SW-110-PIN GaAs SPDT Reflective Switch with TTL/CMOS Control Input, DC-3.0 GHz Rev. V6 Features • 1 dB Compression Point: +39 dBm Typical, -8V Control • IP3: +65 dBm Typical, -8V Control • Insertion Loss: 0.45 dB Typical • Low Power Consumption • Fast Switching Speed • Hermetic Surface Mount Package • 50 Ohm Nominal Impedance • Lead-Free CR-9 Package • 260°C Reflow Compatible • RoHS* Compliant Functional Block Diagram Description M/A-COM’s SW-110-PIN is a GaAs MMIC SPDT reflective switch with an integral silicon ASIC driver. This device is in a 16 lead ceramic surface mount package. These switches exhibit excellent performance and repeatability from DC to 3.0 GHz, with very low DC power dissipation. The SW-110-PIN is ideally suited for RF/IF communications applications. Environmental screening is available. Contract the factory for information. Pin Configuration Pin No. Function Pin No. Function 1 Vee 9 RFC 2 GND 10 GND 3 GND 11 GND 4 GND 12 RF1 5 RF2 13 GND 6 GND 14 GND 7 GND 15 Vcc 8 GND 16 C1 Ordering Information Part Number Package SW-110-PIN Bulk Packaging MASW-008844-0001TB Sample Test Board Note: Reference Application Note M513 for reel size information. The metal bottom of the case must be connected to RF and DC ground. * Restrictions on Hazardous Substances, European Union Directive 2002/95/EC. 1 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice. SW-110-PIN GaAs SPDT Reflective Switch with TTL/CMOS Control Input, DC-3.0 GHz Rev. V6 Electrical Specifications: TA = 25°C1,2,3 Parameter Test Conditions Frequency Units Min Typ Max Reference Insertion Loss — DC - 0.5 GHz DC - 1.0 GHz DC - 2.0 GHz DC - 3.0 GHz dB dB dB dB — — — — — — — — 0.6 0.7 0.9 1.1 Isolation — DC - 0.5 GHz DC - 1.0 GHz DC - 2.0 GHz DC - 3.0 GHz dB dB dB dB 40 35 24 18 — — — — — — — — VSWR — DC - 0.5 GHz DC - 1.0 GHz DC - 2.0 GHz DC - 3.0 GHz Ratio Ratio Ratio Ratio — — — — — — — — 1.2:1 1.4:1 1.4:1 1.5:1 Trise, Tfall Ton, Toff Transients 10% to 90% 1.3V Control to 90/10% RF In-band (peak-peak) — — — nS nS mV — — — 12 35 30 — — — 1 dB Compression Input Power, 0.1 dB, -5V Control Input Power, 1.0 dB, -5V Control Input Power, 0.1 dB, -8V Control Input Power, 1.0 dB, -8V Control 0.9 GHz 0.9 GHz 0.9 GHz 0.9 GHz dBm dBm dBm dBm — — — — +32.5 +32.5 +32.5 +39.5 — — — — Input IP3 For two-tone Input power up to +10 dBm -5V Control -8V Control 0.9 GHz 0.9 GHz dBm dBm — — +61 +65 — — — — V V 4.5 -8.0 5.0 — 5.5 -5.0 Vcc Vee Icc Vcc = 4.5 to 5.5V Vctl = 0 to 0.8V, or VCC - 2.1V to VCC — mA — — 1.0 Iee Vee = -5.0 to –8.0V — mA — — 1.0 Vctl Vctl Logic 0 (TTL) Logic 1 (TTL) — — V V 0.0 2.0 — — 0.8 5.0 Input Leakage Current (Low) 0 to 0.8V — µA — — 1.0 Input Leakage Current (High) 2.0 to 5.0V — µA — — 1.0 1. All specifications apply when operated with bias voltages of +5V for Vcc and –5.0V to –8.0V for Vee, and 50 Ohm impedance at all RF ports unless otherwise specified. 2. For this switch to meet the guaranteed specifications, it is necessary to have a DC return on either RF1 or RF2. The DC return can be either a 10k Ohm resistor, or an RF choke. 3. High Power (greater than 1W) handling specifications apply to cold switching only. For input powers under 1W, hot switching can be used. 2 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice. SW-110-PIN GaAs SPDT Reflective Switch with TTL/CMOS Control Input, DC-3.0 GHz Rev. V6 Absolute Maximum Ratings 4,5 Parameter Max Input Power 0.05 GHz 0.5 - 3.0 GHz -5V Control -8V Control 4. 5. 6. 7. 8. Absolute Maximum +35 +36 +39 Power Dissipation 6,7 2.0W VCC -0.5V ≤ VCC ≤ +7.0V VEE -8.5V ≤ VEE ≤ +0.5V VCC - VEE -0.5V ≤ VCC - VEE ≤ 14.5V Vin8 -0.5V ≤ Vin ≤ VCC + 0.5V Operating Temperature -55°C to +125°C Storage Temperature -65°C to +150°C Junction Temperature +175°C Thermal Resistance θjc +50°C/W Exceeding any one or combination of these limits may cause permanent damage to this device. M/A-COM does not recommend sustained operation near these survivability limits. Tcase = 25°C, where Tcase is the temperature at the bottom of the case. Special consideration must be given to the mounting of the switch to minimize the thermal resistance. The bottom of the case should be thermally attached to the mounting surface to maintain the junction temperature under the absolute maximum rating. Standard CMOS TTL interface, latch-up will occur if logic signal is applied prior to power supply. Handling Procedures Please observe the following precautions to avoid damage: Static Sensitivity Gallium Arsenide Integrated Circuits are sensitive to electrostatic discharge (ESD) and can be damaged by static electricity. Proper ESD control techniques should be used when handling these devices. Truth Table (Switch) Control Inputs Condition of Switch RF Common to each RF Port C1 RF1 RF2 0 On Off 1 Off On 0 = TTL Low; 1 = TTL High Two Tone IP3 Measurements Bias Input Voltage Power for Each Tone (dBm) 3rd IP3 Second Order (dBm) Harmonic Intermod (dBc) Products (dBc) 0, -5V 0, -6V 0, -7V 0, -8V +27 +27 +27 +27 -34 -49 -64 -65 +44 +51 +59 +59 -61 -61 -63 -63 0, -5V 0, -6V 0, -7V 0, -8V +28 +28 +28 +28 -30 -41 -52 -60 +43 +48 +54 +58 -58 -58 -57 -57 0, -5V 0, -6V 0, -7V 0, -8V +29 +29 +29 +29 -28 -34 -44 -52 +43 +46 +51 +55 -54 -54 -54 -54 0, -5V 0, -6V 0, -7V 0, -8V +30 +30 +30 +30 -26 -32 -38 -44 +43 +46 +49 +52 -52 -51 -51 -51 3 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice. SW-110-PIN GaAs SPDT Reflective Switch with TTL/CMOS Control Input, DC-3.0 GHz Rev. V6 Typical Performance Curves Insertion Loss vs. Frequency + 8 5 °C + 2 5 °C Isolation vs. Frequency - 55 °C 80 1.0 Iso latio n (d B ) Insertion Loss (dB) 70 0.8 0.6 0.4 0.2 60 50 40 30 20 10 0 0.0 0.0 0.5 1.0 1.5 2.0 2.5 0.0 3.0 0.5 VSWR vs. Frequency 1.4 1.3 1.2 1.1 1.0 1.0 1.5 2.0 2.5 3.0 C o m p re s s io n ( d B ) 1.0 d B C o mp ressio n 0.5 2.0 2.5 3.0 Compression vs. Control Voltage at 900 MHz 1.5 VSWR 1.5 F requency (GH z) F re que nc y ( G H z) 0.0 1.0 0 .1 d B C o mp ressio n 40 35 30 25 20 15 10 -2.0 -3.0 -4.0 -5.0 -6.0 -7.0 -8.0 F re que nc y ( G H z) C o ntro l Vo ltage (Vo lts) 4 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice. SW-110-PIN GaAs SPDT Reflective Switch with TTL/CMOS Control Input, DC-3.0 GHz Rev. V6 Lead-Free, CR-9 Ceramic Package† † Reference Application Note M538 for lead-free solder reflow recommendations. 5 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice.