30 Watts, 50 Ω General Specifications Resistive Element: Substrate: Terminals: Thick film Aluminum nitride ceramic Tin/Lead, 90/10 over nickel Electrical Specifications Resistance Value: Frequency Range: Power: V.S.W.R.: Features • DC – 3.0 GHz • 30 Watts • Aluminum Nitride (AlN) Ceramic • Terminal for Lead Attachment • Non-Nichrome Resistive Element Aluminum Nitride Chip Terminations Model RFP-100200N4X50-2 Aluminum Nitride Terminations 50 ohms, ±2% DC - 3.0 GHz 30 Watts 1.25:1 Notes: Tolerance is ±.010, unless otherwise specified. Operating temperature is -55°C to +150°C (see chart). Designed to meet or exceed applicable portions of MIL-E-5400. All dimensions are in inches. Specifications subject to change without notice. • Low VSWR • 100% Tested Outline Drawing SIDE VIEW TOP VIEW .100 .040 .200 .030 HATCHED AREA INDICATES PROTECTIVE COATING VER. 12/5/01 Available on Tape and Reel for Pick and Place Manufacturing. Sales Desk USA: Voice: (800) 544-2414 Fax: (315) 432-9121 Sales Desk Europe: Voice: (+44) 23 92 232392 Fax: (+44) 23 92 251369 1 Aluminum Nitride Chip Terminations Model RFP-100200N4X50-2 Typical Performance Suggested Mounting Procedures Power Derating % OF RATED POWER .025 MIN. (2 PLACES) 100 75 BOARD LOWER THAN LEAD. 50 SUGGESTED STRESS RELIEF METHODS 25 SCALE: NONE 0 25 50 75 100 125 CASE TEMPERATURE — °C 150 1. Make sure that the devices are mounted on flat surfaces (.001” under the device) to optimize the heat transfer. 2. Position device on mounting surface and solder in place using an SN96 type solder. 3. Solder leads in place using an SN63 type solder with a controlled temperature iron (700°F). Available on Tape and Reel for Pick and Place Manufacturing. 2 Sales Desk USA: Voice: (800) 544-2414 Fax: (315) 432-9121 Sales Desk Europe: Voice: (+44) 23 92 232392 Fax: (+44) 23 92 251369