1. SPECIFICATIONS OF IN SERIES Vertical Surface Mounting Devices New Products New SV New SV Series is designed for use in high frequency noise limiters and switching power supplies for miniaturization ; compatible with Aluminum electrolytic capacitors of Vertical chip. Series Marking (Purple) Specifications 1. 2. 3. 4. 5. 6. Items Operating temperature range Capacitance tolerance (120Hz) Tangent of loss angle(tanδ) (120Hz) Leakage current (µA/2min.)(or less) *1 ESR (100k to 300kHz) Temperature characteristics Impedance ratio at 100kHz., +20°C 7. High-temperature load 105°C, 1,000Hrs. Rated voltage applied *2 (25WV→20V applied) 8. Moisture resistance (60°C, 90 to 95%RH, 500Hrs. no voltage) 9. Reverse voltage guarantee 10.Solder heat resistance (Hot plate soldering method) (240°C X 30sec.) *3 : Polarity( ), Rated voltage, Capacitance, Lot.No. Characteristics -55°C to +105°C M : ±20% Value in Table 8 or less 0.2CV Value in Table 8 or less 1.0 to 1.25 -55°C Z / Z20°C 0.75 to 1.0 Z / Z20°C +105°C A5, B5, C6 size Within ±30% ∆C/C E7, F8, F12 size Within ±20% 1.5 times of Item 3 or less tanδ Item 4 or less Leakage current Within ±20% ∆C/C 1.5 times of Item 3 or less tanδ Item 4 or less Leakage current Temporary:less than 20% of the rated voltage, Continuous:less than 10% of the rated voltage Within ±10% ∆C/C 1.5 times of Item 3 or less tanδ Item 4 or less Leakage current *1 If any doubt arises, measure the current after applying voltage (voltage treatment) for 120 minutes at 105°C. The rated voltage should be applied for 2.0 to 20WV, while a temperature reduction voltage should be applied for 25WV. *2 To use an OS-CON when the operating temperature exceeds 85°C on a component with a rated voltage of 25V, reduce the voltage by 0.25V for every degree (1°C) relative to the value at 85°C (25V). *3 Reflow soldering may bring about change of nominal capacitance. Refer to SANYO about soldering spec. Dimensions (unit : mm) 0.2max. W Size Code H P C φD R L Size List WV (SV) µF 3.3 4.7 6.8 10 15 22 27 33 39 47 56 68 82 100 120 150 220 270 330 470 680 820 2.0 (2.6) φD+ +0.1 W±0.2 H±0.2 C±0.2 L 0.5max. -0.4 4.0 5.4 4.3 4.3 5.0 0.5 to 0.8 1.0 B6 5.0 5.9 5.3 5.3 6.0 0.5 to 0.8 1.4 C6 6.3 5.9 6.6 6.6 7.3 0.5 to 0.8 2.1 E7 8.0 6.9 8.3 8.3 9.0 0.5 to 0.8 3.2 F8 10.0 7.9 10.3 10.3 11.0 0.5 to 0.8 4.6 F12 10.0 12.6 10.3 10.3 11.0 0.8 to 1.1 4.6 20 (23) 25 (25) B6 E7 C6 F8 E7 F12 A5 A5 A5 A5 A5 B6 B6 C6 B6 B6 C6 E7 C6 F8 C6 E7 F8 E7 E7 F8 F12 F12 F8 F8 F12 F12 F12 F12 30 P±0.2 A5 WV : Rated voltage (SV) : Surge voltage(room temperature) 4.0 6.3 10 16 (5.2) (8.2) (11.5) (18.4) A5 R 1. SPECIFICATIONS OF IN SERIES Table 8 New SV Series Characteristics List Size Code A5 B6 Rated Voltage (V) Part Number *1 F12 *1 *2 *3 Tangent of loss angle (max.) Leakage current (µA) (max.)*3 16 3.3 400 500 0.07 10.6 10 4.7 400 540 0.08 9.4 10SV6R8MN 10 6.8 10SV10MN 10 400 540 0.09 13.6 10 350 560 0.10 20.0 6SV15MN 6.3 15 350 560 0.12 18.9 4SV22MN 4 22 350 560 0.15 17.6 20SV10M 20 10 220 600 0.10 40.0 16SV15M 16 15 200 650 0.10 48.0 10SV22M 10 22 180 700 0.15 44.0 6.3 33 140 750 0.15 42.0 4SV39M 4 39 120 780 0.15 31.0 20SV22M 20 22 80 1050 0.10 88.0 16SV27M 16 27 80 1100 0.10 86.0 10SV47M 10 47 70 1150 0.15 94.0 6.3 56 70 1200 0.15 71.0 4SV82M 4 82 65 1250 0.15 66.0 25SV10M 25 10 60 1400 0.12 50.0 20SV47M 20 47 60 1450 0.12 188.0 16SV56M 16 56 60 1500 0.12 179.0 10SV82M 10 82 55 1550 0.15 164.0 6.3 120 50 1600 0.15 151.0 4SV150M 4 150 50 1700 0.15 120.0 25SV22M 25 22 50 1800 0.12 110.0 20SV68M 20 68 45 2000 0.12 272.0 16SV100M 16 100 45 2200 0.12 320.0 10SV150M 10 150 40 2400 0.15 300.0 6SV120M F8 Maximum allowable ripple current (mArms)*2 10SV4R7MN 6SV56M E7 ESR (100kHz to 300kHz) (mΩ) (max.) 16SV3R3MN 6SV33M C6 Nominal Capacitance (µF) 6SV220M 6.3 220 40 2700 0.15 277.0 4SV270M 4 270 40 2800 0.15 216.0 25SV47M 25 47 25 3500 0.10 235.0 20SV150M 20 150 20 3600 0.10 600.0 16SV220M 16 220 18 3700 0.12 704.0 10SV330M 10 330 16 3800 0.15 660.0 6SV470M 6.3 470 15 4000 0.15 592.0 4SV680M 4 680 13 4200 0.15 544.0 2SV820M 2 820 12 4400 0.15 328.0 Capacitance tolerance : M ; ±20% 100kHz, +45°C After 2 minutes Temperature coefficient for ripple current Ambient Temp.(°C) to +45 +65 +85 Coefficient 1.0 0.85 0.7 Note: +95 0.4 Former SV series appeared in the OS-CON technical book version 5.2 has been integrated into New SV series, size A5. Please order it as New SV series. Additionally, part numbers of New SV series, size A5 have “N” in the end to distinguish themselves from former SV series. +105 0.25 Recommended land pattern dimension of PWB C Code (unit : mm) Size Code A5 B6 C6 E7 F8 a a 1.0 1.4 2.1 2.8 4.3 4.3 b b 6.2 7.4 9.1 11.1 13.1 13.1 c 1.6 1.6 1.6 1.9 1.9 1.9 *New SV series is a new product. Therefore, the specification, dimension may be changed. 31 F12