ETC 6372

Model 6372, 6559, 6560, 6561
Male Mini-Connector
“Do-It-Yourself”
FEATURES:
• Molded in contacts assure precision alignment
• Matching thermocouple alloys reduce EMF
• Channel design isolates wires for clear, strong signals
• Make your own extension cables
MATERIALS:
Insulator – Hytrel 4776.
MODEL NUMBER
6372
6559
6560
6561
CALIBRATION
K
J
E
T
COLOR
Yellow
Black
Violet
Blue
RATINGS:
Maximum Ambient Temperature - 400°F. (205°C.).
Maximum Wire Size – 20AWG (solid), 22 AWG (stranded)
ORDERING INFORMATION: Model 6372, 6559, 6560, 6561
Note: For low voltage environments do not exceed 30VAC/60VDC.
All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm).
All specifications are to the latest revisions. Specifications are subject to change without notice.
Registered trademarks are the property of their respective companies. Made in USA
7/10/02 SY/EH/LS
Last saved by Laura Goldberg
Sales:800-490-2361 Fax: 888-403-3360
Technical Assistance: 800-241-2060
C:\Laura Goldberg\FlukeDataSheet \d6372_6559-60-61_2_02.doc
PomonaACCESS 90739 (800) 444-6785 or (425) 446-6010
More drawings available at www.pomonaelectronics.com
Page 1 of 2
Model 6372, 6559, 6560, 6561
Male Mini-Connector
“Do-It-Yourself”
ASSEMBLY INSTRUCTIONS
1.
Using a flat tip screwdriver, remove lid from connector.
2.
Cut back extension wire jacket (if applicable) 5/8”, strip back individual wires ¼”.
3.
Remove the elastomer strain relief from the connector. Insert wires into the strain relief until flush with the extension
wire outer jacket (5/8”).
4.
Loosen the two wire terminal screws (Approximately 3 ½ turns counter clockwise) using a small flat tip
screwdriver.
5.
Insert the stripped Red* wire under the (-) terminal screw, and the remaining wire under the (+) terminal screw.
Tighten down the two terminal screws.
6.
Install the lid and tighten down the lid screw.
*Color may vary outside of the USA.
All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm).
All specifications are to the latest revisions. Specifications are subject to change without notice.
Registered trademarks are the property of their respective companies. Made in USA
7/10/02 SY/EH/LS
Last saved by Laura Goldberg
Sales:800-490-2361 Fax: 888-403-3360
Technical Assistance: 800-241-2060
C:\Laura Goldberg\FlukeDataSheet \d6372_6559-60-61_2_02.doc
PomonaACCESS 90739 (800) 444-6785 or (425) 446-6010
More drawings available at www.pomonaelectronics.com
Page 2 of 2