Xeon 3 Power Pure White LED OSW4XME3C1E VER C.0 ■Features ■Outline Highest Luminous Flux ● Super Energy Efficiency ● Long Lifetime Operation ● Superior ESD protection ● Superior UV Resistance Anode(+) 1.15 ● Dimension 3.6 2.0 Cathode(-) BackView ■Applications ● Read lights (car, bus, aircraft) ● Portable (flashlight, bicycle) ● Bollards / Security / Garden ● Traffic signaling / Beacons ● In door / Out door Commercial lights ● Automotive Ext 0.1 (Ta=25℃) Unit DC Forward Current IF 800 mA Pulse Forward Current* IFP 1000 mA Reverse Voltage VR 5 V Power Dissipation PD 3200 mW Operating Temperature Topr -30 ~ +85 ℃ Storage Temperature Tstg -40~ +100 ℃ Lead Soldering Temperature Tsol 260℃/5sec - 1.05 0 Symbol DC Forward Voltage VF DC Reverse Current ■Forward Operating Current (DC) (Ta=25℃) Condition Min. Typ. Max. Unit IF=350mA 3.0 3.3 4.0 V IF=700mA 3.5 3.8 4.5 V IR VR=5V - - 10 µA Φv IF=700mA 220 240 - lm CCT IF=700mA - 6500 - K Chromaticity x IF=700mA - 0.31 - - Coordinates* y IF=700mA - 0.33 - - 2θ1/2 IF=700mA - 120 - deg 800 Forward Current, IF (mA) Item 50% Power Angle 0 Duty ratio max 1/10 ■Electrical -Optical Characteristics Color Temperature ESD Protection Diode Unit:mm Tolerance:±0.30mm ■Directivity Value Luminous Flux 0.2 14.5 Symbol *Pulse width Max.10ms Cathode 5.3 Anode ■Absolute Maximum Rating Item 2.75 5.0 700 600 500 400 300 200 100 RJ-A=30 /W RJ-A=25 /W RJ-A=20 /W RJ-A=15 /W 0 0 25 50 75 100 125 Ambient Temperature, TA ( ) Note: Don’t drive at rated current more than 5s without heat sink for Xeon 3 emitter series. LED & Application Technologies http://www.optosupply.com VER C.0 Xeon 3 Power Pure White LED OSW4XME3C1E VER C.0 ■ Handling of Silicone Lens LEDs Notes for handling of silicone lens LEDs ● Please do not use a force of over 3kgf impact or pressure on the silicone lens, otherwise it will cause a catastrophic failure. ● The LEDs should only be picked up by making contact with the sides of the LED body. ● Avoid touching the silicone lens especially by sharp tools such as Tweezers. ● Avoid leaving fingerprints on the silicone lens. ● Please store the LEDs away from dusty areas or seal the product against dust. ● When populating boards in SMT production, there are basically no restrictions regarding the form of the pick and place nozzle, except that mechanical pressure on the silicone lens must be prevented. ● Please do not mold over the silicone lens with another resin. (epoxy, urethane, etc) LED & Application Technologies http://www.optosupply.com VER C.0