PRELIMINARY 30 TO 1200 MHz SMA CASCADED AMPLIFIER A2P1220 A2P1220 Typical Values High Gain . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Low Noise Figure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . High Output Level . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . High Third Order I.P. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . High Reverse Isolation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . High Performance Thin Film Power Pack SMA Package 31.5 dB 4.3 dB +29.7 dBm +40 dBm 53 dB A2P1220 Power Pack SMA Case (two-stage) SPECIFICATIONS* Parameter Typical Frequency (Min.) 20-1200 MHz Guaranteed 0 to 50 °C -55 to +85 °C 30-1200 MHz 30-1200 MHz Small Signal Gain (Min.) 31.5 dB 29.0 dB 27.5 dB Gain Flatness (Max.) ±0.5 dB ±0.7 dB ±1.0 dB Noise Figure (Max.) 4.3 dB 5.5 dB 6.0 dB 1.8:1 1.6:1 1.9:1 1.8:1 2.1:1 2.0:1 +29.7 dBm +29.0 dBm +28.5† dBm Reverse Isolation 53 dB — — DC Current (Max.) 500 mA 520 mA 530 mA SWR (Max.) Input/Output 30-500 MHz 500-1200 MHz Power Output (Min.) @ 1dB comp. * Measured in a 50-ohm system at +15 Vdc unless otherwise specified. † Indicates minimum temperature at -55/+71 °C. INTERMODULATION PERFORMANCE A2P1220 Typical @ 25 °C Second Order Harmonic Intercept Point. . . . . . . . . . . . . . . Second Order Two Tone Intercept Point . . . . . . . . . . . . . . . Third Order Two Tone Intercept Point . . . . . . . . . . . . . . . . . +59 dBm +53 dBm +40 dBm ABSOLUTE MAXIMUM RATINGS Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -62 to +125 °C Maximum Case Temperature . . . . . . . . . . . . . . . . . . . . . . . . +110 °C Maximum DC Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +17 Volts Maximum Continuous RF Input Power . . . . . . . . . . . . . . . . 0 dBm1 Maximum Short Term Input Power (1 Minute Max.) . . . . . . . 50 Milliwatts Maximum Peak Power (3 µsec Max.) . . . . . . . . . . . . . . . . . . 0.5 Watt Burn-in Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +85 °C Thermal Resistance2 (θjc) . . . . . . . . . . . . . . . . . . . . . . . . . . +10 °C/Watt Junction Temperature Rise Above Case (Tjc) . . . . . . . . . . . +57.8 °C 1 If no load on output; decrease input power (no damage) by 10 dBm. 2 Thermal resistance is based on total power dissipation. DIMENSIONS ARE IN INCHES [MILLIMETERS] 650-691-9800 • Fax: 650-962-6845 • Updates: www.teledynemicrowave.com • [email protected]