SP15 & 30U-T 15 AND 30 WATT TRIPLE OUTPUT MODELS ELECTRICAL SPECIFICATIONS All specifications are typical at nominal input, full load. INPUT SPECIFICATIONS Input Voltage.............................................. AC 100-120 / 200-240V (AC85-264V) (DC110-340V) Input Frequency.......................................... 50-60 Hz (47-63 Hz) Input Current (AC 100/240V)............................. SP15U .36/.20 (typ), SP30U .7/.4 (typ), Inrush Current............................................ SP15U 5.5/14.0A, SP30U 15/30A, Voltage Adjust Range.................................. CH1: +5%,-0%, CH2: Fixed (Factory Set Accuracy +/- 5%) OUTPUT SPECIFICATIONS FEATURES 15W AND 30W OUTPUT POWER UNIVERSAL INPUT (AC85-264V) METAL CHASSIS WITH COVER INTERNAL EMI FILTER HIGH RELIABILITY Output Voltage........................................... See Chart Leakage Current......................................... 0.75 mA RMS max. Over-Voltage Protection.............................. Built In Over-Current Protection.............................. Built In (5V output only) Line Regulation........................................... 0.4% Load Regulation.......................................... SP15U/30U CH1: 1% CH2, CH3 1% min. Hold-Up Time.............................................. 20m sec. Min. Rise Time.................................................... SP15U 18 mSEC. SP30U 100 mSEC. Drift.............................................................. 0.5%+15mV (8hr. after 1 hr. warm up) Ripple Noise (DC~100MHz)........................150 mVp-p GENERAL SPECIFICATIONS LOW COST, HIGH PERFORMANCE 3 YEAR WARRANTY MTBF.... .................................................... 200,000 Hours Isolation Voltage Primary to Secondary............... AC 3000V Primary to Case........................ AC 1500V (1 min. Cut off current) Secondary to Case.................... AC 500V Isolation Resistance.................................... Input-Output-Case 100-Mohms min. (DC500V) Vibration .................................................... 0.5 mm width, 10-55 Hz/1 min. cycle, 3 directions each 30 min. Shock..... .................................................... 20G (3 directions, each 3 times) ENVIRONMENTAL SPECIFICATIONS SAFETIES / EMI FCC-B CISPR-B VCCI-2 Operating Temperature .............................. 0˚-60˚C Derates linearly 2.5%/˚C after 50˚C Temperature Coefficient.............................. ±0.02% / ˚C Storage Temperature.................................. -20˚C - 85˚C PHYSICAL SPECIFICATIONS Metal Enclosed - Terminal Block 76 Series MODEL 15W 30W SPU 15T SP15U-0522T SP15U-0533T SP30U-0522T SP30U-0533T OUTPUT 1 OUTPUT 2 VOLT AMPS VOLT +5V +5V +5V +5V 2 2 4 4 +12V +15V +12V +15V AMPS 0.5 0.45 1.2 1.0 OUTPUT 3 VOLT -12V -15V -12V -15V AMPS 0.5 0.45 0.6 0.5 MAX POWER NOT TO EXCEED: SP15U - 15 WATTS SP30U - 30 WATTS SPU 30T NOTE: All specifications typical and nominal / full load and 25˚C unless otherwise noted. Mounting screw lenght should not exceed 0.31 inches or 8 mm. Avoid sustained operation in overload or dead short conditions. Specifications subject to changes without notice. 77 • No. 6-32 mounting holes standard • Dimensions in mm • Terminal block or “pin” type connector available