Gamewell-FCI MBB-6 Multi-mod relay output Datasheet

Velociti™ Series
MM0-6RF
Multi-Mod Relay
Output Module
Description
The FCI Velociti™ Series, multi-mod six relay output
module (MMO-6RF) provides six (6), Form “C” control
relay outputs on one board. Its compact design affords
ease of installation while using a minimum of wall space.
The VelocitiTM Series use a communication protocol that
substantially increases the speed of communication between the sensors and certain FCI analog addressable
fire alarm controls. These devices operate in a grouped
fashion. If one of the devices in the group has a status
change, the panel’s microprocessor stops the group poll
and concentrates on the single device. The net effect is
response speed up to five times greater than earlier designs.
The MMO-6RF connects to the signaling line circuit
(SLC) of the FCI analog addressable series fire alarm
control panels. Each relay circuit on the MMO-6RF occupies its own address on the control panel’s SLC and can
be programmed to respond to its own individual controlby-event sequence of operation. The address of the first
relay is set by a pair of rotary code switches on the
MMO-6RF. Each remaining relay circuit is automatically
assigned to its own subsequent address.
The MMO-6RF module includes an address disable
switch that allows one, two, or three addresses to be
turned off to free these addresses for other purposes.
Each relay has its own status LED that flashes to indicate proper polling and lights steady when the circuit has
been activated.
Two (2), multi-mod series units can be mounted in one
MBB-2 cabinet. Additional mounting options include the
MCH-6 chassis that can accommodate six (6), multi-mod
series modules. The MCH-6 chassis can be installed in
custom cabinets or mounted in the MBB-6 cabinet.
The multi-mod series is ideal for applications where centralized location of circuits is required. As many as thirtysix (36), Form “C” relays may be located in a cabinet that
is only 12.63” H x 24” W x 6.5” D in dimension saving
valuable wall space in mechanical rooms and electrical
closets and reducing cost of installation.
MMO-6RF
Features
• Each module provides six (6), individually addressed,
individually programmable form “C” relays.
• Removable wiring terminal blocks allow ease of
installation and servicing.
• Terminal blocks can accommodate 12 to 18 AWG wire.
• Flexible jumper configuration feature allowing up to
three relay addresses to be disabled.
• A wide range of contact ratings.
• Designed for FCI analog addressable series fire
alarm control panels.
• Individual LED indicators*.
• Suitable for retrofit applications.
• Ideal for applications such as elevator control, AHU
control, door holder release or similar functions
requiring multiple relay outputs.
• Two (2), mounting cabinets available for two (2),
(MBB-2 cabinet) to six (6), (MBB-6 cabinet) units.
Note: Only the red LED is operative in panels that do not operate in Velociti™ mode.
An ISO 9001-2000 Company
Velociti™ and E3 Series™ are trademarks of Fire Control Instruments.
GAMEWELL-FCI
12 Clintonville Road, Northford, CT 06472 - Tel: (203) 484-7161 - Fax: (203) 484-7118
Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use.
www.gamewell-fci.com
9020-0632 Rev. B page 1 of 2
©2006 Gamewell-FCI. All rights reserved.
Specifications
Ordering Information
Operating
Voltage:
Stand-by
Current:
Alarm Current:
Model
Description
MMO-6RF
MBB-2
MBB-6
MCH-6
Multi-mod relay output
Backbox, 2 unit
Backbox, 6 unit, requires MCH-6
6-Unit mounting chassis
Relay Current:
Relay Contact
Ratings:
Temperature
Range:
Humidity
Dimensions:
MBB-2
MBB-6
15-32 VDC
1.45 mA
32 mA (with all six relays activated
and all six LEDs lit)
30 mA/ relay pulse
(see below)
32˚ F to 120˚ F (0˚ to 49˚ C)
10 to 85% (non-condensing)
6.8” H x 5.8” W x 1.0” D
(17.3 x 14.7 x 2.5 cm)
12.25” H x 9.25” W x 3.32” D
(31.1 x 23.5 x 8.4 cm)
12.63” H x 24” W x 6.5” D
(32.1 x 60.1 x 16.5 cm)
Contact Ratings
Current
Rating
3A
2A
1A
Maximum
Voltage
30 VDC
30 VDC
30 VDC
0.5A
30 VDC
0.9A
0.9A
0.7A
110 VDC
125 VAC
70.7 & VAC
0.5A
125 VAC
Load
Description
Resistive
Resistive
Inductive
(L/R= 2ms)
Inductive
(L/R= 5ms)
Resistive
Resistive
Inductive
(PF= 0.35)
Inductive
(PF= 0.35)
Application
Non-coded
Coded
Coded
Coded
Non-coded
Non-coded
Non-coded
Non-coded
GAMEWELL-FCI
12 Clintonville Road, Northford, CT 06472 - Tel: (203) 484-7161 - Fax: (203) 484-7118
www.gamewell-fci.com
9020-0632 Rev. B page 2 of 2
Similar pages