8 Pin Single-in Line Passive Delay Lines ELECTRONICS INC. EP123XXX & EP123XXX-RC Add “-RC” after part number for RoHS Compliant PCA Part Number Zo Ω (± 10%) EP123101(-RC) EP123102(-RC) EP123103(-RC) EP123104(-RC) EP123105(-RC) EP123106(-RC) EP123107(-RC) EP123108(-RC) EP123109(-RC) EP123110(-RC) EP123111(-RC) EP123112(-RC) EP123113(-RC) EP123114(-RC) EP123115(-RC) EP123116(-RC) EP123117(-RC) EP123118(-RC) 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 Delays (nS) Rise Time (nS Max.) Zo Ω (± 10%) EP123119(-RC) EP123120(-RC) EP123121(-RC) EP123123(-RC) EP123125(-RC) EP123127(-RC) EP123129(-RC) EP123131(-RC) EP123133(-RC) EP123135(-RC) EP123137(-RC) EP123139(-RC) EP123141(-RC) EP123146(-RC) EP123151(-RC) EP123156(-RC) EP123161(-RC) EPA594(-RC) 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 [Calculated] DC Electrical Characteristics Distortion Temperature Coefficient of Delay Insulation Resistance @ 100 Vdc Dielectric Strength 0.0 ± 0.25 0.5 ± 0.25 1.0 ± 0.25 1.5 ± 0.25 2.0 ± 0.25 2.5 ± 0.25 3.0 ± 0.25 3.5 ± 0.25 4.0 ± 0.25 4.5 ± 0.25 5.0 ± 0.25 5.5 ± 0.25 6.0 ± 0.25 6.5 ± 0.25 7.0 ± 0.25 7.5 ± 0.25 8.0 ± 0.25 8.5 ± 0.25 Min. ----1000 --- Pulse Width % of Total Delay Duty Cycle Operating Free-Air Temperature 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.1 1.2 1.3 1.4 1.5 1.6 1.7 1.8 Max. 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 Max. Unit 40 +70 % % °C 0 9.0 ± 0.25 9.5 ± 0.25 10.0 ± 0.25 11.0 ± 0.25 12.0 ± 0.25 13.0 ± 0.25 14.0 ± 0.25 15.0 ± 0.25 16.0 ± 0.25 17.0 ± 0.25 18.0 ± 0.25 19.0 ± 0.25 20.0 ± 0.50 25.0 ± 0.50 30.0 ± 0.50 35.0 ± 0.50 40.0 ± 0.50 45.0 ± 1.00 Rise Time (nS Max.) DCR (Ω Max.) 1.9 2.0 2.0 2.2 2.3 2.5 2.6 2.8 3.0 3.2 3.4 3.6 3.8 4.5 5.5 6.4 7.4 8.0 1.0 1.0 1.0 2.0 2.0 2.0 2.0 2.0 2.5 2.5 2.5 2.5 2.5 4.0 4.5 5.5 6.0 6.5 Schematic In/Out 2 % PPM/°C Meg Ω Vdc 200 Delays (nS) [Calculated] Unit ± 10 100 --100 Recommended Operating Conditions Min. PW* D* TA PCA Part Number DCR (Ω Max.) In/Out 7 1 Ground 8 Package Pin 1 I.D. (On Top) *These two values are inter-dependent. .200 Max. (5.08) .800 (20.32) .020 Input Pulse Test Conditions @ 25° C VIN PW TRI PRR Pulse Input Voltage Pulse Width % of Total Delay Input Rise Time (10-90%) Pulse Repetition Rate @ Td ≤ 150 nS Pulse Repetition Rate @ Td > 150 nS .250 Max. (6.35) Unit 3.0 300 2.0 1.0 300 Volts % nS MHz KHz 5.0 nS .120 Typ. PCA EP123111 Min. (.508) Date Code G In Out G (3.05) .020 Typ. (.508) Notes : .500 (12.70) .100 Typ. (2.54) EP123XXX EP123XXX-RC 1. Lead Finish SnPb Hot Tin Dip (Sn) 2. Peak Temperature Rating 260°C 260°C .010 Typ. (.254) .125 Typ. (3.18) (Wave Solder Process Only) 4. Weight 5. Packaging Information (Tube) 0.9 grams 0.9 grams TBD pieces/tube TBD pieces/tube Unless Otherwise Specified Dimensions are in Inches /mm ± .010 /.25 PCA ELECTRONICS, INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 Product performance is limited to specified parameters. Data is subject to change without prior notice. CS123XXX & -RC Rev. 1 8/17/06 RR TEL: (818) 892-0761 FAX: (818) 894-5791 http://www.pca.com