RF SILICON AND SUBSYSTEMS SOLUTIONS FOR BROADBAND COMMUNICATIONS AND AUTOMOTIVE ELECTRONICS MT2130 SINGLE-CHIP LOW POWER TERRESTRIAL TUNER PRODUCT BRIEF The MT2130 is a single-chip low-power tuner for analog and digital worldwide PRELIMINARY television standards. MT2130 Single-Chip Tuner The MicroTuner™ MT2130 is an advanced low-power terrestrial TV tuner, optimized for portable and power sensitive devices. It has been developed to give manufacturers design flexibility and low cost while maintaining high sensitivity. The MT2130 receives frequencies in the 48 MHz to 1 GHz range and converts a selected channel to a standard intermediate frequency (IF) between 30 MHz and 57 MHz. The MT2130’s dual-conversion architecture allows for operation of both terrestrial and cable systems without any manual adjustments. This is achieved via the combination of Microtune’s ClearTune technology and an autonomous automatic gain control (AGC). The integrated LNA delivers excellent sensitivity. The innovative gain control and power detector circuits provide reliable terrestrial performance even in hostile signal environments. The MT2130 can interface with multiple TV transmission standards including ATSC, DVB-T, NTSC, PAL, SECAM and QAM. In addition, the MT2130 provides excellent in-band flatness, as well as consistent gain characteristics across the complete reception band for use in USB TV Receivers, Express Card TV Receivers, portable TVs and TV tuner modules for laptop computers. APPLICATIONS • • • • • • • • ATSC/NTSC USB TV receivers DVB-T/PAL USB TV receivers DVB-T/ATSC USB TV receivers ISDB-T receivers Express Card TV Receivers Cardbus TV Receivers Mini Card TV tuner modules for laptop computers Portable TVs FEATURES • • • • • • • • • • • 48 MHz to 1 GHz input frequency range. Low-power 1.2 W dual conversion architecture. Integrated front-end band pass filtering Integrated RF power detectors and closed-loop RF AGC Single-ended RF input On-chip low-noise amplifier provides excellent terrestrial sensitivity Integrated IF variable gain amplifier for direct connection to digital demodulators Interface with ATSC, NTSC, DVB-T, ISDB-T, PAL, SECAM and QAM TV transmission standards. Capable of driving multiple IF filters Compatible with 3.3 V and 5 V serial bus 48 pin, 7 mm X 7 mm QFN package MT2130 LOW PO WER TERRESTRIAL TUNER PRODUCT BRIEF TUNER ELECTRICAL CHARACTERISTICS RECOMMENDED OPERATING CONDITIONS PARAMETER MIN Second intermediate center frequency (programmable) Supply voltage 5V Supply voltage 3.3V Supply voltage ripple Operating junction temperature 4.75 3.15 VGA output load impedance 300 TYP MAX 30 57 5.0 3.3 400 V V mV °C Ω kHz ABSOLUTE RATINGS MIN UNIT 6 3.6 V V °C +260 °C VCC +0.3 V GND RFin RFcap GND UPCVCCB UPCoutn UPCoutp GND GND DNCinp DNCinn DNCVCC 48 47 46 45 44 43 42 41 40 39 38 37 -0.3 MAX +150 -40 Lead-free temperature (soldering 5 seconds) Input voltage VLNA UPC TYP UNIT 190 mA 80 mA 48 1000 MHz 6 dB 42 dB 55 dB -84 dBc/Hz -104 dBc/Hz 50 kHz 30 VGA MAX 57 MHz 2.0 Vp-p 60 dB 39 dB VGA DNC IF OUTPUT RF INPUT UPCVCCF 1 36 IFVCC GPO 2 35 DNCoutp A1 3 34 DNCoutn A0 4 33 PD1cap 32 PD2cap 31 AFCin Demod AGC IF AGC L01 NC 5 LO1AVCC 6 LO1T2CM 7 30 VGAinp LO1T1CM 8 29 VGAinn LO1REG 9 28 VGAVCC LO1LPF 10 27 VGAVCC GND 11 26 VGAcntl VCC3V 12 25 VGAoutp 14 15 16 17 18 19 20 21 22 23 24 SROout XTALn XTALp VCC3V GND LO2LPF LO2TCM LO2REG LO2AVCC VGAoutn 13 SERCLK Exposed die attach paddle on package bottom SERData PRELIMINARY PARAMETER Supply voltage 5V Supply voltage 3.3V Storage temperature range MIN Power Supply Active current 5V Active current 3.3V RF Signal Path Input frequency range Noise figure (Off-Air mode) Voltage gain RF AGC range LO phase noise (10 kHz) LO phase noise (100 kHz) LO step size IF VGA Frequency range Maximum output voltage Maximum voltage gain IF AGC range MHz 5.25 3.45 15 125 Serial control clock PARAMETER UNIT PLL PLL SRO L02 SERIAL CONTROL INTERFACE SERIAL DATA CLOCK MT2130 Block Diagram MT2130 Pin Diagram Microtune, Inc., 2201 Tenth Street, Plano, TX 75074, USA Tel: +1-972-673-1600, Fax: +1-972-673-1602, E-mail: [email protected], Web site: www.microtune.com For a detailed list of office locations, sales offices, and sales representatives, visit our Web site at www.microtune.com The information in this document is believed to be accurate and reliable. Microtune assumes no responsibility for any consequences arising from the use of this information, nor from any infringement of patents or the rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or other rights of Microtune. The information in this publication replaces and supersedes all information previously supplied, and is subject to change without notice. The customer is responsible for assuring that proper design and operating safeguards are observed to minimize inherent and procedural hazards. Microtune assumes no responsibility for applications assistance or customer product design. The devices described in this document are not authorized for use in medical, life-support equipment, or any other application involving a potential risk of severe property or environmental damage, personal injury, or death without prior express written approval of Microtune. Any such use is understood to be entirely at the user’s risk. Microtune is a registered trademark of Microtune, Inc. MicroTuner, MicroStreamer, VideoCaster, DataCaster, and the Microtune logo are trademarks of Microtune, Inc. All other trademarks belong to their respective companies. Microtune’s products are protected by one or more of the following U.S. patents: 5,625,325; 5,648,744; 5,717,730; 5,737,035; 5,739,730; 5,805,988; 5,847,612; 6,100,761; 6,104,242; 6,163,684; 6,169,569; 6,172,378; 6,177,964; 6,211,745; 6,218,899; 6,268,778; 6,310,387; 6,323,736; 6,355,537; 6,429,502; 6,462,327; 6,535,068; 6,580,313; 6,608,522; 6,631,257; 6,714,776; 6,725,463; 6,744,308; 6,771,124; 6,784,945; 6,804,099; 6,888,406; 6,891,435; 6,906,594; 6,909,886; 6,920,182; 6,922,556; 6,963,478; 6,973,288; 6,993,310; 7,035,614; 7,078,960; 7,079,195; D469,742 and additional patents pending or filed. Entire contents Copyright © 1996 - 2006 Microtune, Inc. MT2130 PB-00139 — Rev 1.1 071906 October 2006