GaN-SiC Pallet Amplifier RTP26010-S0 Product Features Application • Doherty amplifier design • GaN on SiC HEMT • Small and light weight • 50 Ohm Input/Output impedance matched • Highly reliable and rugged design • High efficiency, High Gain • 8W typical PAVG • WiMAX DPD amplifier • General purpose RF amplifier Description The RTP26010-S0 is designed for RF system application frequencies from 2496MHz to 2690MHz, with high gain. This Pallet Amplifier uses GaN on SiC HEMT technology which performs high breakdown voltage, high linearity, high efficiency. The RTP26010-S0 is DPD application amplifier. Electrical Specifications @ VDD=+30VDC, T=25°C, 50Ω System PARAMETER Symbol Min Typ Max Unit Frequency Range BW 2496 - 2690 MHz Output Power PAVG - 8 10 Watt Output Power @ Psat G.C.P Psat - 50 - Watt Small Signal Gain SSG 45 - - dB Small Signal Gain Flatness ΔG - ± 1.0 ±2 dB Gain Variation ΔGt ± 3.0 dB ACLR @ WiMAX 10MHz 2FA ACLR -25dBr dBr Input VSWR S11 - 1.5:1 1.7:1 - Forward Coupling FC - -30 - dB Operating Voltage VDC 28 30 - Volt Efficiency @ Pout 10Watt E 30 % ※ Test Signal Condition : WCDMA 4FA Environmental Characteristics PARAMETER Symbol Min Typ Max Unit Operating Temperature Tc -20 - +50 °C Storage Temperature Ts -30 - +60 °C Mechanical Specifications PARAMETER Value Units Limits Dimensions ( L x W x H ) 150 x 90 x 18.5 mm Max RF Connectors In/Out SMA Female RF Connector Coupling MCX Female DC Connectors / Controls Main 4Pin, Sub 6Pin Cooling External Heat sink + airflow ▪ Tel : 82-31-250-5011 ▪ All specifications may change without notice. ▪ [email protected] ▪ Version 0.3 GaN-SiC Pallet Amplifier RTP26010-S0 RF Interface Connectors Pin # Description Specifications 1 RF IN RF Input signal from TRx B’d 2 RF OUT RF Output signal to TDD switch 3 RF FWD Port RF Forward Detection signal For Feed-back Main DC Connector Pin # Description Specifications 1,2 Drive, Main Amp Stage +Vdd +28V ~ +48V 3,4 GND Ground Sub DC Connector Pin # Description Specifications 1, 2 Gain Block Amp Stage +Vgg +5V 3, 4 GND Ground 5 TDD Signal PA TDD control signal for switching gate bias 6 Temp. Monitor Reporting Temperature data [0.75V/25℃(10mV/℃)] Outline Drawing 1 ▪ Tel : 82-31-250-5011 ▪ All specifications may change without notice. ▪ [email protected] ▪ Version 0.3 GaN-SiC Pallet Amplifier S-Parameter vs. Frequency RTP26010-S0 WCDMA 4FA Signal @ 2500MHz WCDMA 4FA Signal @ 2550MHz WCDMA 4FA Signal @ 2600MHz WCDMA 4FA Signal @ 2650MHz WCDMA 4FA Signal @ 2700MHz RFHIC Corporation (RFHIC) reserves the right to make changes to any products herein or to discontinue any product at any time without notice. RFHIC do not assume any liability for the suitability of its products for any particular purpose, and disclaims any and all liability, including without limitation consequential or incidental damages. The product specifications herein expressed have been carefully checked and are assumed to be reliable. However, RFHIC disclaims liability for inaccuracies and strongly recommends buyers to verify that the information they are using is current before placing purchase orders. RFHIC products are not intended for use in life support equipment or application where malfunction of the product can be expected to result in personal injury or death. Buyer uses or sells such products for any such unintended or unauthorized application, buyer shall indemnify, protect and hold RFHIC and its directors, officers, stockholders, employees, representatives and distributors harmless against any and all claims arising out of such use. RFHIC’s liability under or arising out of damages, claims of whatsoever kind and nature which RFHIC products could cause shall be limited in amount to the net purchase price of the products sold to buyer by RFHIC. ▪ Tel : 82-31-250-5011 ▪ All specifications may change without notice. ▪ [email protected] ▪ Version 0.3