CV110-1 The Communications Edge TM Preliminary Information Cellular-band Single-Branch Downconverter Product Features • High dynamic range downconverter with integrated LO driver and IF amplifiers • +27 dBm Input IP3 • +12 dBm Input P1dB • 11.5 dB Noise Figure • RF: 806 - 915 MHz • IF: 70 - 120 MHz • Low-side LO downconverter • Single supply operation (+5 V) • 6 x 6 mm QFN SMT package CV Product Description Functional Diagram The CV110-1 is a high-linearity downconverter designed to meet the performance, functionality, and cost goals of current and next generation mobile infrastructure basestations. 27 25 23 IF 1 8 +Vcc 21 IF amp RF It is ideally suited for high dynamic range receiver front ends. The module is implemented in reliable GaAs MESFET technology and requires only a small 6x6 mm footprint. LO driver amp Typical applications include frequency downconversion used in CDMA/GSM/TDMA, CDMA2000, W-CDMA, and EDGE 2.5G and 3G mobile base transceiver stations. 17 Top View Actual Size Specifications1 Parameters RF Frequency Range LO Frequency Range IF Frequency Range IF Bandwidth SSB Conversion Gain Input IP3 Input IP2 Input 1 dB Compression Point Noise Figure LO Input Drive Level LO-RF Isolation LO-IF Isolation Return Loss: RF Port Return Loss: LO Port Return Loss: IF Port Operating Supply Voltage Supply Current 1 Units Minimum MHz MHz MHz % dB dBm dBm dBm dB dBm dB dB dB dB dB V mA 806 730 70 8 -2.5 +4.75 Maximum Comments 915 795 120 20 10 +27 +32 +12 11.5 0 9 30 14 14 14 +5 190 12 ∆f = 1 MHz @ RFin = 0 dBm / tone 12.5 +2.5 PLO = 0 dBm PLO = 0 dBm +5.25 230 Specifications when using application specific circuit with a low side LO = 0 dBm in a downconverting application at 25°C. Absolute Maximum Rating2 2 Typical Ordering Information Parameters Rating Part No. Description Operating Case Temperature CV110-1 Cellular-band Single-Branch Downconverter Storage Temperature -40° to +85 °C -65° to +100 °C Maximum Junction Temperature +150 °C Operation of this device above any of these parameters may cause permanent damage. This document contains information on a new product. Specifications and information are subject to change without notice WJ Communications, Inc • Phone 1-800-WJ1-4401 • FAX: 408-577-6620 • e-mail: [email protected] • Web site: www.wj.com May 2002 CV110-1 The Communications Edge TM Preliminary Information Cellular-band Single-Branch Downconverter Application Circuit Note: All components are of size 0603 or 0402 unless otherwise noted. Assembly Layout Functional Pin Layout Pin 1 2 3 4 5 6 7 8 9 10 11 12 13 14 FUNCTION Channel 1 RF Input GND +5 V GND N/C N/C N/C N/C N/C N/C N/C N/C N/C N/C Pin 15 16 17 18 19 20 21 22 23 24 25 26 27 28 FUNCTION N/C GND LO input GND N/C GND +5 V GND Channel 1 IF Amp Output / +5 V GND Channel 1 IF Amp Input GND Channel 1 IF Mixer Output GND This document contains information on a new product. Specifications and information are subject to change without notice WJ Communications, Inc • Phone 1-800-WJ1-4401 • FAX: 408-577-6620 • e-mail: [email protected] • Web site: www.wj.com May 2002 CV110-1 The Communications Edge TM Preliminary Information Cellular-band Single-Branch Downconverter Outline Drawing Mounting Configuration Pin 1 2 3 4 6.000±.050 5 6 7 8 9 10 11 12 13 14 FUNCTION RF Amp Output GND N/C GND N/C GND Mixer RF Port GND N/C GND Mixer LO Port GND LO Amp Output GND Pin 15 16 17 18 19 20 21 22 23 24 25 26 27 28 FUNCTION LO Amp Input GND N/C GND N/C GND IF Amp Output GND IF Amp Input GND Mixer IF Port GND RF Amp Input GND .325±.050 .400±.050 .888 4.700±.050 EXPOSED PAD .650 PITCH .900±.050 .203±.025 (EXPOSED LEAD) .000 - .050 PAD POSITIONER This document contains information on a new product. Specifications and information are subject to change without notice WJ Communications, Inc • Phone 1-800-WJ1-4401 • FAX: 408-577-6620 • e-mail: [email protected] • Web site: www.wj.com May 2002