Xeon 1 Power Violet LED OSV5XME1E1E Ver.c.2 ■Features ■Outline ● Highest Luminous Flux ● Super Energy Efficiency ● Long Lifetime Operation ● Superior ESD protection ● Superior UV Resistance Dimension 3.6 BackView ■Applications Money Detector ● UV-Curing ● Sensor light ● Photo-catalyst ● Other Lighting Anode ■Absolute Maximum Rating Item (Ta=25℃) ■Directivity Symbol Value Unit DC Forward Current IF 400 mA Pulse Forward Current* IFP 500 mA Reverse Voltage VR 5 V Power Dissipation PD 1600 mW Operating Temperature Topr -30 ~ +85 ℃ Storage Temperature Tstg -40~ +100 ℃ Lead Soldering Temperature Tsol 260℃/5sec - *Pulse width Max.10ms DC Forward Voltage 0 0 Duty ratio max 1/10 ■Electrical -Optical Characteristics Item Symbol VF DC Reverse Current IR Condition IF=350mA VR=5V ■Forward Operating Current (DC) (Ta=25℃) Min. 3.0 - Typ. 3.3 - Max. Unit 4.0 V 10 µA Peak Wavelength λP IF=350mA 400 405 410 nm Radiant Power Po IF=350mA 200 250 - mW 2θ1/2 IF=350mA - 140 - deg 400 350 300 250 200 150 100 50 RJ-A=60 /W RJ-A=50 /W RJ-A=40 /W RJ-A=30 /W 0 0 50% Power Angle Cathode ESD Protection Diode Unit:mm Tolerance:±0.30mm Forward Current, IF (mA) ● 25 50 75 100 Ambient Temperature, TA ( ) Note: Don’t drive at rated current more than 5s without heat sink for Xeon 1 emitter series. LED & Application Technologies http://www.optosupply.com VER A.0 125 Xeon 1 Power Violet LED OSV5XME1E1E ■ Handling of Silicone Lens LEDs Notes for handling of silicone lens LEDs ● Please do not use a force of over 3kgf impact or pressure on the silicone lens, otherwise it will cause a catastrophic failure. ● The LEDs should only be picked up by making contact with the sides of the LED body. ● Avoid touching the silicone lens especially by sharp tools such as Tweezers. ● Avoid leaving fingerprints on the silicone lens. ● Please store the LEDs away from dusty areas or seal the product against dust. ● When populating boards in SMT production, there are basically no restrictions regarding the form of the pick and place nozzle, except that mechanical pressure on the silicone lens must be prevented. ● Please do not mold over the silicone lens with another resin. (epoxy, urethane, etc) LED & Application Technologies http://www.optosupply.com VER A.0