ETC RO2047

RO2047
•
•
•
•
Ideal for 418.0 MHz Superhet Receiver LOs
Low Series Resistance
Quartz Stability
Rugged, Hermetic, Low-Profile TO39 Case
The RO2047 is a true one-port, surface-acoustic-wave (SAW) resonator in a low-profile TO39 case. It provides reliable, fundamental-mode, quartz frequency stabilization of fixed-frequency oscillators operating at
407.3 MHz. The RO2047 is designed specifically for the local oscillaotr in superhet receivers operating in the
United Kingdom under DTI MPT 1340 and in the USA under FCC Part 15.
407.35 MHz
SAW
Resonator
Absolute Maximum Ratings
Rating
Value
Units
CW RF Power Dissipation
+0
dBm
DC Voltage Between Any Two Pins
±30
VDC
-40 to +85
°C
Case Temperature
TO39-3 Case
Electrical Characteristics
Characteristic
Center Frequency (+25 °C)
Sym
Absolute Frequency
fC
Tolerance from 407.350 MHz
∆fC
2, 3, 4, 5
IL
2, 5, 6
Unloaded Q
QU
50 Ω Loaded Q
QL
Turnover Temperature
TO
Insertion Loss
Quality Factor
Temperature Stability
Turnover Frequency
Frequency Aging
Notes
FTC
Absolute Value during the First Year
|fA|
RF Equivalent RLC Model
2.5
Units
407.450
MHz
±100
kHz
5.0
dB
46
°C
1,800
6, 7, 8
31
fc + 0.5
kHz
0.037
ppm/°C2
ppm/yr
≤10
1
5
Maximu
7,300
16
DC Insulation Resistance between Any Two Pins
Typical
407.250
5, 6, 7
fO
Frequency Temperature Coefficient
Minimum
1.0
MΩ
RM
Motional Inductance
LM
Motional Capacitance
CM
Pin 1 to Pin 2 Static Capacitance
CO
5, 6, 9
CP
5, 6, 7, 9
3.1
pF
LTEST
2, 7
45
nH
Transducer Static Capacitance
Test Fixture Shunt Inductance
33
78
Ω
Motional Resistance
96.2635
5, 7, 9
µH
1.585780
3.1
Lid Symbolization (in Addition to Lot and/or Date Codes)
3.4
fF
3.7
pF
RFM RO2047
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
2.
3.
4.
5.
6.
Frequency aging is the change in fC with time and is specified at +65°C or less.
Aging may exceed the specification for prolonged temperatures above +65°C.
Typically, aging is greatest the first year after manufacture, decreasing significantly in subsequent years.
The center frequency, fC, is measured at the minimum insertion loss point, ILMIN,
with the resonator in the 50 Ω test system (VSWR ≤ 1.2:1). The shunt inductance, LTEST, is tuned for parallel resonance with CO at fC. Typically, fOSCILLATOR or fTRANSMITTER is less than the resonator fC.
One or more of the following United States patents apply: 4,454,488 and
4,616,197 and others pending.
Typically, equipment designs utilizing this device require emissions testing and
government approval, which is the responsibility of the equipment manufacturer.
Unless noted otherwise, case temperature TC = +25°C±2°C.
The design, manufacturing process, and specifications of this device are subject
to change without notice.
7.
8.
9.
Derived mathematically from one or more of the following directly measured
parameters: fC, IL, 3 dB bandwidth, fC versus TC, and CO.
Turnover temperature, TO, is the temperature of maximum (or turnover) frequency, fO. The nominal frequency at any case temperature, TC, may be calculated from: f = fO [1 - FTC (TO -TC)2]. Typically, oscillator TO is 20°C less than
the specified resonator TO.
This equivalent RLC model approximates resonator performance near the resonant frequency and is provided for reference only. The capacitance CO is the
static (nonmotional) capacitance between pin1 and pin 2 measured at low frequency (10 MHz) with a capacitance meter. The measurement includes case
parasitic capacitance with a floating case. For usual grounded case applications (with ground connected to either pin 1 or pin 2 and to the case), add
approximately 0.25 pF to CO.
RF Monolithics, Inc.
Phone: (972) 233-2903
Fax: (972) 387-9148
RFM Europe
Phone: 44 1963 251383
Fax: 44 1963 251510
©1999 by RF Monolithics, Inc. The stylized RFM logo are registered trademarks of RF Monolithics, Inc.
E-mail: [email protected]
http://www.rfm.com
RO2047-102599
Page 1 of 2
407.35 MHz
SAW Resonator
Electrical Connections
Temperature Characteristics
Pin
Connection
1
Terminal 1
2
Terminal 2
3
Case Ground
Bottom View
Pin 1
Pin 2
The curve shown on the right
accounts for resonator contribution only and does not include oscillator temperature
characteristics.
fC = f O , T C = T O
0
0
-50
-50
-100
-100
-150
-150
(f-fo ) / fo (ppm)
This one-port, two-terminal SAW resonator is bidirectional. The terminals
are interchangeable with the exception of circuit board layout.
-200
-80 -60 -40 -20
Pin 3
-200
0 +20 +40 +60 +80
∆T = TC - T O ( °C )
Typical Test Circuit
The test circuit inductor, LTEST, is tuned to resonate with the static capacitance, CO at FC.
Equivalent LC Model
Electrical Test:
The following equivalent LC model is valid near resonance:
Ω
1
Ω
2
1
Network
Analyzer
2
Network
Analyzer
Co= Cp + 0.25 pF*
Cp
3
*Case Parasitics
R
M
L
M
C
M
0.5 pF*
0.5 pF*
Power Test:
3
P
INCIDENT
50 Ω
Source at P
REFLECTED
F
C
1
Low-Loss
Matching
Network
to 50 Ω
Case Design
3
2
C
G
B
CW RF Power Dissipation =
-P
P
INCIDENT
REFLECTED
H
F
Typical Application Circuits
D
(3 places)
Typical Low-Power Transmitter Application:
Modulation
Input
200k Ω
E
A
J
(2 places)
MPS-H10
45°
+9VDC
47
C1
1
L1
Millimeters
(Antenna)
2
Inches
Dimensions
Min
C2
ROXXXX
Bottom View
3
RF Bypass
A
B
470
C
Typical Local Oscillator Application:
Output
+VDC
C1
1
L1
+VDC
2
Bottom View
3
Min
3.18
2.50
3.50
Max
0.366
0.125
0.098
0.138
D
0.46 Nominal
0.018 Nominal
E
5.08 Nominal
0.200 Nominal
F
2.54 Nominal
0.100 Nominal
G
2.54 Nominal
0.100 Nominal
H
J
C2
ROXXXX
Max
9.30
1.02
1.40
0.040
0.055
RF Bypass
RF Monolithics, Inc.
Phone: (972) 233-2903
Fax: (972) 387-9148
RFM Europe
Phone: 44 1963 251383
Fax: 44 1963 251510
©1999 by RF Monolithics, Inc. The stylized RFM logo are registered trademarks of RF Monolithics, Inc.
E-mail: [email protected]
http://www.rfm.com
RO2047-102599
Page 2 of 2