FPI-W MPI-W MINIBRIDGE 40/50 AMPERES BRIDGE RECTIFIERS WIRE LEADS FOR PC BOARDS Y MOLDED INTEGRALL S HEAT SINK RY LOW VE E PROVID ESISTANCE R L THERMA This mark indicates recognition under the component program of Underwriters Laboratories, inc. ELECTRICAL CHARACTERISTICS PER LEG (at TA =25 OC Unless Otherwise Specified) SERIES DESIGNATIONS (See MPI40-W MPI50-W UNITS 40 40 50 Amps 300 400 400 Amps 20 35 45 Amps 10 10 10 A 100 100 100 A FPI40-W o Average Forward Current, I F(Av.) TC 55 C See Figure 3 Max. Peak Surge Current, I FSM (8.3 ms) See Figure 2 Max. Instantaneous Forward Voltage Drop, V F =1.2V @ IF = Pulse T est: Pulse Width <300 S. Duty cycle < 2.0% O Max. D.C. Reverse Current @ PRV and 25 C, I R O Max. D.C. Reverse Current @ PRV and 100 C, I R Thermal Resistance, Total Bridge R0- j-c Storage Temperature Range, TSTG Figure 1) 1.2typ. -55 to +175 EDI reserves the right to change these specifications at any time without notice. o C/ W o C FPI-W MPI-W AVERAGE FORWARD CURRENT RATING (AMPERES) Figure 1 PART NUMBER NOMENCLATURE PEAK REVERSE VOLTAGE(PRV/LEG) 50 VOLTS 100 VOLTS 200 VOLTS 400 VOLTS 600 VOLTS 800 VOLTS 1000 VOLTS 40AMPS FPI4005W FPI4010W FPI4020W FPI4040W FPI4060W FPI4080W FPI40100W 40AMPS MPI4005W MPI4010W MPI4020W MPI4040W MPI4060W MPI4080W MPI401000W 50AMPS MPI5005W MPI5010W MPI5020W MPI5040W MPI5060W MPI5080W MPI50100W Figure 2 NON-REPETITIVE SURGE L l F(AV) . AVERAGE FORWARD CURRENT( AMP) MAX. PEAK SURGE CURRENT IFSM 1000 800 600 400 MPI-W 200 FPI-W 100 80 60 40 1 3 2 4 6 8 10 Figure 3 CURRENT DERATING CURRENT 20 40 60 50 40 30 FP M P I4 0W I40 W 20 10 0 60 80 100 40 60 80 100 MP 120 I5 0W 140 160 Tc CASE TEMPERATURE ( C) O NUMBER OF CYCLES AT 60 CPS NOTE: For large capacitive load derate by up to 20% PI SERIES MECHANICAL OUTLINE Dielectric test voltage 2500 volts rms, max. 50-60Hz .193 DIA THRU HOLE 1.125 .712 AC AC .450 NOTE: EPOXY CASE + 1.125 .712 .040 DIA. 1.2 MIN. + . 405 MAX METAL HEAT SINK A thin film of silicone thermal compound is recommended between the Minibridge case and mounting surface for improved thermal conduction. Higher dielectric strengths available. Consult factory. R ELECTRONIC DEVICES, INC. DESIGNERS AND MANUFACTURERS OF SOLID STATE DEVICES SINCE 1951. 21 GRAY OAKS AVENUE * YONKERS. NEW YORK 10710 914-965-4400 Ee-mail:[email protected] * Wwebsite: http://www.edidiodes.com * FAX 914-965-5531 * 1-800-678-0828 180