SURFACE MOUNT DISPLAY P/N: KPSA04-104 Features SUPER BRIGHT RED Description 0.4INCH DIGIT HEIGHT. The Super Bright Red source color devices are made LOW CURRENT OPERATION. with Gallium Aluminum Arsenide Red Light Emitting EXCELLENT CHARACTER APPEARANCE. Diode. I.C. COMPATIBLE. MECHANICALLY RUGGED. GRAY FACE,WHITE SEGMENT. PACKAGE: 400PCS/REEL. RoHS COMPLIANT. Package Dimensions & Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted. 2. Specifications are subject to change without notice. SPEC NO: DSAA6030 REV NO: V.5 DATE: NOV/21/2005 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: W.J.ZHU PAGE: 1 OF 4 Selection Guide Part No. Dice KPSA04-104 Iv (ucd) @ 10 mA Lens Type SUPER BRIGHT RED (GaAlAs) WHITE DIFFUSED Description Min. Typ. 8000 27500 Common Anode, Rt. Hand Decimal. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength Super Bright Red λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 660 nm IF=20mA Super Bright Red 640 nm IF=20mA Spectral Line Half-width Super Bright Red 20 nm IF=20mA C Capacitance Super Bright Red 45 pF VF=0V;f=1MHz VF Forward Voltage Super Bright Red 1.85 2.5 V IF=20mA IR Reverse Current Super Bright Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Super Bright Red Units Power dissipation 100 mW DC Forward Current 30 mA Peak Forward Current [1] 155 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAA6030 REV NO: V.5 DATE: NOV/21/2005 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: W.J.ZHU PAGE: 2 OF 4 Super Bright Red KPSA04-104 Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity/ luminous flux, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity/ Luminous Flux: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAA6030 REV NO: V.5 DATE: NOV/21/2005 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: W.J.ZHU PAGE: 3 OF 4 KPSA04-104 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) SPEC NO: DSAA6030 REV NO: V.5 DATE: NOV/21/2005 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: W.J.ZHU PAGE: 4 OF 4