LED Highly-Diffused Light (25 mm) Features • Designed to minimize surface textures and elevation changes, while providing uniform illumination over the field of view • 25 mm x 25 mm light aperture • Provides uniform lighting for specular surfaces • Black anodized aluminum housing • The suggested field of view is 12 mm x 12 mm and the suggested stand off is 25 mm LED Highly-Diffused Light Model Illumination Type Models LEDRS25N† † Color Continuous highly-diffused light Red 640 nm Supply Voltage Cable 0.5 m (18") terminated with 9-pin D-sub connector (male pins) Supply Current Connections Pin 3 = dc common Pin 4 = +V 12V dc ±10% with voltage regulation of ±1% 420 mA max. Power supply model PSA-12(E) or PS2V-12(E) is recommended (see other side) This model is not stocked and is non-returnable. Useful Life 60,000 hours Environmental Rating IEC IP20; NEMA 1 Operating Conditions Temperature: 0° to 40°C (+32° to 104°F) Maximum relative humidity: 95% at 40°C (non-condensing) 22.3 mm (0.88") 40.1 mm 25 mm (1.58") (0.98") Light Aperture 0.5 m (18") 25 mm (0.98") Light Aperture M6 x 1.0 Thru (2x) 61.3 mm (2.41") 25.4 mm (1.00") 115.3 mm (4.54") WARRANTY: Banner Engineering Corp. warrants its products to be free from defects for one year. Banner Engineering Corp. will repair or replace, free of charge, any product of its manufacture found to be defective at the time it is returned to the factory during the warranty period. This warranty does not cover damage or liability for the improper application of Banner products. This warranty is in lieu of any other warranty either expressed or implied. Printed in USA 05/01 P/N 67441 LED Highly-Diffused Light (25 mm) Accessories Continuous Power Supplies Models Input PSA-12 100-250V ac 50/60 Hz PSA-12E Input Cord North America (NEMA 5-15) Cont. Europe (Schuko CEE 7) Output Cable Output 12V dc ±5% with voltage regulation of ±1% 3.5 A max. 1.8 m (6') Terminated with 9-pin D-sub connector (female pins) Used with Continuous types: LEDRS25N Variable Power Supplies (see data sheet p/n 67449) Models Input Input Cord PS2V-12† 100-140V ac 60 Hz North America (NEMA 5-15) PS2V-12E† 200-250V ac 50 Hz Cont. Europe (Schuko CEE 7) Output Cable Output 2-channels 6 - 12V dc 2 A max. per channel 1.8 m (6') Terminated with 9-pin D-sub connector (female pins) Used with Continuous types: LEDRS25N Extension Cables Models DB906 † Length Configuration 1.8 m (6') DB910 Terminated both ends with 9-pin D-sub connector, for continuous lights 3.0 m (10') (one end male pins and opposite end female pins) DB9Y 1.8 m (6') † † † Used with Continuous types: LEDRS25N Y cable for powering 2 lights from one supply, for continuous lights These models are not stocked and are non-returnable. Banner Engineering Corp., 9714 Tenth Ave. No., Mpls., MN 55441 • Ph: 763.544.3164 • www.bannerengineering.com • Email: [email protected]