1.8mm SOLID STATE LAMP WP1060ED Features ORANGE Description 1.8mm DIAMETER SMALL SIZE LED LAMP. The Orange source color devices are made with ULTRA BRIGHTNESS IS AVAILABLE. Gallium Arsenide Phosphide on Gallium Phosphide RELIABLE AND RUGGED. Orange Light Emitting Diode. VERSATILE MOUNTING ON P.C. BOARD OR PANEL. AVAILABLE IN DIFFUSED LENS. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAF2114 REV NO: V.1 DATE: APR/11/2005 PAGE: 1 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP:1101009374 Selection Guide Part No. Dice WP1060ED Iv (mcd) @ 10mA Lens Type ORANGE (GaAsP/GaP) Viewing Angle Min. Typ. 2θ θ1/2 8 15 70° ORANGE DIFFUSED Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Orange λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 627 nm IF=20mA Orange 625 nm IF=20mA Spectral Line Half-width Orange 45 nm IF=20mA C Capacitance Orange 15 pF VF=0V;f=1MHz VF Forward Voltage Orange 2.0 2.5 V IF=20mA IR Reverse Current Orange 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Orange Units 105 mW DC Forward Current 30 mA Peak Forward Current [1] 160 mA 5 V Power dissipation Reverse Voltage Operating/Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 3 Seconds Lead Solder Temperature [3] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAF2114 REV NO: V.1 DATE: APR/11/2005 PAGE: 2 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP:1101009374 Orange WP1060ED Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF2114 REV NO: V.1 DATE: APR/11/2005 PAGE: 3 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP:1101009374