Z-BLOCKER® Z-A431PJ31X Alarm Panel DSL Filter Description The Z-A431PJ31X is an Alarm Panel DSL Filter designed to allow to co-existence of DSL service in homes where security systems are installed. The Excelsus Alarm Panel DSL Filter isolates high-frequency DSL signals from low-frequency voice and data communication. Features ● Designed to be used with GE and Moose Panels Z-BLOCKER® Z-A431PJ31X Alarm Panel DSL Filter ● Allows reliable alarm panel reporting and cut-line protection ● Uninterrupted DSL communication during alarm panel line seizure and incident reporting ● RJ31X-RJ38X connections for line seizure and cut-line protection ● Over-voltage protection, protecting alarm panel from power surges ● Easy installation for service provider personnel—less than 15 minutes to insert filter between alarm panel and phone line and perform a system test Block Diagram ● Compliant and Listed with FCC Part 68, CS-03, UL 60950 and CSA 22.2 60950 www.pulseeng.com EX138.A (11/09) Z-BLOCKER® Z-A431PJ31X Alarm Panel DSL Filter Z-BLOCKER Z-A431PJ31X Alarm Panel DSL Filter Specifications ADSL Insertion Loss (32 kHz to 1.1 MHz) 32 kHz to 300 kHz 300 kHz to 1.1 MHz Insertion Loss (1000 Hz) Short loop Long loop Insertion Loss (200 to 3400 Hz) Short loop Long loop Insertion Loss (3400 to 4000 Hz) Short loop Long loop DC Resistance in Ohms At Line port with POTS port shorted, Tip to Ring At POTS port with Line port shorted, Tip to Ring At any port with all other ports open, Tip/Ring to Ground Longitudinal Balance - Two Port 200 to 1000 Hz At 3000 Hz Inter-Modulation Distortion at -9dB level Voice Band ADSL Band Envelope Delay (600 to 3200 Hz) Short loop Long loop Envelope Delay (3200 to 4000 Hz) Short loop Long loop Return Loss ERL SRL-L SRL-H SRL-H (2200 to 3400 Hz single frequency) Capacitance Tip to Ring Tip to Ring (without modem connected) At POTS port, Tip/Ring to Ground DC Loop Current - Meets specifications between 0 and 100 milliamps DC Isolates dial pulses and on-hook/off-hook transitions from the digital subscriber line Length = 60mm, 150mm including cord and plug; Width = 43mm; Height = 22mm US Pat. No. 6,472,992 and 6,404,347 <8dB <7dB <1.0dB <0.75dB +3.5dB to -1.5dB +3.5dB to -1.5dB +10.0dB to -2.0dB +10.0dB to -1.5dB <25Ω <25Ω >5MΩ >58dB >53dB >57dB >60dB <200µs <200µs <200µs <200µs >6dB >5dB >3dB >2dB >20nF <115nF <1nF 12220 World Trade Drive, San Diego, CA 92128 USA Direct: 858 674 8100, Fax: 858-385-8003 www.excelsus-tech.com Specifications subject to change without notice. Excelsus is a registered trade mark of Pulse Engineering, Inc. © 2009 Pulse Engineering, Inc. EX138.A (11/09)