Mimix CMM3566-LC-0000 3.4 to 3.5 ghz, 7.0v, 24 dbm w-cdma power amplifier Datasheet

3.4 to 3.5 GHz, 7.0V, +24 dBm
W-CDMA Power Amplifier
August 2007 - Rev 02-Aug-07
CMM3566-LC
Features
Functional Block Diagram
7.0V Bias Voltage
+24 dBm Linear Output Power (W-CDMA)
30 dB Gain at Operating Output
Tested Under Digital Modulation (W-CDMA)
Leadless Chip Carrier (LCC) Package
Ground Tab
8 RF OUT/+Vd3
Vg3 1
General Description
The CMM3566-LC is a 7.0V, +24 dBm, linear power amplifier
intended for use in PCS handsets and wireless local loop
subscriber units and base stations. The amplifier is biased to meet
the requirements of linear modulation systems of W-CDMA. The
CMM3566-LC is packaged in a low-cost, space efficient, power
package that provides excellent electrical stability and low
thermal resistance. The part requires minimal external circuitry for
bias and matching to reduce space and cost.
Vg2 2
7 RF OUT/+Vd3
Vg1 3
6 Vd2
RF IN 4
5 Vd1
Ground Tab
Applications
Wireless Local Loop Subscriber Units
Wireless Local Loop Base Stations
Absolute Maximum Ratings
Parameter
Rating
Parameter
Rating
Parameter
Rating
Drain Voltage (+Vd)
Drain Current (Id)
RF Input Power
DC Gate Voltage (-Vg)
+8 V*
1.0 A
0 dBm*
-4.0 V*
Power Dissipation
Thermal Resistance
Storage Temperature
BVGD
5W
20°C/W
-65°C to +150°C
18 V
Operating Temperature
Channel Temperature
Soldering Temperature
-30°C to +90°C
150°C
240°C for 5 Sec.
* Max (+Vd ) and (-Vg ) under linear operation. Max potential difference across the device at 1dB gain compression point (2Vd +|-Vg1) not to exceed the minimum breakdown voltage (BVGD ) of +18V.
Recommended Operating Conditions
Parameter
Typ
Units
Parameter
Typ
Units
Drain Voltage (+Vd)
7.0
Volts
Operating Temperature (PC Board)
-40 to +70
°C
Application Information
The CMM3566-LC is a three stage amplifier that requires a
positive and a negative supply voltages for proper operation. It is
essential when turning on the device that the negative supply be
applied before the positive supply. When turning the device off,
the positive supply should be removed before the negative supply
is removed.
The CMM3566-LC can be operated over a range of supply
voltages and bias currents. It is important that the maximum power
dissipation specification for the package be observed at all times
and that the maximum voltage across the device not be exceeded.
Circuit Design Considerations
Biasing Three negative voltages are needed to set the bias current
of the 3-stage GaAs FET power amplifier. The first stage bias is
controlled via Vg1. The second stage bias is controlled via Vg2.
The output stage is controlled via Vg3. The recommended divider
networks for each gate bias shown in the schematic. The positive
supply voltage is applied to pins 5, 6, 7 and 8. The negative voltage supplies control the quiescent current of the device. The quiescent current needs to be set at the level specified in order to get the
guaranteed RF performances.
Negative bias voltages can also be used to control the gain,
the output power and the operating current during operation of the
device.
Matching Circuits Output matching circuit is required to achieve
the output power and gain guaranteed. Mimix’s recommendation for the topology of the matching circuit is shown in the
schematic diagram of the test circuit in this data sheet.
In providing both the negative and positive bias voltages, it is
important to provide adequate de-coupling between the RF signal
and the DC voltages. Inadequate de-coupling could result in low
output power, low gain or oscillation. Mimix recommends the
bias circuits shown in the evaluation circuit .
– Continued on Page 2 –
Mimix Broadband, Inc., 10795 Rockley Rd., Houston, Texas 77099
Tel: 281.988.4600 Fax: 281.988.4615 mimixbroadband.com
Page 1 of 4
Characteristic Data and Specifications are subject to change without notice. ©2007 Mimix Broadband, Inc.
Export of this item may require appropriate export licensing from the U.S. Government. In purchasing these parts, U.S. Domestic customers accept
their obligation to be compliant with U.S. Export Laws.
3.4 to 3.5 GHz, 7.0V, +24 dBm
W-CDMA Power Amplifier
August 2007 - Rev 02-Aug-07
CMM3566-LC
Electrical Characteristics
Unless otherwise specified, the following specifications are guaranteed at 3.45 GHz, room temperature with drain voltage (+Vd) = 7.0V in Mimix test fixture.
Parameter
Condition
Frequency Range
Gain
Gain Variation
Min
3.4
26
@ Digital power output
Over supply voltage
Over temperature
2nd (Pout = +22 to +26 dBm)
3rd (Pout = +22 to +26 dBm) and above
±2.7 MHz from carrier
(Pout = +22 dBm, Data Rate = 4.096Mc/Sec
±5.25 MHz from carrier
(Pout = +22 dBm, Data Rate = 4.096Mc/Sec
±2.7 MHz from carrier
(Pout = +24 dBm, Data Rate = 4.096Mc/Sec
±5.25 MHz from carrier
(Pout = +24 dBm, Data Rate = 4.096Mc/Sec
10 MHz Bandwidth
Vdd = 7.0 V
Harmonics*
Linear Output Power
Linear Output Power
Wideband Noise
Noise Figure
Return Loss Input
Return Loss Output
Positive Supply Current (Id)
Quiescent Current (Iq)
Negative Supply Current (-Ig)
Max
3.5
31
Pout = +24 dBm
No RF
Includes external resistor divider
Into external resistor divider
-0.3
Units
28.5
2
0.03
-35
-40
-43
-30
-35
-40
GHz
dB
dB/V
dB/°C
dBc
dBc
dBc/30 KHz
-50
-48
dBc/30 KHz
-38
-35
dBc/30 KHz
-47
-45
dBc/30 KHz
5
-14
-14
540
520
2.0
4.0
dBc
dB
dB
dB
mA
mA
mA
-1.5
-3.0
V
-68
-10
-10
Negative Supply Voltage (-Vg)
Typ
* The integrity of the input signal at an offset of 5.25 MHz has an adjacent channel performance of not greater than -52 dBc.
– Continued from Page 1 –
Thermal
Modulation When biased as specified, the CMM3566-LC will
achieve the required adjacent channel response for the W-CDMA
linearity. Mimix tests each product under digital modulation to
ensure compliance to system specifications.
1. The copper pad on the backside of the CMM3566-LC must be
soldered to the ground plane.
S-Parameters
Vdd = 7V, ID 1 & 2 = 200, ID 3 = 300
Frequency
(GHz)
0.6
0.8
1.0
1.2
1.4
1.6
1.8
2.0
2.2
2.4
2.6
2.8
3.0
3.2
3.4
3.6
3.8
4.0
S11
S21
S12
S22
Mag
ANG
Mag
ANG
Mag
ANG
Mag
ANG
0.646
0.659
0.732
0.778
0.781
0.751
0.770
0.770
0.781
0.772
0.757
0.640
0.447
0.516
0.518
0.131
0.423
0.578
136.623
54.979
-19.826
-82.663
-140.684
155.653
14.916
11.996
-40.876
-81.765
-121.242
176.329
86.466
0.714
-69.213
-149.583
-13.907
-59.337
2.393
1.283
5.119
8.080
10.458
12.110
11.272
11.158
11.715
15.438
21.302
27.182
29.193
28.413
25.542
24.348
19.130
14.619
20.992
17.015
-67.405
-171.314
93.318
-2.432
-176.757
-179.876
106.441
32.091
-51.262
-150.627
105.943
4.707
-94.768
164.543
58.878
-37.638
0.002
0.003
0.004
0.005
0.005
0.007
0.006
0.006
0.007
0.008
0.010
0.011
0.010
0.011
0.010
0.012
0.011
0.008
-19.228
-80.195
-158.535
132.866
67.738
0.028
-124.480
-126.766
173.071
128.121
68.938
-13.377
-79.627
-137.593
152.682
93.523
18.708
-52.138
0.804
0.682
0.420
0.382
0.533
0.650
0.874
0.880
0.911
0.877
0.771
0.756
0.690
0.471
0.383
0.268
0.257
0.278
-23.817
-89.402
-138.407
-152.437
150.599
69.917
-61.986
-63.734
-116.517
-177.609
103.364
13.731
-53.854
-91.983
-99.415
-121.022
-98.953
-134.978
Mimix Broadband, Inc., 10795 Rockley Rd., Houston, Texas 77099
Tel: 281.988.4600 Fax: 281.988.4615 mimixbroadband.com
Page 2 of 4
Characteristic Data and Specifications are subject to change without notice. ©2007 Mimix Broadband, Inc.
Export of this item may require appropriate export licensing from the U.S. Government. In purchasing these parts, U.S. Domestic customers accept
their obligation to be compliant with U.S. Export Laws.
3.4 to 3.5 GHz, 7.0V, +24 dBm
W-CDMA Power Amplifier
August 2007 - Rev 02-Aug-07
CMM3566-LC
Typical Performance
G ai n and R eturn L oss vs F requency
L i near O utput Power vs F requency
Id & Adjacent Channel Power vs Output Power
(2.7 MHz from Carrier)
Id & Adjacent Channel Power vs Output Power
(5.25 MHz from Carrier)
Mimix Broadband, Inc., 10795 Rockley Rd., Houston, Texas 77099
Tel: 281.988.4600 Fax: 281.988.4615 mimixbroadband.com
Page 3 of 4
Characteristic Data and Specifications are subject to change without notice. ©2007 Mimix Broadband, Inc.
Export of this item may require appropriate export licensing from the U.S. Government. In purchasing these parts, U.S. Domestic customers accept
their obligation to be compliant with U.S. Export Laws.
3.4 to 3.5 GHz, 7.0V, +24 dBm
W-CDMA Power Amplifier
August 2007 - Rev 02-Aug-07
CMM3566-LC
Recommended Matching Topology
Note: This schematic represents the topology of the matching circuit recommended by Mimix.
Physical Dimensions
Ordering Information
The CMM3566-LC is available in a surface mount plastic LCC-8 package and devices are available in tube or tape and reel.
Part Number for Ordering
Package
CMM3566-LC-0000
CMM3566-LC-000T
PB-CMM3566-LC-0000
LCC-8 surface mount power package
LCC-8 surface mount power package in tape and reel
Evaluation Board with SMA connectors for CMM3566-LC
Mimix Broadband, Inc., 10795 Rockley Rd., Houston, Texas 77099
Tel: 281.988.4600 Fax: 281.988.4615 mimixbroadband.com
Page 4 of 4
Characteristic Data and Specifications are subject to change without notice. ©2007 Mimix Broadband, Inc.
Export of this item may require appropriate export licensing from the U.S. Government. In purchasing these parts, U.S. Domestic customers accept
their obligation to be compliant with U.S. Export Laws.
Similar pages