○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ PSA-25 Series Switching Power Supply V DE Features • 100% Burn-in • Low output ripple • Built-in EMI filter • Short circuit protection • High efficiency • Over voltage protection Applications • Microcomputers • Peripheral equipment • Small drive systems • Test equipment Safety Compliance • UL 1950 [E134610] • VDE 0805/IEC 950 [74711] • CSA 22.2 234 [LR 56927-137] Mechanical Characteristics Dimensions: • Length: 101.6mm (4.0in) • Height: 33mm (1.3in) • Width: 76.2mm (3.0in) • Weight: 0.25kgs (0.55Ibs) Output Specifications Model PSA-25-105 PSA-25-112 PSA-25-115 PSA-25-124 PSA-25-301 PSA-25-303 PSA-25-305 DC Output Load Ripple Total Output Voltage Min. Max. @20CFM Peak P-P Tolerance Pins +5V +12V +15V +24V +5.1V +12V -12V +5.1V +12V -5V +5.1V +15V -15V 0.0A 0.0A 0.0A 0.0A 0.3A 0.1A 0.0A 0.3A 0.1A 0.0A 0.3A 0.1A 0.0A 4.0A 2.0A 1.6A 1.1A 2.0A 1.0A 0.3A 2.0A 1.0A 0.3A 2.0A 0.7A 0.3A 6.0A 3.2A 2.5A 1.8A 3.0A 1.5A 0.5A 3.0A 1.5A 0.5A 3.0A 1.2A 0.5A 50mV 120mV 150mV 240mV 50mV 120mV 120mV 50mV 120mV 50mV 50mV 150mV 150mV +2% +2% +2% +2% +2% +5% +5% +2% +5% +5% +2% +5% +5% 1,2 1,2 1,2 1,2 2,3 1 6 2,3 1 6 2,3 1 6 8.0A 4.0A 3.5A 2.0A 5.0A 2.0A 0.5A 5.0A 2.0A 0.5A 4.0A 1.2A 1.0A (1) Total output power must not exceed 25W at convection cooling and 40W at 20CFM air flow condition. (2) Peak output current lasting less than 30 seconds with duty cycle less than 10%. During peak loading, peak total power must not exceed 40W. (3) Ripple & noise is measured at 20MHz bandwidth limit by use a 10 inch twisted wire terminated with a 10µf capacitor in parallel 0.1µf ceramic capacitor. PHIHONG 25W Universal Input Series ISO 9001 • BABT • MITI Facility Approvals 25W Universal Input Series ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ PSA-25 Switching Power Supply Characteristics AC input Voltage 90VAC-260VAC AC Frequency 47 to 63Hz AC Input Current 0.8A(rms) for 115VAC 0.4A(rms) for 230VAC DC Output See Chart Efficiency 70% typical at full load Hold-up Time 16msec. at full load, 115VAC input Overvoltage Protection 5.6V to 6.5V on main output ENTERPRISE CO., LTD. 16, Lane 530, Chung Cheng N. Rd. Sanchung City, Taipei Taiwan 24103, R.O.C. Phone: 886-2-988-2126 886-2-980-5255 Fax: 886-2-981-7086 886-2-983-3222 Overcurrent Protection All outputs equipped with automatic recovery current limiting circuit Operation Temperature 0 to +40˚C Temperature Coefficient 0.04% per ˚C Storage Temperature -25˚C to +85˚C Insulation Resistance 50M ohm min. from input to output, input to ground MTBF Calculated Greater than 100,000 hours, (MIL-HDBK-217) Emissions FCC Class B EN 50081-1: EN 55022 B Immunity EN 50082-1:IEC 801-2 Level 3 IEC 801-3 Level 2 IEC 801-4 Level 2 Dimension Diagram Unit: mm (inch) PHIHONG USA C O R P O R A T I O N U.S. Headquaters: 48607 Warm Springs Blvd. Fremont, CA 94539 Phone: (510) 445-0100 Fax: (510) 445-1678 Email: [email protected] Internet: http://www.phihongusa.com Eastern Office: Southwestern Office: 3325 Cochran St., Suite 200 Simi Valley, CA 93063 Phone: (805) 520-8177 Fax: (805) 520-3907 Mating: 09-50-3061 Output Connections: (Multiples) Pins 1,2,3,6 - See chart on front Pins 4,5 Common return CN1: 09-50-3031 Mating: 09-50-3041 Output Connections: (Singles) Four pin connector Pins 1,2 - Positive Pins 3,4 - Return 25/704 3005 Brodhead Road Bethlehem, PA 18017 Phone: (610) 866-9911 Fax: (610) 866-9920