectro. 2 x 10-8 atmos. CC/sec He Resistance to Soldering Lead Integrity MIL-STD-202, Mtd 210A, Cond. C 260°C; 10 seconds: 1 inch/sec. MIL-STD-883, Mtd 2004.5, Cond. A, B1 Lead tension & bend stress Marking Permanence Life Test MIL-STD-883, Mtd 2015.8 MIL-STD-883, Mtd 1005.6 Resistance to solvents 125°C, powered, 1000 hours minimum 2553 N. Edgington Street, Franklin Park, IL 60131 " Phone: 847.451.1000 " Fax: 847.451.7585 800-888-1499 or www.champtech.com 2