REVISIONS PART NO. MCD Series ECN # REV DESCRIPTION - A RELEASED DRAWN DATE Ashok 18/01/12 CHECKD DATE APPRVD DATE Jagan 18/01/12 Farnell 01/02/12 DS PCB Layout Dimensions : Millimetres (Inches) Schematic (Typical) (2, 4, 6, 8, 10 and 12 Pos Avails) Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. Multicomp is the registered trademark of the Group. © Premier Farnell plc 2012. TOLERANCES: UNLESS OTHERWISE SPECIFIED, DIMENSIONS ARE FOR REFERENCE PURPOSES ONLY. DRAWN BY: Ashok CHECKED BY: DATE: 18/01/12 DATE: Jagan 18/01/12 APPROVED BY: DATE: 01/02/12 DRAWING TITLE: Switch - DS, DP, DA Series SIZE A DWG NO. SCALE: NTS M10001964 U.O.M.: mm REV ELECTRONIC FILE A 73742_DWG SHEET: 1 OF 5 REVISIONS PART NO. MCD Series ECN # REV DESCRIPTION - A RELEASED DRAWN DATE Ashok 18/01/12 CHECKD DATE APPRVD DATE Jagan 18/01/12 Farnell 01/02/12 DA PCB Layout Schematic (Typical) Dimensions : Millimetres (Inches) (4, 6 and 8 Pos Avails) Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. Multicomp is the registered trademark of the Group. © Premier Farnell plc 2012. TOLERANCES: UNLESS OTHERWISE SPECIFIED, DIMENSIONS ARE FOR REFERENCE PURPOSES ONLY. DRAWN BY: Ashok CHECKED BY: DATE: 18/01/12 DATE: Veena 18/01/12 APPROVED BY: DATE: 01/02/12 DRAWING TITLE: Switch - DS, DP, DA Series SIZE A DWG NO. SCALE: NTS M10001964 U.O.M.: mm REV ELECTRONIC FILE A 73742_DWG SHEET: 2 OF 5 REVISIONS PART NO. MCD Series ECN # REV DESCRIPTION - A RELEASED DRAWN DATE Ashok 18/01/12 CHECKD DATE APPRVD DATE Jagan 18/01/12 Farnell 01/02/12 DP PCB Layout DP Series Schematic (Typical) Dimensions : Millimetres (Inches) (4, 6 and 8 Pos Avails) Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. Multicomp is the registered trademark of the Group. © Premier Farnell plc 2012. TOLERANCES: UNLESS OTHERWISE SPECIFIED, DIMENSIONS ARE FOR REFERENCE PURPOSES ONLY. DRAWN BY: Ashok CHECKED BY: DATE: 18/01/12 DATE: Veena 18/01/12 APPROVED BY: DATE: 01/02/12 DRAWING TITLE: Switch - DS, DP, DA Series SIZE A DWG NO. SCALE: NTS M10001964 U.O.M.: mm REV ELECTRONIC FILE A 73742_DWG SHEET: 3 OF 5 REVISIONS PART NO. MCD Series ECN # REV DESCRIPTION - A RELEASED DRAWN DATE Ashok 18/01/12 CHECKD DATE APPRVD DATE Jagan 18/01/12 Farnell 01/02/12 Specifications: Mechanical: Mechanical life Maximum operation force Stroke Operation temperature Storage temperature Electrical: Electrical life Non-switching rating Switching rating Maximum contact resistance Insulation resistance Dielectric strength Circuit Materials: Base Colour Cover Colour Actuators Colour Contact Top seal Potting material : : : : : : 2,000 operations per switch 400 gf (DP Series) 1,000gf maximum (DS and DA Series) 2 mm -20°C to +70°C -40°C to +85°C : : : : : : : 2,000 operations per switch 24 V dc, 25 mA 100 mA, 50 V dc 25 mA, 24 V dc 50 mΩ at initial 100 MΩ 500 V ac for one minute SPST : : : : : : : : : PBT thermoplastic Black PBT thermoplastic Red, black and blue PBT high thermoplastic White Phosphor bronze with gold plating over nickel Polyester film Epoxy Soldering Process: Keep all switch contacts in their “OFF” position for all operations Wave soldering : Recommended temperature at 500°F (260°C) maximum 5 seconds for through hole type Hand soldering : Use a soldering iron of 30 watts, controlled at 350°C approximately maximum 5 seconds Make sure switch is in “OFF” position during soldering process, or it will decrease the operating force and meanwhile increase the contact resistance Do not wash the switch body except top tape sealed type, which suitable for spray cleaning method from top of the s/w Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. Multicomp is the registered trademark of the Group. © Premier Farnell plc 2012. TOLERANCES: UNLESS OTHERWISE SPECIFIED, DIMENSIONS ARE FOR REFERENCE PURPOSES ONLY. DRAWN BY: Ashok CHECKED BY: DATE: 18/01/12 DATE: Veena 18/01/12 APPROVED BY: DATE: 01/02/12 DRAWING TITLE: Switch - DS, DP, DA Series SIZE A DWG NO. SCALE: NTS M10001964 U.O.M.: mm REV ELECTRONIC FILE A 73742_DWG SHEET: 4 OF 5 REVISIONS PART NO. MCD Series ECN # REV DESCRIPTION - A RELEASED DRAWN DATE Ashok 18/01/12 CHECKD DATE APPRVD DATE Jagan 18/01/12 Farnell 01/02/12 Specification Table Number of Positions A B Part Number 4 11.52 (0.454) 7.62 (0.300) MCDA04 6 16.60 (0.654) 12.70 (0.500) MCDA06 8 21.68 (0.854) 17.78 (0.700) MCDA08 4 11.52 (0.454) 7.62 (0.300) MCDS04 6 16.60 (0.654) 12.70 (0.500) MCDS06 8 21.68 (0.854) 17.78 (0.700) MCDS08 2 6.44 (0.254) 2.54 (0.100) MCDS02 10 26.76 (1.054) 22.86 (0.900) MCDS10 12 31.84 (1.254) 27.94 (1.100) MCDS12 4 11.72 (0.461) 7.62 (0.300) MCDP04 6 16.80 (0.661) 12.70 (0.500) MCDP06 8 21.88 (0.861) 17.78 (0.700) MCDP08 Dimensions : Millimetres (Inches) Part Number Explanation: MC DA 04 Type Dip Switch Number of Positions Type Dip Switch Number of Positions www.element14.com www.farnell.com www.newark.com : DA = Right Angle, DP = Piano and DS = Slide Type Dip Switch : 04 = 4, 06 = 6, 08 = 8, 02 = 2, 10 = 10 and 12 = 12 Positions Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. Multicomp is the registered trademark of the Group. © Premier Farnell plc 2012. TOLERANCES: UNLESS OTHERWISE SPECIFIED, DIMENSIONS ARE FOR REFERENCE PURPOSES ONLY. DRAWN BY: Ashok CHECKED BY: DATE: 18/01/12 DATE: Veena 18/01/12 APPROVED BY: DATE: 01/02/12 DRAWING TITLE: Switch - DS, DP, DA Series SIZE A DWG NO. SCALE: NTS M10001964 U.O.M.: mm REV ELECTRONIC FILE A 73742_DWG SHEET: 5 OF 5