SLPOWER CENT1120

CENT1120
Universal 120 Watt Series
ITE Switch-Mode Power Supply
3 Year Warranty
•Universal Input 100Vac – 240Vac
•Single Output Models up to 120W
•Desktop Style/Non-vented case
•Efficiency Level IV
•Power Factor Correction
•Certified to UL/ EN60950
•IPX1 Rated Enclosure
•Complies with EMI/RFI Regulations
•Modified and Custom Designs Available
Specifications
Specifications
AC Input
90-264Vac, 47-63 Hz single phase
Input Current
Inrush Current
Input Fuse
Earth Leakage Current
Efficiency
90VAC: 2A, 180VAC: 1.0A
Inrush Current Protection Provided
Internal Primary Current Fuse Provided
Input-GND: <3.5mA, Normal State
Output-GND: <0.25mA, Normal State
88% typical
No Load Power
<0.5W
Input Harmonics
Meets IEC61000-3-2, class D
Transient Response
MTBF
> 100K hours (calculated, 25°C at full load)
Hold-up Time
16.7 ms min. @ 110VAC
Overvoltage Protection
Overload Protection
Output Voltage
Safety Standards
IEC/EN/UL60950
Operating Temperature
Turn-on Time
3 sec. maximum @ 115VAC
Case Material
Black 94V-0 rated Polycarbonate
Case Dimensions/Output Connections See chart and outline drawing
Two-Stage Conversion and Quasi-Resonant Flyback
Isolation
Temperature Coefficient
Storage Temperature
Relative Humidity
Altitude
Latching
See chart
Minimum Load
1% pk-pk max., 20MHz BW, differential mode
Hiccup Mode, auto-recovery
Overtemperature Protection
Topology
Ripple and Noise
>120% of full rated load, Hiccup Mode
Short Circuit Protection
5ms return to within 1%, 50% load step.
0.2A/sec slew rate. Maximum deviation is 5%
Line/ Load Voltage Regulation Line: +/-2.0% max., Load: +/-5% max
Not required
Latching
Input-Output: 3000VAC,
Input-GND: 1500VAC, Output-GND: 500VDC
0° to 40°C with no derating
0.3% per °C, maximum
-20°C to +85°C
5% to 95%, non-condensing
0 to 10,000 ft, operating; -500 to 40,000 ft, non-operating
Model Number Key
CENT 1 120 A VV 51 F 01
Model
Input Connector:
Output Connector:
Output Voltage:
Model
Output Pow er:
# of Outputs
Product Fam ily:
"01" = Standard. "02" and higher indicates a m odified m odel.
"F" = IEC320 C14 grounded, Other options available, see below
"51" = 6 pin Molex. Other options available.
"09" = 9Vdc, "12" = 12Vdc, "24" = 24Vdc, etc.
"A" = Original Configuration
"120" = 120 Watts
"1" = Single Output
"C" = Com m ercial/ITE/Industrial, "E" = External, "NT" = New Technology
______________________________________________________________________________________________________________________________ 1 of 2
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: [email protected] • www.slpower.com
CENT1120
Universal 120W Series
ITE Switch-Mode Power Supply
3Year Warranty
OUTPUT PARAMETERS
Model Number
Output Volts
Output Current (max)
Max Watts
Ripple (Vp-p max)
CENT1120A0951F01
9V
9.00A
81W
90mV
CENT1120A1251F01
12V
9.17 A
120W
120mV
CENT1120A1551F01
15V
7.33 A
120W
150mV
CENT1120A1851F01
18V
6.67 A
120W
180mV
CENT1120A2451F01
24V
5.00 A
120W
240mV
CENT1120A4851F01
48V
2.50 A
120W
480mV
Note: Ripple and Noise is measured with 0.1µF ceramic and 10µF electrolytic capacitor in parallel, connected at the measurement point.
EMI/EMC Compliance
Conducted Emissions
EN55022 Class B
Radiated Emissions
EN55022 Class B, FCC Part 15, Class B.
Static Discharge Immunity
EN61000-4-2, 6kV Contact Discharge, 8kV air discharge
Radiated RF Immunity
EN61000-4-3, 3V/m.
EFT/Burst Immunity
EN61000-4-4, 2kV/5kHz..
Line Surge Immunity
EN61000-4-5, 1kV differential, 2kV common-mode
Conducted RF Immunity
EN61000-4-6, 3Vrms
Power Frequency Magnetic Field Immunity
EN61000-4-8, 3A/m, performance criteria A
Voltage Dip Immunity
Line Flicker
EN61000-4-11, 70% UT for 10mS, 40% UT for 100mS, <5% UT
for 5000mS, performance criteria A, B
EN61000-3-3
Line Frequency Harmonics
EN61000-3-2, Class D
Input Receptacle
IEC320, C14 – Class I
Output Connector (12V model)
“#3” Connector is 2.5mm barrel type, center (+)
Output Connector (All other models)
“#51” Connector is Molex 39-01-2060 or equivalent.
Outline Drawing (#51 connector shown)
167
(6.6”)
82
(3.2”)
1800+/- 50mm
(1000mm on 12V models)
40
(1.6”)
Data Sheet © 2010 SL Power Electronics Corp. The information and specifications contained herein are believed to be correct at the time of publication.
Rev. 12-3-2010
However, SL Power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice.
______________________________________________________________________________________________________________________________ 2 of 2
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: [email protected] • www.slpower.com