Memory Module Specification KVR333X72RC25/1GD 1GB 128M x 72-Bit DDR333 Registered CL2.5 ECC 184-Pin DIMM DESCRIPTION: This document describes ValueRAM's 128M x 72-bit 1GB (1024MB) DDR333 CL2.5 SDRAM (Synchronous DRAM) Registered ECC memory module. The components on this module include eighteen 64M x 8-bit (16M x 8-Bit x 4 bank) DDR333 SDRAM in TSOP packages and three 16-bit drivers in TSSOP packages. This 184-pin DIMM uses gold contact fingers and requires +2.5V. The electrical and mechanical specifications are as follows: FEATURES: Clock Cycle Time (tCK) Row Cycle Time (tRC) Refresh Row Cycle Time (tRFC) Row Active Time (tRAS) Single Power Supply of Power (IDD0) UL Rating 6ns (min.) / 12ns (max.) 60ns (min.) 72ns (min.) 42ns (min.) / 70,000ns (max.) +2.5V (+/- .2V) 5.625 W operating 94 V - 0 Note: The module defined in this data sheet is one of several configurations available under this part number. While all configurations are compatible, the DRAM combination and/or the module height may vary from what is described here. However, in no configuration will the module height exceed 1.200" (30.48mm). Units : Inches (Millimeters) 1.200 (30.48) (17.80) 0.700 0.393 (10.00) 0.250 (6.350) 0.157 (4.00) 0.1496 (3.80) 2.175 0.071 (1.80) 0.100 0.26 (6.62) (2.50 ) 2.886 (73.30) 5.250 (133.35) 1 0.000 (00.00) 0.000 (00.00) 0.118 (3.00) 0.039 ± 0.002 (1.000 ± 0.050) 0.0787 (2.00) 0.0078 ±0.006 (0.20 ±0.15) 0.050 (1.270) 0.1575 (4.00) Figure 1: KVR333X72RC25/1GD 184-Pin DIMM Document No. VALUERAM0354-001.B00 07/14/04