The 3CX10,000U7 high-mu triode is intended for use as a cathode driven RF amplifier in the VHF spectrum. It is a very linear device making it ideally suited for TV service in addition to CW and pulsed RF amplifier service. The 3CX10,000U7 makes use of beam forming cathode and control grid geometry to produce high gain, low grid interception, and zero-bias operation capability. The CV2240B and CV2250B 10kW peak sync VHF-TV Broadcast Cavities are available for use with the 3CX10,000U7. Characteristics Plate Dissipation (Max.) Screen Dissipation (Max.) Grid Dissipation (Max.) Frequency for Max. rating (CW) Amplification Factor Filament/Cathode Voltage Current Capacitance Input Output Feedthrough Capacitance Input Output Feedthrough Cooling Base Air Socket Air Chimney Boiler Length Diameter Weight 10,000 Watts N/A 50 Watts 250 MHz 200 Oxide Coated 15.0 Volts 13.5 Amps Grounded Grid 86.5 pf 23.2 pf 0.2 pf --N/A N/A N/A Forced Air Special Coaxial SK-2500 SK-2506 N/A 7.3 in; 185 mm 8.3 in; 211 mm 20 lb; 9.1 kg Maximum RatingsTypical Operation Class of Type of ServicePlate PlatePlateScreenPlate Operation VoltageCurrent Voltage VoltageCurrent (Volts) (Amps) (Volts) (Volts) (Amps) ABCathode Driven Low Band TV Linear RF Amplifier ABCathode Driven High Band TV Linear RF Amplifier CCathode Driven Pulse RF Amplifier Short Pulse 6,500 6,500 13,000 4 4 54 5,000 5,500 7,200 --- --- --- 3.72 3.6 --- Drive Output PowerPower (Watts) (kiloWatts) 400 410 1,580 10.0 10.0 40.0 The values listed above represent specified limits for the product and are subject to change. The data should be used for basic information only. Formal, controlled specifications may be obtained from CPI for use in equipment design. For information on this and other CPI MPP products, visit our website at: www.cpii.com, or contact: CPI Microwave Products Division, Eimac Operation,607 Hansen Way, Palo Alto, CA 94303 telephone : 1(800) 414-8823. fax : (650) 592-9988 | email : [email protected] CPI | 3CX10,000U7 4CW50,000J 3CX10,000U7