Sparkle Power Inc. A Leading Power Supply Manufacturer www.sparklepower.com FSP450-60ETN (80PLUS Platinum, RoHS Compliant) 450 Watts ATX12V V2.3 EPS12V V2.92 Switching Power Supply (Meet 2013 ErP) Features • • • • Complied with ATX12V V2.3 EPS12V V2.92 standard Active Power Factor Correction (PFC) meet EN61000-3-2 High efficiency and reliability Compatible with European Union Directive 2002/95/EC (Restriction on Hazardous Substances). • • • • • • • • Remote ON/OFF function Internal 12V DC fan included Specification Noise Killer (thermal fan speed control function) • Low noise and ripple Storage & Shipping: -40°C ~ +70°C Output over voltage, short circuit, and over current protection 100% Hi-pot, ATE, and burn-in tested Re-settable power shut down Complies with FCC part 15 subpart J class B 115Vac operation, and CISPR 22 class B at 230Vac operation • Temperature Range: Operating: +0°C ~ +40°C on full load Approved by CUL/UL60950-1, TUV EN60950-1,CB 60950-1 report, • • • • • FCC,EMC. Humidity: 5-85% on operating, 5-95% on storage Efficiency: 89% minimum, typical up to 92% Rise time: 15ms maximum Hold-up Time: 17ms minimum at nominal input voltage Power Good Signal: Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible) • • • Input Characteristics Input Range: 90 ~ 264Vac, Full Range Input Frequency: 47 ~ 63Hz Input Current: Max 8A at 100-127Vrms@60Hz, Min 4A at 200-240Vrms@50Hz. Inrush Current: No damage. Leakage Current: Less than 3.5mA at 264Vac, 50Hz MTBF: 100,000 hours on maximum load at +25°C Dimensions (LxWxH):140x150x85.8mm / 5.5x5.9x3.4inch Output Characteristics +3.3V +5V +12V1 +12V2 -12V +5Vsb MINIMUM LOAD NORMAL LOAD MAXIMUM LOAD LOAD REG. LINE REG. 0.1A 0.2A 0.1A 0A 0A 12A 12A 9A 9A 0.15A 16/1.5A 6.5/16A 18A 18A ±5% ±5% ±5% ±5% ±10% ±1% ±1% ±1% ±1% ±2% 50mV P-P 50mV P-P 120mV P-P 120mV P-P 200mV P-P 0A 1.5A ±5% ±1% 50mV P-P Sparkle Power Inc. Main Office 1000 Rock Avenue San Jose, CA 95131 Tel : 408-519-8888 Fax: 408-519-9999 E-MAIL: [email protected] 0.3A 3A RIPPLE & NOISE (1) +3.3V & +5V total output not exceed 85W. When +5V is load to 16A, the +3.3V maximum load is 1.5A. When +3.3V is load to 16A, the +5V maximum load is 6.5A. (2) +12V1 & +12V2 total output not exceed 408W(34A). (3) All outputs shall be safety-isolated from the AC mains and share a common return. This common return must be connected to supply chassis. (4) Voltages and ripple are measured at the load side of mating connectors with a 0.1uF monolithic ceramic capacitor paralleled by a 10uF electrolytic capacitor across the measuring terminals. Sparkle Power Inc. Los Angeles Office 17071 Green Drive City of Industry, CA 91745 Tel : 626-839-7180 Fax: 626-839-3395