Model RFP-150-100RCGN-S RoHS Compliant Flangeless Resistor 150 Watts, 100Ω General Specifications Resistive Element Substrate Cover Mounting Flange Lead(s) Operating Temperature Thick film Beryllium oxide ceramic Alumina ceramic Copper, nickel plated per QQ-N-290 99.9% pure silver (.005” thick) -55 to +150°C (see de rating chart) Tolerance is ±0.010”, unless otherwise specified. Designed to meet of exceed applicable portions of MIL-E-5400. All dimensions in inches. Features: • 150 Watts • DC – 2.0 GHz • Beryllium oxide Ceramic • Welded Silver Leads Electrical Specifications Resistance Value: Power: Frequency Range: Capacitance 100 Ohms, ± 5% 150 Watts DC – 2.0 GHz 3.5 pF Specification based on unit properly installed using suggested mounting instructions and a 50 ohm nominal impedance. Specifications subject to change. • Non-Nichrome Resistive Element • 100% Tested • RoHS Compliant Outline Drawing Dimensions inches 150-100RCGN-S (097) Rev B Available on Tape and Reel For Pick and Place Manufacturing. USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Model RFP-150-100RCGN-S RoHS Compliant Typical Performance: Mounting Footprint and Procedure: Derating: .025 (2 PLACES) BOARD LOWER THAN LEAD. BOARD EVEN WITH LEAD. SUGGESTED STRESS RELIEF METHODS BOARD LOWER THAN LEAD. BOARD HIGHER THAN LEAD. NOT RECOMMENDED APPLICATION SCALE: NONE SCALE: NONE SUGGESTED MOUNTING PROCEDURES: 1. MAKE SURE THAT THE DEVICES ARE MOUNTED ON FLAT SURFACES (.001" UNDER THE DEVICE) TO OPTIMIZE THE HEAT TRANSFER. 2. POSITION DEVICE ON MOUNTING SURFACE AND SOLDER IN PLACE USING AN APPROPRIATE SOLDER TYPE OR A SN96 TYPE SOLDER. 3. SOLDER LEADS IN PLACE USING SN96 TYPE SOLDER WITH A CONTROLLED TEMPERATURE IRON. KEEP LEAD LENGTH AS SHORT AS POSSIBLE USING A SUGGESTED STRESS RELIEF METHOD. 150-100RCGN-S (097) Rev B USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Available on Tape and Reel For Pick and Place Manufacturing.